per unit width 
Application of the maximum width of the grid and flow rate per unit width of the river results in the number of flow zones in the lateral direction of the river.


The peel strength is the first peak force per unit width of bondline required to produce progressive separation, and the peel energy is the amount of energy per unit bonding area associated with a crack opening.


Estimates of crossreef mass transport per unit width ranged from 0.058 to 0.032?m2s?1.


The intrinsic force per unit width, S, in thin films of Ag, Al, ZnS and LiF prepared by vacuum evaporation at pressures of less than 5×105 Torr, has been investigated using a sensitive bending plate technique with capacitative detection.


Measurement of contact angles for the flowing beads and for sessile drops led to the conclusion that the surface tension forces per unit width were similar for the drops on the two surfaces.


However, the gravitational force per unit width was higher for the drop on the refractory surface.


Measurement of contact angles for the flowing beads and for sessile drops led to the conclusion that the surface tension forces per unit width were similar for the drops on the two surfaces.


However, the gravitational force per unit width was higher for the drop on the refractory surface.


By analogy with the case of planeparallel flow an equation is derived for the volume flowrate per unit width of a plane convergent flow.


Channel current per unit width vs drain voltage with the gate voltage as the parameter.


Clearly, there is a rather strict empirical correspondence between volume per unit width and runout.


From this strain state, the force per unit width in the 1direction at section a, can be calculated.


Finally, the volume flux per unit width is given by qp = Q0/w, where w is the width of the channel.


In E T Is the rate of sediment transport per unit width.


In addition, the volume per unit width is welldefined for the Storegga debris flows where the transverse flow of material has been small.


Measured force per unit width vs strain response from tension test Figure 8.


Measured moment per unit width vs curvature A plot of bending moment per unit width vs longitudinal curvature is shown in figure 16.


The units of Dfd are mass detached/deposited per unit width per unit flow length per time.


There is considerable discrepancy in the stiffness and strength per unit width between the dry and laminate properties given by the manufacturer.


The axial load P may be assumed to be uniformly distributed with intensity P/4b per unit width of flange.

