助手标题
全文文献 工具书 数字 学术定义 翻译助手 学术趋势 更多
查询帮助
意见反馈
共[40]条 当前为第1条到20条
 

相关语句
未完全匹配句对
    A Study of Testing Method for Output Torsional Power and Efficiency from the Gear box of LG 4 Heater with Rolling Fire Bars Group
    LG4型滚动炉排变速箱输出扭矩功率和效率测试方法研究
    The Relation of Pre-pressure and Output-torque of Longitudinal and Torsional Ultrasonic Motor
    纵扭复合型超声电机预压力和输出扭矩的关系
    Then two sets instrument,SEC Shaft HorsePower meter and WDC 1605A Current Ship Power Measurement System,are analyzed,emphasizing on basic principle,performance,installation and operation on-board.
    同时,结合具体的测量仪器设备——日本SHOYO公司的“SEC船舶主机功率仪”和美国WDC无线数据传输公司的“1605A通用海上试验功率测试系统”,详细介绍应用扭矩仪实船测量柴油机的输出扭矩和有效功率,包括基本测量原理、设备的技术性能、应用注意事项以及实际安装与操作等内容。
    Carrying on the test underthe high-pressure pump function of the model QL-270 .Through testing, at 0.8MPa, output torsion meets cleaning requirement basically and at about 500r/min of rotational speed, the total efficiency reaches the most effective about 22.67%.
    经测试,进水压力在0.8MPa时,输出扭矩基本满足清洗要求,当转速为500r/min左右时,水动马达总效率最高,在22.67%左右。
    on the other side, it can improve the magnetic circuit efficiency of the torque motor because of the magnetic fluid’s larger magnetic permeability.
    另一方面由于力矩马达气隙中磁导率的提高,使气隙中的磁通量增大,力矩马达的磁路效率和输出扭矩将增大,因此可以提高力矩马达的固有频率和伺服阀的响应速度。
    Load (output torque of the rotor) is another factor influencing the flow-speed characteristic. Tests show that the torque of the screwdrill under the optimum working condition is 50~70 percent of the braking torque.
    负载(转子输出扭矩)是影响流量—转速特性的另一重要因素,试验表明,螺杆钻具在最佳工况时的扭矩是制动扭矩的50%~70%。 按螺杆钻具在不同流量下的扭矩—转速特性,为适应牙轮钻头钻井工况的要求,设计马达时应尽量降低转速,提高输出扭矩
    The experiments show that the maximum torque output stops increasing and gets a maximum value when the excitation volt for torsional vibration reaches 300 V. The motor's maximum torque output is 1?
    在实验中发现 :电机的最大输出扭矩并不总是随扭振激振电压Vt 的增大而增大 ,当扭振子输入电压达到 30 0V以后 ,电机的最大输出扭矩不再增加 ,而是有一最大值 ,当扭振子输入电压达到 35 0V时 ,电机的最大输出扭矩达 1N·m .
    After improvement, the power is taken off from the output shaft of the clutch, therefore 90% of the power of the motor can be taken off, and the torque output of the drumworks is increased from 660kN·m to 1010kN·m.
    改进后的取力器是由离合器输出轴上取力 ,取力功率从原为主机功率的 6 0 %增至 90 %,使通井机滚筒输出扭矩从 6 6 0kN·m增至 10 10kN·m ,提高了设备的载荷能力。
    the trial indicate it can add speed for 8 times and deliver the ideal torsion and the slip rate is within 2%.
    试验结果表明:增速刀柄能使原机床主轴增速8倍,输出扭矩能达到理想状态,且在恶劣的条件下滑动率不超过2%.
    Do experiment to the motor prototype, and the test results are in agreement with the theoretical analysis results essentially. To the prototype the rotary velocity is 3308.6microradian/sec, the output torque is 0.294N·m, and the minimum stepping angle (rotary resolution) is 0.206 microradian.
    测试结果与理论分析结果基本相符,所开发样机的旋转速度可达3308.6μrad/s、输出扭矩为0.294N·m、单步最小转角(旋转分辨率)为 0.206μrad。
    The results showed that the actuator prototype works stably and reliably,its rotating speed can reach 2990.6 μrad/s,the torque output is 0.147 N·m,the minimum stepping angle(angular resolution) is less than 0.32 μrad,and the rotor can rotate around the axis for 360° continuously.
    测试结果表明,所开发的驱动器样机旋转速度可达2990.6μrad/s、输出扭矩0.147 N. m、最小旋转步距(旋转分辨率)小于0.32μrad,运动行程为连续360°,驱动器性能稳定可靠。
    Study and Optimization of Meshing Coefficients of Low speed Large output Gearing
    低速大输出扭矩齿轮传动啮合参数的优化设计初探
    The relationships between the fluctuation rate of the output torque of the involute gearing and both the sliding friction coefficient between teeth and tooth numbers
    渐开线齿轮机构输出扭矩波动率与齿间滑动摩擦系数及齿数之关系
    On the fluctuation of the output torque of gear drive in the machine tool under the hypothesis that only one pair of teeth contacts
    评单齿啮合假设下机床齿轮传动输出扭矩之波动
    Calculation of the fluctuation ratio of the output torque of the involute gearing
    渐开线齿轮机构输出扭矩波动率的计算
    Driving Torque Calculation of the Power Unit of Mobile Ground Anchor Vehicle
    地锚车动力头输出扭矩计算
    The relationship of pressure, rudder angle, and torque
    转舵机构舵角、压力和输出扭矩的关系
    The discussion about the marking patterns of the valve actuator's output torque in the nameplate
    阀门手动装置输出扭矩在铭牌上标定形式的探讨
    Verifying the effect of the friction between teeth on the output torque fluctuation of a spur gearing through the use of experimental method
    齿间摩擦引起齿轮输出扭矩波动的实验验证
    Contrast Study of Paramlters Which Affect the out Torque of the Vortex Brake Device
    几个影响电涡流缓速器输出扭矩的参数对比研究
 

首页上一页12下一页尾页 

 
CNKI主页设CNKI翻译助手为主页 | 收藏CNKI翻译助手 | 广告服务 | 英文学术搜索
版权图标  2008 CNKI-中国知网
京ICP证040431号 互联网出版许可证 新出网证(京)字008号
北京市公安局海淀分局 备案号:110 1081725
版权图标 2008中国知网(cnki) 中国学术期刊(光盘版)电子杂志社