3. The author proceeds theoretical calculation of positive evolution for layer model, and introduced the multi-wavelet transforms and complex analysis technology into the model, showed the effectiveness of the algorithm.
In the energy levels' expression of the bound states,the quantity related to the magnetic flux in the A B potential has been included, which indicates that in the layer model there are the effects of the quantum border and measurement when the thickness of the metal layer is very thin .
In addition, wave field simulation using Maslov asymptotic theory and symplectic algorithm for linear layer model is performed. The comparison of the numerical solution with the analytic solution is carried out.
From the approximate reduction to the inverse objective function of two dimensional layer model, the two dimensional inversion along the total profile was reduced to the one dimensional inversion of each site along the profile, and a simple easy scheme of the parametric inversion for two dimensional layer model was made.
Based on an idealization of cancellous bone as a periodic array of bone\|marrow layers that is stratified model,Schoenberg's theory was applied to analysis propagation properties of two compressional modes(fast and slow waves).
Finally, the anisotropy of horizontal well strata resistivity is studied by using three-layer horizontal stratified model, and the horizontal resistivity and oil saturation of formation are calculated accurately.
In this paper, the recent advances of cancellous bone models in ultrasonic osteoporosis diagnosis are reviewed, which consist of the bar model, the fluid-saturated porous medium model (Biot's theory) and the stratified model (Schoenberg's theory). After the performances of these models are analyzed, their limitations are pointed out and some suggestions are propose for the further research.
AVO modeling for P and S-waves (including P-P, P-SV, SV-SV, SV-P and S-SH waves) of two-dimensional undulate layered model was made by using fast ray-tracing algorithm as well as formulas for calculating reflection and transmission coefficients of plane wave traveling at reflection interface.
United with load transfer method,Chow constituted a layered model,which could be used to calculate settlement of pile foundation in arbitrary layered soil condition,and the analysis was extended to nonlinear deformation.
Heferosis degenerated three-dimensional bending shell element suited to the laminated thin and thick plates and shells are used to analyze etastic and plastic of metal matrix composite laminated plates and shells with Hill yield criterion and layered model method.
(2) Based on assembly information model, the idea of hierarchical assembly was applied in the generation of assembly sequence, by which the efficiency and practicality of assembly sequence planning were increased.
Firstly,by analytical calculation,the authors find that the influence of water amount in surface layer on observed apparent resistivity posses two characteristics: (1) no mater the deep layers are resistive or conductive relative to the surface layer,the influence of resistivity increase in surface layer on apparent resistivity is very small;
A model of rainfall interception by an inhomogeneous forest canopy is classified as a multi-layer model, which is different from previous models (models where all the parameters represent the whole canopy).
Two-Layer Model of Colloidal Gold Bioconjugates and Its Application to the Optimization of Nanosensors
Based on the two-layer model of the formation of surface charge developed earlier, it is shown that the energy of hydrophobic adsorption is smaller than that of electrostatic adsorption and is equal to 17.7kT.
A two-layer model of the flow of an ideal gas over a blunt body was used in [2, 3] for the analysis of radiative heat transfer.
We consider the problem of a hypersonic viscous flow of a nonreactive mixture of ideal gases around smooth thick bodies in the framework of a two-layer model of a thin shock layer for moderately small Reynolds numbers.
In order to explain this effect, a two-layered model of potential distribution is suggested.
A multistage mechanism is suggested for particle exchange in the preparation of multicomponent mixtures, and the layered model of mixing is adapted to the case of particles differing in size and/or density.
Determination of the excess density in a horizontal layered model
An analysis of surface acoustic wave propagation in a plate of functionally graded materials with a layered model
In this paper, a generalized layered model for radiation transfer in canopy with high vertical resolution is developed.