助手标题  
全文文献 工具书 数字 学术定义 翻译助手 学术趋势 更多
查询帮助
意见反馈
   作用载荷 的翻译结果: 查询用时:0.021秒
图标索引 在分类学科中查询
所有学科
更多类别查询

图标索引 历史查询
 

作用载荷
相关语句
  “作用载荷”译为未确定词的双语例句
     Some bases of geotechnical engineering limit state design, such as concepts of limit state, geotechnical parameter,category and risk and partial safety factors,are introduced in this paper.
     论述了岩土工程极限状态设计的基本思想,包括极限状态的概念、土工参数设计值的确定过程和方法、构造物的重要度和场地地基复杂程度的划分、岩土工程类别、作用载荷组合、分项安全系数和极限状态设计等;
短句来源
     According to its structure and load characteristics,a derrick is considered as a freely supported beam with uniform dis tributed mass and constant rigidity along the length, and the relation between the structural frequency and load on the derrick is investigated by the vibration theory.
     根据结构形式和受力特征,将井架折算成一根沿长度上质量均匀分布、刚度恒定的简支渠,用振动理论研究井架的结构频率与作用载荷的关系。
短句来源
     The Analysis and Calculation of Load Which Charges Acted on Shell of Ceramic Ball Mill
     陶瓷球磨机研磨体对筒体作用载荷分析与计算
短句来源
     The safety bearing capacity test shows that, the upper portion of the derrick is an area loaded heavily, and the measured stress on the derrick stand is linear to the hook load.
     由井架安全承载试验结果可知:井架上段为受力较大部位; 井架立柱测试应力与大钩作用载荷呈线性关系。
短句来源
     The method of weighted residuals and the method of moment in probability have been integrated into a new method of dynamic analysis for the stochastic structures.
     基于矩法和加权残值法两者的特点,提出随机结构动力响应分析的一种新方法。 该法是将加权残值法和概率论中的矩法相结合,对物理参数、几何参数和作用载荷具有随机性的结构进行动力响应数字特征分析。
短句来源
更多       
  相似匹配句对
     Calculation of Shear Forces under Eccentric Loads
     承受偏心载荷作用的剪切计算
短句来源
     STRESSES IN RIGID FRAMES DUE TO DYNAMIC LOAD
     在动载荷作用下的刚架计算
短句来源
     Affect of Role Intrusion Detection System
     入侵检测系统的作用
短句来源
     The Function of Capital
     资本金的作用
短句来源
查询“作用载荷”译词为用户自定义的双语例句

    我想查看译文中含有:的双语例句
例句
为了更好的帮助您理解掌握查询词或其译词在地道英语中的实际用法,我们为您准备了出自英文原文的大量英语例句,供您参考。
  useful load
Because cost is so important, BAT Co felt that the cost reduction was more important than the extra useful load capability.
      
Caution is needed, however, in that any load break may prove expensive and the use of containers lowers the useful load.
      
It was found that small changes in the useful load and SFC made large changes in the acquisition cost.
      
It is found that the useful load fraction increase with increasing displacement.
      
Incorporated into that useful load must be useful values for crew, cargo and fuel weights.
      
更多          
  used load
Exercise I consisted of seven sets of seven vertical leg lifts at 85% of the subject's Seven Repetition Maximum (SRM) and, 5 days later, seven sets of 21 vertical leg lifts with one-third of the previously used load (Exercise II).
      
Assign the ACN of the critical airplane at commonly used load percentage as the PCN.
      
The used load was 0.750 kG and the rate of increase of the temperature was 1 K/min.
      


The paper presents friction and wear behavior of a polymer solid lubricating film ( CKD-31 dry film), with the matrix of thermal oxidized polyethylene, the effects of film thickness, sliding speed, operating period and load on friction and wear have been investigated with a MHK-500 ring-block tester.A remarkable improvement on the shooting accuracy of the bullet for the spot gun of 5.6mm has been resulted from the application of this film as a surface coating of the bullet.

本文报导了以热氧化聚乙烯为基础的高分子固体润滑膜(CKD-31干膜)的摩擦磨损性能。用MHK-500型环块磨损试验机考察了这种膜的厚度、滑动速度、摩擦时间、作用载荷对其摩擦磨损性能的影响。介绍了这种膜用作国产5.6mm运动步枪弹表面涂层可明显地提高该弹的射击精度。

This paper presents several geotechnical problems on improvement of cohesive soils by the vibroflotation methods, including the change of the shear strength of cohesive soils caused by vibroflotation, the types of soil suitable for vibroflotation, the special capability of short stone column, the effects of vibration during construction,the loading test and determination of bearing capacity of the composite foundation consisting of clay and stone column.Some case records and appropriate analyses are given.

本文着重讨论了振冲法加固软粘土地基时有关的几个土工问题,其中包括振冲法对地基土抗剪强度的影响、适用范围、短而密碎石桩的特殊作用、载荷试验、复合地基的计算等问题。文中通过对一些工程实例的分析,对上述问题提出了一些初浅的认识,供读者参考。

In this paper, the three dimensional finite element model analyzed is an integrate gear pair so that it isn't necessary to assume boundary conditions on cut surfaces and to estimate applied loads on teeth prior to stress analyses of gears. The surface of contact between meshed teeth is replaced by the line of contact and hence the nonlinear contact problem is simplified as a linear contact problem, however in order to reduce amount of data-preparing and calculating time. Results for load distribution along tooth...

In this paper, the three dimensional finite element model analyzed is an integrate gear pair so that it isn't necessary to assume boundary conditions on cut surfaces and to estimate applied loads on teeth prior to stress analyses of gears. The surface of contact between meshed teeth is replaced by the line of contact and hence the nonlinear contact problem is simplified as a linear contact problem, however in order to reduce amount of data-preparing and calculating time. Results for load distribution along tooth length direction, load sharing among teeth, and displacements and stresses in any region of an integrate gear pair can be obtained using the technique described here.

本文分析的三维有限元模型是一完整的齿轮副,不必假设切开表面上的力与位移边界条件,也不必在进行齿轮的应力分析前预估齿牙上作用的载荷。为了减少数据准备及计算工作量,用接触线代替了啮合齿间的接触面,把非线性接触问题简化为线性接触问题。利用这里所介绍的办法,可以得到齿向载荷分布结果、齿间载荷分配结果、以及完整齿轮副任一区域内的位移及应力结果。

 
<< 更多相关文摘    
图标索引 相关查询

 


 
CNKI小工具
在英文学术搜索中查有关作用载荷的内容
在知识搜索中查有关作用载荷的内容
在数字搜索中查有关作用载荷的内容
在概念知识元中查有关作用载荷的内容
在学术趋势中查有关作用载荷的内容
 
 

CNKI主页设CNKI翻译助手为主页 | 收藏CNKI翻译助手 | 广告服务 | 英文学术搜索
版权图标  2008 CNKI-中国知网
京ICP证040431号 互联网出版许可证 新出网证(京)字008号
北京市公安局海淀分局 备案号:110 1081725
版权图标 2008中国知网(cnki) 中国学术期刊(光盘版)电子杂志社