Through analysis the process’s characteristic, the W2H model has been proposed as s main element to description process. We point out in this paper that the main problem need to be solved of Product design and process plan process is“Who”does“what”and“How”to do.
Aiming at the footwear design and technique specialty in higher vocational education, this article discusses the key issues to be well solved in order to carry out the reform of practice teaching, and proposes that personality standard be the guide line in establishing the practice teaching system, and we should properly handle the relationships between course practice, specialty practice and social practice.
Capitalizing on the conceptual integration of the design and process activities, an Abstract Design Environment is used for the design of the basically process oriented material flow tool.
The process technology is described, discussing the influence of bioreactor design and process parameters required to obtain high nematode yields.
In product design, concept selection for determining product configuration is a critical step because all subsequent detailed design and process design is based on decisions made at this stage.
The two main phases in a product cycle where dimensioning and tolerancing techniques are extensively employed are in the areas of product design and process planning.
Tolerance and dimension assignment in both product design and process planning has an equally important role in keeping the production cost down and, hence, requires equal attention as far as research into these areas are concerned.
Design and technology of vertical-cavity surface-emitting lasers with nonconducting epitaxial mirrors
Design and technology problems in the fabrication of vertical-cavity surface-emitting lasers (VCSELs) equipped with nonconducting distributed Bragg reflectors (DBRs) and fabricated using molecular-beam epitaxy are considered.
Effect of the design and technology factors on electrical characteristics of the Au/Ti-n-GaAs Schottky diodes
Design and technology of monolithic GaAs p-i-n diode limiters for the millimeter wavelength range
A design and technology are proposed for the mass production of butt low-power induction motors that enable one to approximately halve the material consumption and labor input
Inferior softness of pattern bath tath towel is usually due to unsuitable technological design and the residue size on the towel. To improve the softness of pattern bath towel must better both the technological design for producing grey towel, and its after-treatment such as, desizing measure, bleaching, printing, dyeing, and baking process. The article discusses the above items in detail.
Superconducting cosθ dipole magnet is widely used for construction of highenergy superconducting accelerator as basic element. Success of acceleratordepends on the property of the magnets. The results of the investigation andanalysis of the magnet are presented. A method to determine conductor positionquantitatively in the magnet is given. Thus the multipoles inside the dipole magnetcould be efficiently controlled and an ideal design of the magnet is expected.