助手标题  
全文文献 工具书 数字 学术定义 翻译助手 学术趋势 更多
查询帮助
意见反馈
   放热峰温度 的翻译结果: 查询用时:0.185秒
图标索引 在分类学科中查询
所有学科
有机化工
更多类别查询

图标索引 历史查询
 

放热峰温度
相关语句
  exothermic peak temperature
     The results show that Li_ 005CoO_2 reaches to exothermic peak at 2718℃ with a total heat generation of 15755J/g. In general, the heat generation and main exothermic peak temperature of Li_xCoO_2 are increasing with x decreasing.
     结果表明,LixCoO2的放热量和主放热峰温度随x值减小而增加,Li0.05CoO2在271.8℃达到放热峰,总放热量高达1575.5Jg。
短句来源
     CHP is found to be a product of paste form if it contains over 0.3% water,with increasing water content, the exothermic peak temperature decreases quickly and the time of solidification is about 0.1%, the exothermic peak temperature reaches a highest value,the time of solidification is shortened; and a CHP product of a transparent colorless liquid form may be obtained.
     初步弄清了CHP质量与其水份含量的关系:水份含量在0.3%以上时,CHP成糊状,随着水份含量的增加,放热峰温度迅速下降,凝皎固化时间延长:水份含量在0.1%左右时,CHP基本上为无色透明液体,放热峰温度则能达到最高值,凝胶固化时间缩短。
短句来源
  “放热峰温度”译为未确定词的双语例句
     The findings show that there is only one peak for heat releasing on DSC curve of Sb-Se system with the temperature of 220°C.
     结果表明,Sb-Se系合金的DSC曲线只有一个放热峰,温度为220℃。
短句来源
     24%,the temperature of DTA exothermic peak is 378.7 C withexothermic peak temperature extrapolated is 367.7t.
     差热分析放热峰温度为378.7℃,放热峰外推温度为367.7℃。
短句来源
     In the meanwhile, Nanometer Ni, Cu, Ni-B and Al had catalytic characteristics on the propellant samples and could make the high temperature decomposition decrease 14.7℃, 33.6℃, 23.3℃ and 31.6℃ respectively.
     纳米镍、铜、Ni-B合金和铝粉使推进剂样品的高温放热峰温度分别降低了14.7℃、33.6℃、23.3℃和31.6℃,其中纳米铜粉的催化作用最强。
短句来源
     the temperature of DTA exothermal peak has been promotedto 391 .9C with exothermal peak temperature extrapolated of 378.TC,the temperatureof DTA endothermic peak is 486.5 C with endothermic peak temperature extrapolatedis 475.8C.
     差热分析DTA放热峰温度提高到391.9℃,放热峰外推温度提高到了378.7℃,而吸热峰温度为486.5℃,吸热外推温度为475.8℃。
短句来源
     At first exothermal peak temperature of 820℃,it is found that a surface-induced crystallization is dominated and anorthite(CaAl2Si2O8)as major phase and wollastonite(CaSiO3)as minor phase are precipitated.
     在第一放热峰温度(820℃)析晶时,玻璃样品为表面析晶,析出晶体为钙长石(CaAl2Si2O8)和硅灰石(CaSiO3)。
短句来源
更多       
  相似匹配句对
     Peak temperature is 115℃, hardnessincreased to 70 in 40-50 min.
     放热曲线测得最高放热为115℃。
短句来源
     The max peaks at 320℃ and 440℃ in DTA are observed by exothermic decomposed reaction, respectively.
     在320℃、440℃分别有2个放热.
短句来源
     In addition,there also exist C=C vibra tion peak as the result of the de-hydrogen chloride reaction.
     C振动
短句来源
     JUNFENG COMPANY(pooled by CPGSC and GEO SPACE)
     俊公司
短句来源
     24%,the temperature of DTA exothermic peak is 378.7 C withexothermic peak temperature extrapolated is 367.7t.
     差热分析放热温度为378.7℃,放热外推温度为367.7℃。
短句来源
查询“放热峰温度”译词为用户自定义的双语例句

    我想查看译文中含有:的双语例句
例句
为了更好的帮助您理解掌握查询词或其译词在地道英语中的实际用法,我们为您准备了出自英文原文的大量英语例句,供您参考。
  exothermic peak temperature
A decrease in the melting point and exothermic peak temperature was observed with increasing mass percent of reactive diluent.
      
According to results of thermal analysis, the exothermic peak temperature of the glass showed a decrease with increase of nucleation temperature to nucleation time of 6 h.
      
The dependence of reciprocal value of the exothermic peak temperature on the nucleation temperature indicated that an introduction of MgO might accelerate the nucleation of the base glass and thus result in rough surface topography of glass-ceramics.
      


For a series of NH_4~+ ion exchanged NaY (0~98%), hydrothermal treatment at different temperatures (550-800%]) have been conducted. The hydrothermally treated samples (USY) and their further NH_4~+ (or NH_4~+ and H~+) ion exchanged forms (USHY) have been characterized by IR, X-Ray and DTA methods.

在铵交换度为27~98%、超稳化处理温度为550~800℃、有或无后铵交换条件下,用NaY分子筛制备了样品。从分子筛骨架振动及羟基伸缩振动的红外光谱特征谱带、吡啶为探针分子的不同脱附温度下1550和1450cm~(-1)附近红外光谱谱带、X射线衍射法测得的晶胞常数α_0、DTA分析法测得的沸石结构破坏放热峰温度,对样品进行了表征,研究了USY制备中脱铝、稳定化和酸性变化的规律,对稳定化过程的有关问题进行了讨论。

CHP is found to be a product of paste form if it contains over 0.3% water,with increasing water content, the exothermic peak temperature decreases quickly and the time of solidification is about 0.1%, the exothermic peak temperature reaches a highest value,the time of solidification is shortened; and a CHP product of a transparent colorless liquid form may be obtained.

初步弄清了CHP质量与其水份含量的关系:水份含量在0.3%以上时,CHP成糊状,随着水份含量的增加,放热峰温度迅速下降,凝皎固化时间延长:水份含量在0.1%左右时,CHP基本上为无色透明液体,放热峰温度则能达到最高值,凝胶固化时间缩短。

A study was made on the microstructure of ultrafine diamond powders synthesized by two different explosive methods including particle size distribution, lattice parameter, brain size and morphology. The Debye characcteristic temperature was also calculated fain X-ray diffraction intensities. DTA indicates that two kinds of diamond powders have the same initial oxidation temperature, but their exotermic peaks of diamond and graphite impurity have a little difference of 35℃ and 50℃ respectively.

本文分析研究了两种冲击法合成的超细金刚石粉的显微结构特征,包括粒度分布、点阵常数、晶粒度和形貌,并根据X射线衍射强度计算了纳米金刚石粉的德拜特征温度。差热分析(DTA)表明两种超细金刚石粉在空气中的起始氧化温度相同,但由于粉末粒径的差异,金刚石及杂质石墨的放热峰温度分别相差35℃和50℃。

 
<< 更多相关文摘    
图标索引 相关查询

 


 
CNKI小工具
在英文学术搜索中查有关放热峰温度的内容
在知识搜索中查有关放热峰温度的内容
在数字搜索中查有关放热峰温度的内容
在概念知识元中查有关放热峰温度的内容
在学术趋势中查有关放热峰温度的内容
 
 

CNKI主页设CNKI翻译助手为主页 | 收藏CNKI翻译助手 | 广告服务 | 英文学术搜索
版权图标  2008 CNKI-中国知网
京ICP证040431号 互联网出版许可证 新出网证(京)字008号
北京市公安局海淀分局 备案号:110 1081725
版权图标 2008中国知网(cnki) 中国学术期刊(光盘版)电子杂志社