The chip has been realized in 0.35μm 2P4M CMOS technology. The amplifier features an open-loop gain of 83.9dB and a GBW of 10MHz. The measured typical residual input offset is less than 93.7μV,and the equivalent input low frequency noise is 19.6nV/Hz at a chopping frequency of 100kHz and supply voltage of 3.3V.
The amplifier provides a gain of 16 dB and a noise figure below(0.4) dB in the frequency range of 880~915 MHz. Test results show that the circuit has met the specifications for practical applications.
The results of the stimulation, based on the Spectre software with 0.35μm Bi CMOS technology module, showed that the amplifier had a open loop plus of more than 60dB, a unit plus bandwidth of more than 2.1 GHz and an output amplitude of 1.5V.
利用0.35um Bi CMOS工艺条件下Spectre仿真得到运算放大器的开环增益要大于60dB,单位增益带宽要大于 2.1GMz,输出摆幅能达到1.5V。
And we simulated the transmission model constructed with Erbium-doped fiber amplifier (EDFA) as the solo amplifier and the chirped fiber Bragg grating (CFBG) as the solo dispersion compensator used in the system.
A new electron beam (EB) control system was developed in a general vacuum EB machine by equipping it with an industrial control computer, programmable logic control (PLC), deflection coil, data acquisition card, power amplifier, etc.
This problem is of interest in connection with the possibility of application to the design of jet amplifier-one of the elements of fluidic automatic control (pneumonies) [1, 2].