助手标题  
全文文献 工具书 数字 学术定义 翻译助手 学术趋势 更多
查询帮助
意见反馈
   烘烤时间 的翻译结果: 查询用时:1.336秒
图标索引 在分类学科中查询
所有学科
冶金工业
无线电电子学
轻工业手工业
更多类别查询

图标索引 历史查询
 

烘烤时间     
相关语句
  baking time
     With infrared bake, feat baking temperature is 280℃ and feat baking time is 8 mins.
     远红外烘烤适宜的烘烤温度为280℃,烘烤时间为8min;
短句来源
     the best of them is the Zinc powder 300g/l, Aluminum powder 40g/l, CrO_3 50g/l, additive in coat 8g/l, baking temperature 300°C, baking time 20 min.
     L~(-1),CrO_350 g. L~(-1),成膜助剂8克/升,烘烤温度300℃,烘烤时间20分钟。
短句来源
     influential tendencies of baking time on BH value and predeformation amount are just the same,but with smaller change of BH value.
     烘烤时间对BH值的影响与预变形量的影响趋势相同,但BH直变化范围很小。
短句来源
     The effects of baking temperature,baking time and prestrain on the bake hardenability and dent resistance of isotropic sheet steel and BH sheet steel produced by batch annealing were studied.
     研究了烘烤温度、烘烤时间和预拉伸应变量对罩式炉退火工艺生产的各向同性钢的烘烤硬化性的影响,并与力学性能相当的冷轧烘烤硬化钢进行了对比。
短句来源
     Concerning the rare study on physico-mechanical properties of phosphogypsum,the relationship of water content with baking temperature and baking time,as well as the relationship of solubility with temperature is investigated by lots of experiments.
     通过大量的室内试验,研究了磷石膏的烘烤温度与含水率的关系、烘烤时间与含水率关系、溶解度与温度关系。
短句来源
更多       
  heating time
     The peeling strength of CR/MMA graft adhesive is dependent upon the concentration of curing agent, heating time, curing time and adhe-sive thickness.
     本文研究了固化剂用量、烘烤时间、固化时间以及胶层厚度对CR/MMA接板氯丁胶粘剂剥离强度的影响.
短句来源
  drying time
     inorganic salt Ca(NO_3)_2; drying temperature 85 ℃; pre-drying time 60s and drying time 60s.
     在85℃下设定预烘烤时间烘烤时间分别为60秒,以慢速定量滤纸为固体基质,外加无机盐Ca(NO_3)_2,Pd(Ⅱ)TMPyP能产生强的室温磷光信号。
短句来源
     It is shown through tests that the lining temperature of dried ladle reaches to 1200℃,and bottom temperature 1350℃,drying time of cold ladle is 4 hours, the drying time of hot ladle with 400~600℃ 2 hours.
     试验表明,烘烤的钢包内衬温度达到了1200℃,罐底最高温度可达1350℃,冷罐烘烤时间为4h,400~800℃热罐烘烤时间为2h。
短句来源
  time during curing
     The results showed that with the lengthening of time during curing the activity ofsuperoxide dismutase(SOD)and peroxidase(POD)in tobacco leaves decreased,while thecontent of malondialdehyde(MDA),a product of membrane lipid peroxidation,increased.
     结果表明,随烘烤时间延长,叶内超氧物歧化酶(SOD)和过氧化物酶(POD)活性下降,丙二醛(MDA)含量增加。
短句来源
     At the same time,with the lengthening of time during curing,the amount of starch,protein,insoluble nitrogen,nicotine in tobacco leaves dereased,while that of rpducing sug-artotal amount of amino-acid,soluhle nitrogen increased.
     同时,随着烘烤时间的延长,烟叶内淀粉、蛋白质、不溶性氮和烟碱含量下降,还原糖、总氨基酸和可溶性氮含量上升。
短句来源

 

查询“烘烤时间”译词为其他词的双语例句

     

    查询“烘烤时间”译词为用户自定义的双语例句

        我想查看译文中含有:的双语例句
    例句
    为了更好的帮助您理解掌握查询词或其译词在地道英语中的实际用法,我们为您准备了出自英文原文的大量英语例句,供您参考。
      baking time
    Other parameters such as purge flow, sample volume, desorption time and temperature and baking time and temperature were kept constant.
          
    Resistant starch formation during baking -effect of baking time and temperature and variations in the recipe
          
    The independent variables were water content, emulsifier content baking time, oven power, shortening content and starch type.
          
    Independent variables were the baking time (4, 4.5, 5, 5.5, and 6?min), the power of the microwaves (20, 30, 40, 50, and 60%), and the power of the upper and lower halogen lamps (40, 50, 60, 70, and 80%).
          
    Baking time, upper halogen lamp power, and microwave power were found to be significant in affecting most of the quality parameters.
          
    更多          
      heating time
    The optimum condition for PCDD/Fs decomposition in fly ash was a heating time of 60 min at 400 °C under nitrogen atmosphere.
          
    The results of this study were obtained for a comparatively short heating time for a fixed ratio of heat fluxes to the side and free surfaces.
          
    The heating time is approximately 2.25 s, with the density of heating radiation flux of approximately 1200 W/cm2 and 1600 W/cm2.
          
    The heating time is approximately 2.25 s, with the density of heating radiation flux of approximately 1600 W/cm2.
          
    The optimal reaction conditions such as reagent concentration, heating time, and stability of the reaction product were determined.
          
    更多          
      drying time
    The dependences of the spectral halfwidth of intensity fluctuations on the drying time demonstrate the characteristic features of drying front evolution, which proved to be similar to those found in the modeling of irreversible growth front.
          
    At a specified drying temperature, drying time was highly dependent upon the packed waste thickness, having an exponent relation with the thickness.
          
    The drying time to the equilibrium is almost the same under different humidity conditions, but low equilibrium moisture content can be acquired under low humidity.
          
    The results, showed that the moisture content decreased and the electrostatic charge increased with drying time.
          
    For cotton fabrics, the electrostatic charge was under 1000 V even for the maximum drying time due to the intrinsic high moisture regain of cotton.
          
    更多          


    In order to meet the demand of the quick development of ladle refining and continuous casting and the high quality drying of ladle a horizontal ladle drying system has been developed. The structure and cold and hot tests of the ladle drying system have been introduced in this paper.It is shown through tests that the lining temperature of dried ladle reaches to 1200℃,and bottom temperature 1350℃,drying time of cold ladle is 4 hours, the drying time of hot ladle with 400~600℃ 2 hours.

    卧式钢包烘烤器的研制是在炉外精炼及连铸技术得到迅速发展,而对钢包加热质量提出了更高的要求下开展起来的。本文介绍了该烘烤器的结构和冷、热罐的烘烤试验情况。试验表明,烘烤的钢包内衬温度达到了1200℃,罐底最高温度可达1350℃,冷罐烘烤时间为4h,400~800℃热罐烘烤时间为2h。

    A fast curing acrylic baking paint under low temperature has been developed for reducing the baking temperature and time, as well as conforming to the current product specifications. By using the experimental design approach, the best technological parameters have been specified. The specifications and testing results have been listed.

    为了降低热固型丙烯酸烘漆的烘烤温度和烘烤时间,且保持现行产品的技术要求,研制了低温快干丙烯酸烘漆。采用正交优选法,选择了最佳工艺条件。列举了该烘漆的技术要求及性能检验结果。

    The effects of ratio of silver powder to the resin, the capacity of the salvent, dry temperature and time of the paste on bulk resistance ratio and shearing stress of paste were discussed. The bright silver-white paste with bulk resistance ratio of 10~(-4)~10~(-5)Ω·cm and a shearing stress of 1.9 MPa were obtained. The preperties of the paste come up to the world levels of anologous silver paste.

    论述了银粉与树脂配比,溶剂添加量,烘烤温度,烘烤时间对浆料的体电阻率,抗剪强度的影响。制备出体电阻率为10~(-4)~10~(-5)(?)·cm,抗剪强度为1.5MPa的亮银白色的浆料。

     
    << 更多相关文摘    
    图标索引 相关查询

     


     
    CNKI小工具
    在英文学术搜索中查有关烘烤时间的内容
    在知识搜索中查有关烘烤时间的内容
    在数字搜索中查有关烘烤时间的内容
    在概念知识元中查有关烘烤时间的内容
    在学术趋势中查有关烘烤时间的内容
     
     

    CNKI主页设CNKI翻译助手为主页 | 收藏CNKI翻译助手 | 广告服务 | 英文学术搜索
    版权图标  2008 CNKI-中国知网
    京ICP证040431号 互联网出版许可证 新出网证(京)字008号
    北京市公安局海淀分局 备案号:110 1081725
    版权图标 2008中国知网(cnki) 中国学术期刊(光盘版)电子杂志社