助手标题  
全文文献 工具书 数字 学术定义 翻译助手 学术趋势 更多
查询帮助
意见反馈
   临界负载 的翻译结果: 查询用时:0.017秒
图标索引 在分类学科中查询
所有学科
电力工业
互联网技术
更多类别查询

图标索引 历史查询
 

临界负载
相关语句
  critical load
     The critical load of the film is about 31 N by thescretch test.
     (Ti,Al)N薄膜划痕实验的临界负载L_c约为31N。
短句来源
     The mechanical and optical properties of sputtered TiN thin films have been investigated. Microhardness and scratch critical load of TiN thin films are up to 23520N/mm~2 and 80 N, respectively. Cell dimensions and fracture cross section of the films were obtained by x-ray investigation and SEM.
     对这种TiN薄膜的机械与光学性能作了研究,测定了它们的表面粗糙度、显微硬度可达23520N/mm~2和划刻临界负载可达80N,给出了TiN薄膜晶格常数变化与SEM的断面形貌图。
短句来源
     According to the principle that the sum of transformer loss and dielectric loss of capacitors is minimum the critical load, by which the capacitor bank is switched, is calculated and analyzed, the result is that under certain conditions the sum of transformer loss and dielectric loss of capacitors cannot be reduced, but increased.
     根据变压器损耗与电容器介质损耗之和最小的原则分析计算投切电容器组的临界负载,发现在某些条件下提高功率因数不仅不节电反而浪费电量;
短句来源
     The equilibrium current in 24-pulse traction rectifier system is analyzed. The relation between critical load and resistance of traction rectifier transformer is discussed.
     分析了24脉波牵引整流系统中的均衡电流,讨论了临界负载与牵引整流变压器阻抗参数的关系。
短句来源
     Critical load of peer-to-peer networks
     对等网络的临界负载研究
短句来源
更多       
  “临界负载”译为未确定词的双语例句
     To overcome the traditional shortcoming of frequent transferring in the Y/ △ transforming point, a method that adjusts the Y/ △ transforming point and the change time manually is presented.
     并针对传统电动机Y/Δ切换节能保护器在Y/Δ切换点附近发生频繁切换的问题,提出手动现场整定临界负载率和切换时间的解决办法。
短句来源
     This paper gives an exact quantitative analysis about the stator current,the rator current,the loss and the operation efficiency of an asynchronous motor under an off-rated voltage. And then,a method is given. From the method,We can determine the operation voltage of an asynchronous motor by an economical operation principle.
     本文对异步电动机非额定电压运行时定、转子电流、损耗及运行效率进行了较为精确的定量分析,提出了一种按经济运行原则选择异步电动机运行电压的方法并给出 JO_2系列电机的临界负载率。
短句来源
     By practicing △-Y Connecting and analyzing power saving of electrical motor and our factory' s experiment data of JO2 3-7 three -phase asynchronous electrical motor, this paper gives its applying field and gains different ways of connecting changes and limit loading rate for referencing.
     通过电机的型式试验,分析△-Y改接的节电情况。 并根据我厂生产的JO23-7号三相异步电动机型式试验的统计数据计算出各种用控制电流的方法进行改接的转换电流数值范围及△-Y转换的临界负载率。
短句来源
     The hidden failures and power system frequency response characteristics are considered in this model and it can be used to help designers and operators of power grids to get the critical value of loading rate in relation to risk of cascading failures,key lines and risk indices of some operating state.
     模型考虑了保护隐藏故障、计及了系统频率特性, 可以帮助系统规划、设计和运行人员找到系统发生连锁故障的临界负载率、关键线路,并得到某种运行状态下的连锁故障风险指标。
短句来源
  相似匹配句对
     Critical load of peer-to-peer networks
     对等网络的临界负载研究
短句来源
     (M, H)-Critical Matrices
     (M,H)-临界矩阵
短句来源
     The critical load of the film is about 31 N by thescretch test.
     (Ti,Al)N薄膜划痕实验的临界负载L_c约为31N。
短句来源
     Load Equalization Summary
     负载均衡综述
短句来源
     THE GAUSS -CRITICAL SUBMANIFOLDS
     高斯临界子流形
短句来源
查询“临界负载”译词为用户自定义的双语例句

    我想查看译文中含有:的双语例句
例句
为了更好的帮助您理解掌握查询词或其译词在地道英语中的实际用法,我们为您准备了出自英文原文的大量英语例句,供您参考。
  critical load
Analysis of a Communication Network Governed by an Adaptive Random Multiple Access Protocol in Critical Load
      
The value of the network critical load is found; in the critical load, asymptotic probability distributions for states of the information transmission channel and for the number of requests in the source of repeated calls are found.
      
Acidic soil, large deposits of sulfur pollutants in relation to the critical load, the presence of soot and soluble salt, and conditions giving access to water and air were found to accelerate the deterioration.
      
Physical, mechanical, and tribological characteristics of coatings were comparatively analyzed, including determination of the hardness, elastic modulus, elastic recovery, critical load, friction coefficient, and wear rate.
      
The resulting asymptotic solution can be used readily to perform the analysis of parameters and predict the buckling critical load.
      
更多          


This paper gives an exact quantitative analysis about the stator current,the rator current,the loss and the operation efficiency of an asynchronous motor under an off-rated voltage. And then,a method is given. From the method,We can determine the operation voltage of an asynchronous motor by an economical operation principle. Simulta- neously,a couple of critical load rates are listed for JO_2 serial motors in a table.

本文对异步电动机非额定电压运行时定、转子电流、损耗及运行效率进行了较为精确的定量分析,提出了一种按经济运行原则选择异步电动机运行电压的方法并给出 JO_2系列电机的临界负载率。

(Ti, Al)N thin films have been preduced using d. c. planar magnetron sputtering. The microhardness of (Ti, Al)Nthin films deposited on polished and quenched substrates of carbon tool steel has been investigated by varying the reactiveN_2 gas flow and substrate bias. Near the maximum microhardness of about 3000kgf/mm~2 for the sputtered (Ti,Al)Nfilm was obtained at 10 seem N_2 flow, P_(N_2)/P_(Ar) of 0. 12 and 200 V bias. The critical load of the film is about 31 N by thescretch test. Wear tests show that the...

(Ti, Al)N thin films have been preduced using d. c. planar magnetron sputtering. The microhardness of (Ti, Al)Nthin films deposited on polished and quenched substrates of carbon tool steel has been investigated by varying the reactiveN_2 gas flow and substrate bias. Near the maximum microhardness of about 3000kgf/mm~2 for the sputtered (Ti,Al)Nfilm was obtained at 10 seem N_2 flow, P_(N_2)/P_(Ar) of 0. 12 and 200 V bias. The critical load of the film is about 31 N by thescretch test. Wear tests show that the film has a much better wear risistance than the substrate of quenched carbon toolsteel. (Ti,Al)N films have a better oxidation resistance due to the formation of thin Al-O protecting layer on top of thefilms.

运用直流平面磁控反应溅射在抛光淬火的TSA碳素工具钢上沉积(Ti,Al)N薄膜。研究了反应气体N_2流量与基片偏压对形成(Ti,Al)N薄膜的显微硬度的影响。在N_2流量约为10sccm,P_(N2)/P_(Ar),约为0.12与偏压U_B=200V时,(Ti,Al)N薄膜的显微硬度接近极大,可达3000kgf/mm~2。(Ti,Al)N薄膜划痕实验的临界负载L_c约为31N。磨损实验表明,(Ti,Al)N薄膜比淬火的T8A碳素工具钢基底具有好得多的耐磨损特性。微观分析表明(Ti,Al)N薄膜具有良好的抗氧化性能是由于氧化过程中在薄膜表面形成Al-O保护层。

The TiN thin films were deposited on the two substrates of hardmetal and austenitic steel by using DC. magnetron reactive sputtering with N_2/Ar pressure ratio range of 3%~13%, heated substrates and bias. The mechanical and optical properties of sputtered TiN thin films have been investigated. Microhardness and scratch critical load of TiN thin films are up to 23520N/mm~2 and 80 N, respectively. Cell dimensions and fracture cross section of the films were obtained by x-ray investigation and SEM. Near normal...

The TiN thin films were deposited on the two substrates of hardmetal and austenitic steel by using DC. magnetron reactive sputtering with N_2/Ar pressure ratio range of 3%~13%, heated substrates and bias. The mechanical and optical properties of sputtered TiN thin films have been investigated. Microhardness and scratch critical load of TiN thin films are up to 23520N/mm~2 and 80 N, respectively. Cell dimensions and fracture cross section of the films were obtained by x-ray investigation and SEM. Near normal specular, diffuse and total reflectance of TiN thin films on two substrates were measured at 0.35-2.5μm wavelength range. The optical constants, n-refractive index, k-extinction coefficient of TiN thin films were determined by T-R method.

运用直流磁控溅射技术,在加温与具有偏压的硬质合金与奥氏体不锈钢衬底上,在N_2与Ar压强比在3%~13%内沉积TiN薄膜。对这种TiN薄膜的机械与光学性能作了研究,测定了它们的表面粗糙度、显微硬度可达23520N/mm~2和划刻临界负载可达80N,给出了TiN薄膜晶格常数变化与SEM的断面形貌图。测定了两种基体上TiN薄膜的近于垂直的镜反射率、漫反射率与总反射率。还确定了TiN薄膜的光学常数n—折射率,k—消光系数。

 
<< 更多相关文摘    
图标索引 相关查询

 


 
CNKI小工具
在英文学术搜索中查有关临界负载的内容
在知识搜索中查有关临界负载的内容
在数字搜索中查有关临界负载的内容
在概念知识元中查有关临界负载的内容
在学术趋势中查有关临界负载的内容
 
 

CNKI主页设CNKI翻译助手为主页 | 收藏CNKI翻译助手 | 广告服务 | 英文学术搜索
版权图标  2008 CNKI-中国知网
京ICP证040431号 互联网出版许可证 新出网证(京)字008号
北京市公安局海淀分局 备案号:110 1081725
版权图标 2008中国知网(cnki) 中国学术期刊(光盘版)电子杂志社