历史查询   





 为了更好的帮助您理解掌握查询词或其译词在地道英语中的实际用法，我们为您准备了出自英文原文的大量英语例句，供您参考。 
A digital accelerometer is developed by using a ring oscillator (RO) and a mixer.


Based on this fact, firstly, a snakelike robot controller with cyclic inhibitory CPG model was designed, and then the stability of a single neuron, CPG model and the NON (neuron oscillator network) was analyzed.


A method based on the energy dissipation mechanism of an Independent Oscillator model is used to calculate the frictional force and the friction coefficient of interfacial friction.


The dipole oscillator strengths for the 1s22s1s2np and 1s22p1s2nd (n ? 9) transitions of V20+ ion are calculated with the energies and FCPC wave functions obtained above.


The calculations are based on the liquid drop macroscopic model and the microscopic model with the modified singleparticle oscillator potential.

 更多 
Numerical modeling bore out efficiency of this method for any number of oscillators.


Blockcircuits of phaselocked systems, which act as frequency synthesizers and misphasing correctors, for timing oscillators of digital signal processers are designed.


Examples of applying the method of passification and adaptive observers to the problems of synchronization of the nonlinear oscillators and message transmission by chaotic signals were presented.


Analytical synthesis of oscillators on two oscillatory links


Simplest Kinetic Schemes for Biochemical Oscillators

 更多 
A digital accelerometer is developed by using a ring oscillator (RO) and a mixer.


Based on this fact, firstly, a snakelike robot controller with cyclic inhibitory CPG model was designed, and then the stability of a single neuron, CPG model and the NON (neuron oscillator network) was analyzed.


A method based on the energy dissipation mechanism of an Independent Oscillator model is used to calculate the frictional force and the friction coefficient of interfacial friction.


The dipole oscillator strengths for the 1s22s1s2np and 1s22p1s2nd (n ? 9) transitions of V20+ ion are calculated with the energies and FCPC wave functions obtained above.


The calculations are based on the liquid drop macroscopic model and the microscopic model with the modified singleparticle oscillator potential.

 更多 
Combining the quantum defect theory with the discrete oscillator strengths, the discrete oscillator strengths for 1s23d1s2nf (n >amp;gt; 9) transitions and the oscillator strengths densities corresponding to the boundfree transitions are obtained.


It is revealed that the values of the oscillator strengths and the probabilities of spontaneous radiative transitions in Er3+ ions in the chalcogenide matrix are larger than those in phosphate, germanate, and tellurite matrices.


The operation of the oscillator is based on the creation of overvoltages across the spark gaps that increase from the first gap to the last.


The oscillator head is a waveguide section with a channel cross section of 7.2 × 3.4 mm2.


Both analytic and numerical techniques have been used in studying the oscillator dynamics at given beam parameters (configuration, electron energy, and current pulse), with different plasma configurations, and at various lengths of the system.

 更多 
 其他 

 The main and ancillary factors which influence the oscillating cavity forming selfexcited oscillation through the experiment is studied in this paper. The oscillators were compared and optimum seeked under the condition of experiment, based on which, the experimental research with leadingin turbulence were done. The purpose of the experiment is to supply a new thought for the design of drilling bit cavity, especially, it supplies the experimental evidence for the hydraulic system design of the small size... The main and ancillary factors which influence the oscillating cavity forming selfexcited oscillation through the experiment is studied in this paper. The oscillators were compared and optimum seeked under the condition of experiment, based on which, the experimental research with leadingin turbulence were done. The purpose of the experiment is to supply a new thought for the design of drilling bit cavity, especially, it supplies the experimental evidence for the hydraulic system design of the small size cone bit. At the same time, the effort is made to find a new method of the fluid selfexcited oscillating pressure boost.We adopted the replaceable oscillating cavity designed by authors in the experiment was adopted, it has three kinds of cavity diameters (50mm, 60mm, 70mm), and its cavity length can be steeples regulated. The experiment was done under the conditions of submergence by clean water and with no backpressure. In the case of submergence and freeness jet flow, the turbulence can be ledin by drilling a hole at the side wall of the oscillator, and the impact pressure of the jet flow can be measured at the outlet of the oscillator, then the experimental results can be analyzed through the waveform analysis and spectrum analysis.The experiment shows that the oscillator behaviors can be changed by leadingin turbulence, even possibly improved under some conditions. High power oscillator and producing selfexcited pressure boost can form powerful impulse jet flow.  通过实验研究了影响振荡腔室产生自激振荡的主次因素，在实验条件下对流体振荡器进行了比较和优选，在此基础上进行引入扰动的实验研究，试图为钻头内腔设计提供新的思路，尤其是为小尺寸钻头水力系统设计提供实验依据，同时也试图探索流体自激振荡增压的新途径。实验中采用了我们自行设计的可更换式振荡腔，它具有５０ｍｍ～７０ｍｍ三种腔径，腔长可无级调节，实验是在清水淹没无回压条件下进行的。在淹没非自由射流条件下，采用在振荡器侧面钻孔的方式引入扰动，测量振荡器出口射流的冲击压力，对实验结果进行波形分析和频谱分析。实验表明，引入扰动可以改变，甚至在一定条件下可以改善振荡器特性，设计大功率振荡器，产生自激增压，形成强有力的脉冲射流。  After the analysis of lack of injection in Lianjialou oilfield, an injection increasing technique by acidizing magnetization oscillation was put forward and its mechanism has been researched. It shows that the water injection after acidized then magnetized oscillation is a activating blocking relieved process.This process is helpful for injection and reduces the secondary blocking, so keeping the acidizing effect and prolonging the valid period of injection increase. Field practical applications show that... After the analysis of lack of injection in Lianjialou oilfield, an injection increasing technique by acidizing magnetization oscillation was put forward and its mechanism has been researched. It shows that the water injection after acidized then magnetized oscillation is a activating blocking relieved process.This process is helpful for injection and reduces the secondary blocking, so keeping the acidizing effect and prolonging the valid period of injection increase. Field practical applications show that valid period of acidizing magnetization oscillation for the injection is prolonged 1 37～ 3.75 times that of acidizing only. The effect is obvious.  通过对梁家楼油田水井欠注原因的分析，提出了酸化磁化振荡增注工艺，并对该工艺的增注机理进行了探讨。研究表明：酸化后，下入磁化振荡器进行注水是一个动态解堵的过程，既有利于注水，又减少或抑制了堵塞物的二次形成，从而保持了酸化效果，延长了增注有效期。现场应用后，酸化磁化振荡增注有效期较酸化增注有效期延长了１．３７～３．７５倍，措施效果明显。  Introduces working principle and structure of a indication and alarm device for over water content rate in piped crude oil. The electric amount in a capacitance in sensitive probe composed of emitting antenna and the corresponding oil transport pipe case will vary with water content rate in crude oil and the probe is also used as a modulate capacitance of a resonance circuit. The resonance circuit is coupled by inductance and obtains oscillating voltage from a stable crystal oscillator. When the capacitance... Introduces working principle and structure of a indication and alarm device for over water content rate in piped crude oil. The electric amount in a capacitance in sensitive probe composed of emitting antenna and the corresponding oil transport pipe case will vary with water content rate in crude oil and the probe is also used as a modulate capacitance of a resonance circuit. The resonance circuit is coupled by inductance and obtains oscillating voltage from a stable crystal oscillator. When the capacitance of the sensitive probe is changed, the impedance of the oscillator circuit will be changed consequently, e. g. changes in oscillating voltage will occur. The change will be transferred into D. C. voltage changeable output through detecting circuit and displayed.  介绍了一种管输原油含水率超标(≥2.5%)指示与报警仪器的工作原理与结构。由发射天线和相应输油管壳组成的敏感探头的电容量随原油含水率的变化而改变,并作为谐振电路的调谐电容。谐振电路通过电感耦合,从稳定的晶体振荡器获取振荡电压。当敏感探头电容改交时,谐振电路的阻抗发生变化,即振荡电压发生变化,这个变化经检波电路转换为直流电压变化输出并显示。   << 更多相关文摘 
相关查询  


