To theoretically justify the effective thermodynamical conditions of the hybrid system, the concepts of critical relative inner efficiency of total flow engine and critical dryness of heat sources are proposed.
Digital Particle Image Velocimetry is the developing full flow field measurement method . In this paper, we mainly study the key technique in this method-the matching algorithm of particle image.
Its basic integration of full flow dilute and flow control system such as application fields, major technical parameters and Adjustment are introduced with emphasis.
In Europe and in many countries or regions, the partial-flow dilution sampling system, usedas a special test set-up, has taken the place of the full-flow system CVS, enormous and costly.
Aiming at the problem of easy break of filtering net when pressure all-flow filter filtered high-silt content water, this paper presents a soft non-all-flow filtering method and device that filters high-silt content water, and conducts a drip irrigation experimentation using the filtered water.
Total flow curves of the suspensions of modified (methylated) nanodispersed Aerosil (mean particle size is 40 nm) in Vaseline oil with concentrations of 2-7 wt % are recorded under quasi-equilibrium conditions.
For differing flow distribution along the radius we solve the problem of specifying the ratio of the electrode radii required to obtain a given total impulse with the least power for a given total flow.
The method is based on the zonal linearization of the equation for mass conservation in the total flow between chosen surfaces or contour lines (lines of equal saturation or concentration).
The influence of the motion in the unsaturated region on the total flow of ground water is most important when the water-saturated region is thin and especially in the case of finely grained soil.
The flow rate in general varies as should be expected, except, perhaps, at the onset of oscillation at low transmural pressures when it suffers a fairly abrupt decrease from its steady full flow value.
Movable Electrical Conducting Probe (MECP), a kind of simple and reliable measuring transducer, used for predicting full-flow-path flow pattern in a boiling vapor/liquid two-phase flow is introduced in this paper.
By means of flow pattern analysis, flow field numerical calculations have been carried out, and heat transfer coefficient correlations along full-flow-path derived.
With the exception of thoracic aortic procedures, full-flow perfusion was performed.?Measurements and results: PCT was measured prior to surgery and daily thereafter until ICU discharge or death.