助手标题  
全文文献 工具书 数字 学术定义 翻译助手 学术趋势 更多
查询帮助
意见反馈
   coating thickness 的翻译结果: 查询用时:0.152秒
图标索引 在分类学科中查询
所有学科
金属学及金属工艺
材料科学
无机化工
核科学技术
有机化工
电力工业
一般化学工业
航空航天科学与工程
仪器仪表工业
更多类别查询

图标索引 历史查询
 

coating thickness     
相关语句
  涂层厚度
     Studies on Measurement of Plasma-sprayed ZrO_28Y_2O_3 Coating Thickness
     等离子喷涂ZrO_28Y_2O_3涂层厚度测量方法研究
短句来源
     The growth velocity of coating thickness was 0.7 m/min during first 135 min, then that was constant.
     陶瓷涂层厚度的生长速率大约为0.7 m/min; 在135 min之后,涂层的厚度基本不变。
短句来源
     The influences of thicknesses of the TiC interface layer and diamond coating on the field emission properties are primarily explored and the ideal combination of annealing temperature and coating thickness is decided.
     本文重点探索了TiC界面层厚度和金刚石涂层厚度对场发射性能的影响,分析比较了不同热处理温度和不同涂层厚度样品的场发射性能,确定出较为理想的退火温度与金刚石涂层厚度的参数组合。
短句来源
     In this thesis, the effect of character of C/SiC surface, coating thickness, heat treatment and oxidation in high temperature on 2D and 3D C/SiC composites were studied.
     本文系统研究了表面特征、涂层厚度、热处理以及高温氧化对2D和3D CVI-C/SiC复合材料热辐射性能的影响。
短句来源
     Carbon coating thickness has evident effects on the mechanical properties of the composites. When the carbon coating thickness was 0 35 μm, the flexural strength was 231 9 MPa. When the carbon coating thickness was 0 55 μm, the fracture toughness was 10 4 MPa·m 1/2 .
     碳涂层的厚度对复合材料的力学性能有较大影响 ,涂层厚度在 0 .35μm时 ,弯曲强度达到2 31.9MPa,在 0 .5 5μm时 ,断裂韧性达到 10 .4 MPa· m1 /2 .
短句来源
更多       
  镀层厚度
     The results indicated that the maximum coating thickness was obtained with a preheating temperature of 500~600℃,bath temperature of 1120~1135℃ ,and contact time of 4~6s.
     结果表明预热温度为500~600℃、浸镀温度为1120~1135℃及浸镀时间4~6s时,可以获得理想的镀层厚度
短句来源
     To test by gold plate, the measuring deviation is<0.10m, when the thickness of gold membrance and coating is t<0. 3μm. The method is simple and convenient for the controlling production of the coating thickness.
     用镀金片检验,当薄膜和镀层厚度t<3.0μm时,测量偏差<0.10μm,方法简便,可方便地用于镀层厚度的控制生产中。
短句来源
     Application of XRF to Coating Thickness Measurement of Metal Cases
     XRF在外壳镀层厚度测试中的正确应用
短句来源
     The adhesion of aluminum coating with the substrate decreases with the coating thickness, but greater than 30 N.
     铝镀层与碳钢基体问的结合力随镀层厚度的增加而减少,但均 大于30 N。
短句来源
     The influences of substrate hardness, coatisng hardne,ss, coating thickness, loading rate, scratch speed and the, friction i state between the indenter ( scratcher) and coatings on critical, load,which cha-
     结果表明,临界载荷随底材硬度及镀层硬度的增加而增大,镀层厚度存在一个最佳值,在此值下的临界载荷最大,当加载速率高于100N/min时,临界载荷基本不再受其影响,临界载荷与划痕速度无关,镀层上覆盖固体润滑剂可使临界载荷增大,而覆盖纯油对临界载荷没有影响。
短句来源
更多       
  包衣厚度
     Conclusion: The pellets was belong to the matrix-coating pellets, its release mechanism was varied with the change of coating thickness.
     结论:体外释放度表明本微丸属于包衣骨架控释微丸,随包衣厚度的改变而释放机理有所不同。
短句来源
     CONCLUSION:The pellets belongs to the matrix-coating pellets,and the release mechanism varies with the change of coating thickness.
     这些因素与包衣厚度共同决定衣膜的控释能力。 结论 :本制剂属于包衣骨架控释微丸 ,随着包衣厚度的改变 ,释放机理有所不同。
短句来源
     Methods Film coating thickness of Compound Danshen Dropping Pills was scanned by NIRS instrument,the pretreatment methods and wavenumber selection of NIRS were discussed in detail. Partial least squares regress(PLSR) was utilized to build the quantitive calibration model.
     方法用近红外光谱仪扫描复方丹参滴丸包衣生产过程中的样品,对所得近红外漫反射光谱的预处理方法、有效谱段范围选择进行了讨论,并用偏最小二乘回归法(PLSR)建立测定滴丸包衣厚度的近红外光谱定量分析校正模型。
短句来源
     The preparation parameters were investigated by evaluation of the film coating thickness and uniformity.
     以薄膜包衣厚度和均匀性为指标,考察包衣工艺参数。
短句来源
     Objective Near-infrared spectroscopy(NIRS) and chemometrics were used to develop a nondestructive method for fast detection of Compound Danshen Dropping Pills′ film coating thickness in pharmaceutical process.
     目的应用近红外光谱分析技术结合化学计量学方法建立制药过程中复方丹参滴丸包衣厚度的快速、无损检测的新方法。
短句来源
更多       
  覆层厚度
     Study on Nondestructive Coating Thickness Measurement Methods of Coated Particles
     微球覆层厚度无损测定方法研究
短句来源
     Relation Between Coating Thickness and Carbon Content and Holding Time in Carbon Steel's Mixed Salt Bath Vanadinizing
     碳钢混合盐浴渗钒时覆层厚度与含碳量及保温时间的关系
短句来源
     For thincoating and thick coating, the coating thickness may be deviate from the real thicknesswhen low diffraction angle peak are used in substrate XRD method, we should use thehigh diffraction angle peak in substrate XRD method;
     基体X 射线衍射法在选用低角度衍射峰来测量覆层厚度时,对于太薄和太厚的覆层,其测量值会严重偏离实际厚度,测量时应尽量选用高角度的衍射峰进行测量;
短句来源
     The carbon steel used in the mixed salt bath which is the mixture of broax and neutral salt for vanadinizing. The purpose is to research the effect that carbon content and holding time do for the coating thickness.
     采用硼砂与中性盐混合盐浴对碳钢试样进行渗钒,研究钢含碳量及保温时间对覆层厚度的影响。
短句来源

 

查询“coating thickness”译词为其他词的双语例句

 

查询“coating thickness”译词为用户自定义的双语例句

    我想查看译文中含有:的双语例句
例句
为了更好的帮助您理解掌握查询词或其译词在地道英语中的实际用法,我们为您准备了出自英文原文的大量英语例句,供您参考。
  coating thickness
The effect of the coating thickness, the ambient pressure and the temperature of the material on the relative pressure difference is investigated.
      
Chronopotentiometric study of copper dissolution revealed that the optimum concentration of NH4NO3in the working solution should be in a range from 100 to 200 g/l for reliable coulometric measurements of the copper coating thickness.
      
The optimization of the electroplating process in drum electrolyzers to minimize the standard deviation of the coating thickness is considered.
      
A dependence of the shelf life of the material on the coating thickness was established.
      
Nondestructive tests of dielectric coating thickness and quality based on frequency characteristics of electric discharge
      
更多          


点击这里查询相关文摘
图标索引 相关查询

 


 
CNKI小工具
在英文学术搜索中查有关coating thickness的内容
在知识搜索中查有关coating thickness的内容
在数字搜索中查有关coating thickness的内容
在概念知识元中查有关coating thickness的内容
在学术趋势中查有关coating thickness的内容
 
 

CNKI主页设CNKI翻译助手为主页 | 收藏CNKI翻译助手 | 广告服务 | 英文学术搜索
版权图标  2008 CNKI-中国知网
京ICP证040431号 互联网出版许可证 新出网证(京)字008号
北京市公安局海淀分局 备案号:110 1081725
版权图标 2008中国知网(cnki) 中国学术期刊(光盘版)电子杂志社