助手标题  
全文文献 工具书 数字 学术定义 翻译助手 学术趋势 更多
查询帮助
意见反馈
   recovery 在 金属学及金属工艺 分类中 的翻译结果: 查询用时:0.13秒
图标索引 在分类学科中查询
所有学科
金属学及金属工艺
石油天然气工业
中药学
化学
环境科学与资源利用
外科学
药学
有机化工
矿业工程
更多类别查询

图标索引 历史查询
 

很抱歉,暂未找到该词条在当前类别下的译词。
您可以查看在所有学科的译词。
相关语句
  回收率
    Detection limits of the 7 elements were found in the range of 0.000 9-0.022 5 mg·L-1.Precision and recovery of the method were tested,giving RSD′s in the range of 0.048%-0.34% and recoveries in the range of 99.0%-102.0%.
    L-1,方法的回收率和相对标准偏差分别为99.0%~102.0%和0.048%~0.34%。
短句来源
    The best combination of flux components (35%NaCl, 40%KCl, 5%Na3AlF6 , 5%villiaumite A, 15%villiaumite B), melting temperature (720℃) and flux addition (4%) can makes recovery ratio increase to 90% and impurity content reduce to 0.0531%.
    通过正交优化和比较等方法得到了最优的熔剂配比及净化处理工艺:配方③熔剂、熔炼温度720℃、熔剂加入量4%的组合,在此条件下废铝屑的回收率为90%,合金的含杂量为0.0531%。
短句来源
    The recovery is in the range of 98%~103%. Relative standard deviation(RSD)is less than 3.0%. The method is rapid,simple with high accuracy.
    结果表明:该方法回收率为98%~103%,RSD小于3.0%,且简便、快速、准确度高,已用于钽合金产品的检验。
短句来源
    The results show that the method is quick and accurate,the recovery rate is in the range of 91.8%~102.7% and the RSD ≤3.64%(n=6).
    结果表明,此法快速、准确,回收率在91.8%~102.7%之间,RSD≤3.64%。
短句来源
    Test for recovery was made by adding 200.0 mg·kg-1 of standard chloride to 6 samples of Mg-Al alloy,and the values of recovery were found in the range of 94.1% to 106.0%.
    在6个试样中各加氯标准200.0 mg. kg-1作回收率试验,所得结果在94.1%~106.0%之间。
短句来源
更多       
  恢复
    The Creep Damage and Reheat-Treatment to Recovery of 12Cr1MoV Steel
    12Cr1MoV钢蠕变损伤及恢复热处理
短句来源
    Effects of Creep Strength Recovery Heat-treatment on Morphology and Distribution of Creep Voids for a 21/4 Cr-1Mo Steel Welding Joints
    蠕变抗力恢复热处理对21/4Cr-1Mo钢焊接接头蠕变空洞形态及其分布的影响
短句来源
    INTERNAL FRICTION AND RESISTANCESYNCHRONISTIC MEASUREMENT IN THE PROCESSOF SHAPE RECOVERY FOR Fe-30Mn-6Si ALLOY
    Fe—30Mn—6Si合金(SMA)形状恢复过程的内耗和电阻分析
短句来源
    The Martensitic Transformation and Recovery of Torsionally Deformed Samples in the Shape Memory Alloy of Fe-Mn-Si
    形状记忆Fe-Mn-Si合金中马氏体相变和扭转形变的恢复
短句来源
    RECOVERY OF CREEP PROPERTIES OF 12Cr1MoV STEEL BY RESTORATION-HEAT-TREATMENT
    12Cr1MoV钢经修复热处理后蠕变性能的恢复
短句来源
更多       
  回收
    ANALYSIS AND DETERMINATION OF SPRAY FURNACE TUBE FOR ALKALI RECOVERY IN PAPERMAKING PRECESS
    造纸碱回收喷射炉炉管材质分析鉴定
短句来源
    Technological Process of Ni--Al Alloy Fines Recovery with Plasma Arc Furnace
    等离子电弧炉回收Ni-Al合金细粉工艺的研究
短句来源
    Recovery of Precious Metals in Japan
    日本贵金属回收业概况
短句来源
    The Application of Solvent Extraction on the Gold Recovery from Alkaline Cyanide Solutions
    溶剂萃取从碱性氰化物溶液中回收
短句来源
    DIRECT RECOVERY OF COBALT METAL AND TUNGSTEN CARBIDE FROM HARD ALLOY SCRAP BY ELECTROCHEMICAL METHOD
    电化学法处理废硬质合金直接回收金属钴和碳化钨
短句来源
更多       
  收率
    The current efficiency of Nd during electrolysis is 92~99%, the direct recovery of neodymium metal is 86~95%, Neodymium content in Nd-Zn alloy is 10—50wt%.
    电解过程中金属钕的电流效率为92~99%,直收率为86~95%,Nd-Zn合金中含钕达10~50wt%。
短句来源
    This new method has lower acidity and temperature, more moderate current density and higher recovery of GCP phase than routine (10%H 3PO 4 solution, 25℃, 5mA/cm 2).
    新方法与常规方法 ( 1 0 %H3PO4水溶液 ,2 5℃ ,5mA/cm2 )相比酸度低 ,温度低 ,电流密度适中 ,GCP相的收率高。
短句来源
    When the aluminum-magnesium melt was used as the reductive agent, the recovery would exceed 80% and the content of Sc in master alloy prepared would exceed 1.9%(mass fraction). The best reducing reaction temperature and time is 1 100 K and 40 min, respectively.
    采用Al Mg合金熔体为还原剂经二次还原后钪收率 >80 %,制备的Al Mg Sc中间合金铸锭中钪含量 >1.9%,最佳的还原反应温度为 110 0K ,还原时间 40min .
短句来源
    Adding appropriate amount ScF3,the solubility of Sc2O3 in nNaF·AlF3-KCl-NaCl molten salt as well as the content of Sc(to attain 2%)and Sc recovery in the Al-Sc intermediate alloys could be increased. In addition,the quality of the Al-Sc intermediate alloys was improved and its manufacturing cost was too decreased. Thereby it was advantageous to extensive application of the Al-Sc intermediate alloys.
    AlF3—KCl—NaCl熔盐体系中,用液态铝还原Sc2O3制备Al—Sc中间合金,加入适量的ScF3,可以提高Sc2O3在熔盐体系中的溶解度,从而提高Al—Sc中间合金中钪的含量(可达2%)和钪的收率以及Al—Sc中间合金的质量,降低Al—Sc中间合金的生产成本,并为Al—Sc中间合金的广泛应用创造有利条件。
短句来源
    The optimum reduction temperature of ScF3-MX-Mg(AI) to manufacture AI-Mg-Sc alloys is 1100 C, time 40min, the total recovery of scandium after twice fluoridating is higher than 80%.
    swt%的Al·Mg一Sc中间合金,最佳的还原反应温度为1 100℃,还原时间40而n; 二次还原后Sc收率>8O%。
短句来源
更多       

 

查询“recovery”译词为其他词的双语例句

 

查询“recovery”译词为用户自定义的双语例句

    我想查看译文中含有:的双语例句
例句
为了更好的帮助您理解掌握查询词或其译词在地道英语中的实际用法,我们为您准备了出自英文原文的大量英语例句,供您参考。
  recovery
Connections to signal recovery for positive functions, as well as partial spectral analysis, are also discussed.
      
The sensor has also been applied to the analysis of nicotine in tobacco samples with recovery rates ranging from 99.0% to 102%.
      
The 50% compressed PLA-PUs could recover almost 100% to their original shape within 10°C from the lowest recovery temperature (22°C-37°C).
      
In the recovery process the PLA-PU showed a maximum contracting stress in the range of 1.5-4 MPa.
      
Under these conditions, the recovery of the solvent is 86.0%.
      
更多          


点击这里查询相关文摘
图标索引 相关查询

 


 
CNKI小工具
在英文学术搜索中查有关recovery的内容
在知识搜索中查有关recovery的内容
在数字搜索中查有关recovery的内容
在概念知识元中查有关recovery的内容
在学术趋势中查有关recovery的内容
 
 

CNKI主页设CNKI翻译助手为主页 | 收藏CNKI翻译助手 | 广告服务 | 英文学术搜索
版权图标  2008 CNKI-中国知网
京ICP证040431号 互联网出版许可证 新出网证(京)字008号
北京市公安局海淀分局 备案号:110 1081725
版权图标 2008中国知网(cnki) 中国学术期刊(光盘版)电子杂志社