助手标题  
全文文献 工具书 数字 学术定义 翻译助手 学术趋势 更多
查询帮助
意见反馈
   absorbing 在 材料科学 分类中 的翻译结果: 查询用时:0.013秒
图标索引 在分类学科中查询
所有学科
材料科学
环境科学与资源利用
新能源
有机化工
轻工业手工业
无机化工
冶金工业
园艺
工业通用技术及设备
更多类别查询

图标索引 历史查询
 

absorbing
相关语句
  
    Design and Preparation of Fe-Ni Soft Magnetic Alloy Absorbing Materials
    Fe-Ni软磁合金波材料的设计与制备
短句来源
    Study of Microwave Absorbing Performances of Nano-Fe_3Al Intermetallic
    纳米Fe_3Al金属间化合物波性能的研究
短句来源
    Cement-based Composite Materials for Microwave Absorbing
    水泥基复合波材料
短句来源
    A New Type of Wave Absorbing Material
    新型波材料研究
短句来源
    The Study of Honeycomb Sandwich Microwave Absorbing Materials
    蜂窝夹层结构波材料研究
短句来源
更多       
  吸波
    Design and Preparation of Fe-Ni Soft Magnetic Alloy Absorbing Materials
    Fe-Ni软磁合金吸波材料的设计与制备
短句来源
    Study of Microwave Absorbing Performances of Nano-Fe_3Al Intermetallic
    纳米Fe_3Al金属间化合物吸波性能的研究
短句来源
    Cement-based Composite Materials for Microwave Absorbing
    水泥基复合吸波材料
短句来源
    A New Type of Wave Absorbing Material
    新型吸波材料研究
短句来源
    The Study of Honeycomb Sandwich Microwave Absorbing Materials
    蜂窝夹层结构吸波材料研究
短句来源
更多       
  “absorbing”译为未确定词的双语例句
    AB_2 Type Zr-Based Laves Phase Alloys and Hydrogen Absorbing Electrodes
    AB_2型锆基Laves相合金及贮氢电极
短句来源
    The results show that crystalline phase transition temperature is about 300℃, and the composite particles in the plating solution results in the decreasing of crystallization temperature of the coating as absorbing the H ions. A complex structure of Ni3P+Ni+UFD is achieved after crystallizing in the coatings.
    300℃左右时,镀层开始晶化,与Ni-P复合镀相比,复合粒子的加入使晶化温度降低:时效晶化后,复合镀层的结构为Ni3P+Ni+UFD的混合结构。
    The reflectivity lower than -SdB of the activated CNTs is in the range of 5.3 GHz to 18 GHz, while that lower than -10dB is in the range of 6.48 GHz to 10.88 GHz. The maximum absorbing peak of the activatod CNTs teaches 22.58 dB at 8.08 GHz.
    活化碳纳米管在5.37~18GHz范围内对电磁波的反射率低于-5dB,在6.48~10.88GHz范围内对电磁波的反射率低于-10dB,最大的衰减峰值达到22.58dB。
    The ε′ and ε″ of the mixture are high, which is suitable for microwave absorbing material.
    包覆粉体具有高的复介电常数的实部ε′和虚部ε″值。
    Study on Characteristics of Hydrogen absorbing LaNi 5 Alloy Powder Made by Gas Atomization
    气体雾化LaNi_5型储氢合金粉末特性的研究
短句来源
更多       
查询“absorbing”译词为用户自定义的双语例句

    我想查看译文中含有:的双语例句
例句
为了更好的帮助您理解掌握查询词或其译词在地道英语中的实际用法,我们为您准备了出自英文原文的大量英语例句,供您参考。
  absorbing
This paper considers how to find some joint distributions and their marginal distributions of crossing time and renewal numbers related to two PH-renewal processes by constructing an absorbing Markov process.
      
Discrete singular convolution method with perfectly matched absorbing layers for the wave scattering by periodic structures
      
Absorbing water from soil by roots in vascular plants is an important physiological function and plays an essential role on their water balance.
      
Results showed that compared with farmland watersheds, runoff generation time in forest watersheds was delayed remarkably, and peak flow was reduced greatly, which indicates that vegetation played an important role in holding and absorbing rainfall.
      
The contents of the tested microelements in soil fauna had significant correlations with their environmental background values, litter decomposition rate, food habit of soil fauna, and its absorbing selectively and enrichment to microelements.
      
更多          


Reaction between carbon and oxygen in melts of iron was studied, using crucibles made of electrically prefused magnesia, in a medium-frequency induction furnace of 10kg. capacity. It was found that the melts continually absorbed oxygen from the crucible, so that during the heat its oxygen content dropped to a minimum and then rose again. Under a furnace pressure of 10-4 (and in a few cases 10~(-1) mm Hg, the [%C].[0%] product fell between 6×10~(-6) and 3.5×10~(-5). By limiting the carbon content of the...

Reaction between carbon and oxygen in melts of iron was studied, using crucibles made of electrically prefused magnesia, in a medium-frequency induction furnace of 10kg. capacity. It was found that the melts continually absorbed oxygen from the crucible, so that during the heat its oxygen content dropped to a minimum and then rose again. Under a furnace pressure of 10-4 (and in a few cases 10~(-1) mm Hg, the [%C].[0%] product fell between 6×10~(-6) and 3.5×10~(-5). By limiting the carbon content of the charged iron to 0.03—0.05%, with a C:O ratio of 2, a high-purity product containing less than 0.003% oxygen and less than 0.006% carbon was satisfactorily obtained. The melt-crucible reaction became less pronounced with each heat after a new crucible had been put into use. The oxygen content of the melt had a marked effect on its final nitrogen content. A high oxygen concentration retarded de-nitrogenation.

用容量为10公斤的真空感应炉研究了在电熔氧化鎂坩堝中熔炼純鉄时熔池中碳和氧的反应,以及坩堝在这个反应中所起的作用。証实在熔炼过程中坩堝不断向熔池供氧,因此熔池的含氧量在降低到最低值后重新回升。在10~(-4)(及10~(-1))毫米汞柱的炉压下,发現熔池中的[%C]·[%O]乘积都达到6×10~(-6)至3.5×10~(-5)之間的数值。当配料含碳0.03—0.05%而含氧为其一半时,可以得到含碳0.006%以下、含氧0.003%以下的高純度铁。坩堝对熔池的影响随着使用次数的增长而減弱。熔池的氧浓度对最終含氮量有显著影响。含氧量越高,脫氮就越慢。

The thermo-stability of K_2TaF_7 in air and argon atmosphere was investigated by means of thermo-differential, thermo-gravimetric and chemical analyses and also X-ray powder diffraction method. An obvious heat-absorbing effect was observed at 218°±3℃ with the appearance of break-up of larger crystals. The melting point of K_2TaF_7 was measured to be 730°±3℃. During the course of heating, by the action of moisture in air, K_2TaF_7 was hydrolyzed into K_2TaO_2F_3 which is soluble in molten K_2TaF_7 and thus...

The thermo-stability of K_2TaF_7 in air and argon atmosphere was investigated by means of thermo-differential, thermo-gravimetric and chemical analyses and also X-ray powder diffraction method. An obvious heat-absorbing effect was observed at 218°±3℃ with the appearance of break-up of larger crystals. The melting point of K_2TaF_7 was measured to be 730°±3℃. During the course of heating, by the action of moisture in air, K_2TaF_7 was hydrolyzed into K_2TaO_2F_3 which is soluble in molten K_2TaF_7 and thus affects its melting point. This might throw light on the disagreement of the melting points of K_2TaF_7 determined by the various authors. The end product of hydrolysis of K_2TaF_7 was identified to be KF and KTaO_3 (potassium meta-tantalate). Finally, the different stages of hydrolytic reaction of K_2TaF_7 and its relation with various temperatures were discussed.

用热差分析、热重分析、化学分析及X射线粉末衍射法研究了K_2TaF_7在空气中和氩气氛中加热时的行为.发现在218°±3℃,有一显著的吸热效应,同时发生晶体破碎.测得K_2TaF_7的熔点为730°±3℃.当加热时,K_2TaF_7同空气中的水气起水解作用,水解产物能溶于K_2TaF_7熔体而影响其熔点.这可能是过去测定的熔点不一致的原因.确定了水解最终产物为氟化钾及偏钽酸钾.最后,讨论了水解反应的步骤及其与溫度的关系.

Argon ion sputtering alone does not remove completely the carbon remained on the nickel surface. By bombarding the nickel surface contaminated with carbon with an electron beam under a pressure of 10-8-10-9 torr to enhance the adsorption of oxygen on it, we obtain a nickel surface with both absorbed oxygen and carbon. Heating this surface at 360℃ for 45 minutes, we could obtain an atomically clean surface without carbon. The conditions and the possible machanism of removing residual carbon by oxygen are...

Argon ion sputtering alone does not remove completely the carbon remained on the nickel surface. By bombarding the nickel surface contaminated with carbon with an electron beam under a pressure of 10-8-10-9 torr to enhance the adsorption of oxygen on it, we obtain a nickel surface with both absorbed oxygen and carbon. Heating this surface at 360℃ for 45 minutes, we could obtain an atomically clean surface without carbon. The conditions and the possible machanism of removing residual carbon by oxygen are disccused.

单用氩离子剥离很难完全去掉镍表面上的碳。在10~(-8)—10~(-9)托下用电子轰击加速氧的吸附,使残留着碳的镍表面吸附一定的氧;再将这个表面加热到360℃保温45分钟,获得了一个无碳的原子级清洁表面。讨论了利用氧去除碳的条件和机制。

 
<< 更多相关文摘    
图标索引 相关查询

 


 
CNKI小工具
在英文学术搜索中查有关absorbing的内容
在知识搜索中查有关absorbing的内容
在数字搜索中查有关absorbing的内容
在概念知识元中查有关absorbing的内容
在学术趋势中查有关absorbing的内容
 
 

CNKI主页设CNKI翻译助手为主页 | 收藏CNKI翻译助手 | 广告服务 | 英文学术搜索
版权图标  2008 CNKI-中国知网
京ICP证040431号 互联网出版许可证 新出网证(京)字008号
北京市公安局海淀分局 备案号:110 1081725
版权图标 2008中国知网(cnki) 中国学术期刊(光盘版)电子杂志社