The dielectric constant and dissipation factor for(Ba0.65Sr0.35)TiO3 thin film at room temperature and a frequency of 100 kHz were 353.8 and 0.012 8,respectively.
The experimental results show that the piezoelectric charge constant(d33),relative dielectric constant(εr) and dielectric dissipation loss factor(tanδ) decrease dramatically with increasing amount of doped Co2O3 in a rang from 0 to 0.4 %.
After optimizing insulation design,processing research and testverification,the final product has main specifications as follows: power frequency withstand voltage 1 200 kV 5 min,lightning impulse withstand voltage 2 400 kV,switching impulse withstand voltage 1 960 kV / 1 800 kV,low dielectric dissipation(tanδ),low partial discharge magnitude,stable insulation performance.
The Hspice simulation results show that the typical ripple voltage is 10mV,and the typical quiescent current is only 56.7 μA,but quiescent current is less than 0.01 μA in standby mode,efficiency achieves up to 90% at 1mA when power supply is 3.6 V and temperature is 25 ℃,which imply it has an advantage of low power dissipation,low ripple voltage and high efficiency.
In the present paper, we deal with the long-time behavior of dissipative partial differential equations, and we construct the approximate inertial manifolds for the nonlinear Schr?dinger equation with a zero order dissipation.
The relative dielectric constant εr and the dissipation factor tgδ of the PZT thin films were measured with an LCR meter and were found to be 158 and 0.04-0.005, respectively.
The sap flow density, water consumption, and related environmental factors were also measured using thermal dissipation method and ICT-2000TE (Transpiration-Environment) automatic measuring system for tree transpiration and environmental factors.
Three problems are herein discussed: how to raise the rate of certificated 500A silicon wafers over 2KV; how to improve the contour and stability of the junction surface; how to raise the ability of the rectifiers at surge current. The effects of power dissipation and construction parameters of the rectifiers on the trasient maximum allowable junction temperature of the rectifiers at surge current are calculated on an electronic computer and analyzed. Based on the transient maximum allowable junction ...
There exist two relative theories of the alternating current circuit, the theory of constant current source and that of constant voltage source and so there are also two relative methods, the method of unifying admittance calculation and that of unifying impedance calculation. In the alternating current bridge methods generally speaking, both of these calculations are randomly used and may sometimes cause trouble during bridge circuit analysis. From the history of the development of the bridge, it can be se...
This paper describes the measurements of several high frequency parameters of the fixed condenser by a resonance method with the aid of a wide frequency band Q meter. It includes the separate detective analyses of the equivalent serial and paralled resistances, the serial inductance and high frequency dissipation (within 300 MHz).This paper analyses the measuring accuracy quantitatively also.