助手标题  
全文文献 工具书 数字 学术定义 翻译助手 学术趋势 更多
查询帮助
意见反馈
   bend 的翻译结果: 查询用时:0.138秒
图标索引 在分类学科中查询
所有学科
金属学及金属工艺
力学
水利水电工程
地球物理学
动力工程
石油天然气工业
工业通用技术及设备
建筑科学与工程
航空航天科学与工程
更多类别查询

图标索引 历史查询
 

bend     
相关语句
  弯曲
     Investigation on the Technological Process of a φ1040×1500 Bend Stretcher Leveller
     φ1040×1500拉伸弯曲矫正机工艺研究
短句来源
     A Study about J and rp in the Three-point Bend Specimens with Shallow Notches
     浅裂纹三点弯曲试件的J和r_p研究
短句来源
     A Study of COD on Three-point Bend Specimen ts with Shallow Crack
     浅裂纹三点弯曲试件的COD研究
短句来源
     Determination of Fracture Toughness of the High-Strength Steel Bar with Arc-Shaped Three-Point Bend Specimen
     用拱形三点弯曲试样测定高强钢棒材断裂韧性
短句来源
     Numerical Method for Determining K_1 of Straight Three-point Bend Specimen
     直三点弯曲试样K_1的数值解法
短句来源
更多       
  
     On impact and cold bend properties of 1Cr17Ni13Mo2Ti steel weld metal
     1Cr17Ni13Mo2Ti焊缝冲击韧性及冷性能研究
短句来源
     THE DEVELOPMENT OF MODEL 5LZ95×7.0 INTEGRATE DOUBLE BEND SCREW DRILL
     5LZ95×7.0同体双螺杆钻具研制
短句来源
     A study on the shaping technology of a 180° E bend waveguide
     180°E波导成型技术研究
短句来源
     The X-ray K absorption spectra of iron in metglas Fe_(80)B_(20) and Fe_(80)Si_6B_(14) are measured, using the rotating anode X-ray generator and the EXAFS spectrometer with bend crystal.
     用转靶X射线源及晶EXAFS谱仪测定了Fe_(80)B_(20)及Fe_(80)Si_6B_(14)金属玻璃中铁的X射线K吸收谱。
短句来源
     The occurrence ratio of the middle eth- moidal artery was (36.7±8.8)%,and the middle ethmoidal artery originated from the third segment of the intraorbital ophthalmic artery in (54.5±9.1)%,the ophthalmic artery bend in (27.3±8.1)% and the second segment of the in- traorbital ophthalmic artery in (18.2±7.0)%.
     筛中动脉出现率为(36.7±8.8)%,起自O_3段(54.5±9.1)%、眼动脉(27.3±8.1)%和O_2段(18.2±7.0)%。
短句来源
更多       
  弯管
     Design of the Injection Mold for the 45°Plastic Bend Tube
     45°塑料弯管注射模设计
短句来源
     Initial pressures of combustible gas used in the experiments were 33.3, 26.7, 24.0, 16.0, 10.7 kPa, respectively. The curvature radii of rectangular bend were 100 mm and 50 mm.
     实验所采用的预混气体初始压力为33. 3、26. 7、24. 0、16. 0、10. 7kPa, 90°矩形弯管的曲率半径分别为100、50mm。
短句来源
     Large eddy simulation of turbulent flow in a square duct with 180° bend
     180°方形弯管中湍流流动的大涡模拟
短句来源
     Experimental Study on the Propagation Characteristics of Unsteady Gaseous Detonation through 90° Round Bend
     可燃气体非稳定爆轰波通过90°圆弯管传播特性的实验研究
短句来源
     The Calculation of Exhaust Pipe Bend on Nan Fang125 and Nan Ya125 Motorcycle Muffler
     南方125和南雅125消声器排气弯管的展开长计算
短句来源
更多       
  弯头
     Analysis on Cracks of Elbow Bend in 1 Economizer of Type DG 220/9.8-4 Boiler
     DG220/9.8-4型锅炉~#1省煤器弯头裂缝分析
短句来源
     Analysis on the Explosion of a 12Cr1MoV Steam Connecting Pipe Bend in 1000 t/h Once Through Boiler
     1000t/h直流锅炉12Cr1MoV钢导汽管弯头爆破分析
短句来源
     The injection of the corrosion inhibitor KQ-1 at the inlet of the water cooler of waste oil stripper and furfural water cooler has controlled the corrosion of the tube bend by raising the pH value from 4.5 to 6.2~8.0 and lowing the Fe 2+ from 38.8 mg/L for 3.4~7.0 mg/L.
     经在废油汽提增强水冷器和糠醛水冷器的出口注入KQ - 1缓蚀阻焦剂后 ,使排出液的pH值由 4 .5提高到了 6 .2~ 8.0 ,Fe2 + 由 38.8mg/L降低到 3.4~ 7.0mg/L ,使炉管弯头腐蚀得到抑制。
短句来源
     The deformation and the stress of the convection superheater are calculated from the structure analysis, and the result indicates that the outlet pipe bend of the convection superheater is the most possible failure and the pipe clamp has great affect on pipe expansion.
     对某火电厂#7炉对流过热器进行了结构仿真分析,得到了其热态位移和应力值,结果表明对流过热器出口段外侧管弯头为应力最大区,承重管夹的安装对整个结构膨胀影响较大。
短句来源
     Analysis on Burst Reason of a Bend of E-103 Outlet Pipe in Petrolatum Oil Hydrogenation Unit
     蜡油加氢装置E-103出口弯头破裂原因分析
短句来源
更多       

 

查询“bend”译词为其他词的双语例句

 

查询“bend”译词为用户自定义的双语例句

    我想查看译文中含有:的双语例句
例句
为了更好的帮助您理解掌握查询词或其译词在地道英语中的实际用法,我们为您准备了出自英文原文的大量英语例句,供您参考。
  bend
Some of them including the existence problem, minimax problem, net representation, bend minimization, area minimization, placement problem, routing problem, etc.
      
This paper provides the complete proof of the fact that any planar cubic graph is at most single-bend embeddable except for the tetrahedron.
      
AnO(n) amortized time algorithm for drawing an at most single-bend embedding of a cubic graph is also presented, wheren is the number of vertices of the graph.
      
Furthermore, it is proved that the minimum of the total number of bends in an at most single-bend embedding of a cubic graph of ordern is less than or equal to 0.5n+1.
      
In a discharge passage with a guide blade discharge circulation and secondary flow because of bend pipe, the flow in a 1-channel discharge passage of an axial flow pump is a complicated spiral flow.
      
更多          


点击这里查询相关文摘
图标索引 相关查询

 


 
CNKI小工具
在英文学术搜索中查有关bend的内容
在知识搜索中查有关bend的内容
在数字搜索中查有关bend的内容
在概念知识元中查有关bend的内容
在学术趋势中查有关bend的内容
 
 

CNKI主页设CNKI翻译助手为主页 | 收藏CNKI翻译助手 | 广告服务 | 英文学术搜索
版权图标  2008 CNKI-中国知网
京ICP证040431号 互联网出版许可证 新出网证(京)字008号
北京市公安局海淀分局 备案号:110 1081725
版权图标 2008中国知网(cnki) 中国学术期刊(光盘版)电子杂志社