助手标题  
全文文献 工具书 数字 学术定义 翻译助手 学术趋势 更多
查询帮助
意见反馈
   fillets 的翻译结果: 查询用时:0.499秒
图标索引 在分类学科中查询
所有学科
金属学及金属工艺
汽车工业
动力工程
工业通用技术及设备
更多类别查询


图标索引 历史查询
tax preference
library
interstitial thermot
bidirectional advanc
double discharge por
valence shell
adhesive fillets
dynamic equilibrium
 
数字出版物超市-中国知网

      fillets
相关语句
  圆角
     Roll-Strengthening of Crankshaft Fillets in NJD433A Diesel Engines
     NJD433A型柴油机曲轴圆角滚压试验
短句来源
     Applying the deep rolling depression technology to engine crankshaft fillets can greatly improve their fatigue strength.
     发动机曲轴圆角采用深滚压工艺可大幅提高曲轴疲劳强度。
短句来源
     Influential Factors on the Stress of Crankshaft Fillets
     曲轴圆角应力的影响因素
短句来源
     The variation trend of stress in crankshaft fillets when changing the structural dimension of a crankshaft has been studied by means of threedimension finite element calculation method, citing the CA6102 petrol engine crankshaft as an example, the comparative analysis between calculated and experimented results is given.
     用三维有限元计算曲轴应力的方法,研究了曲轴结构尺寸改变时在轴颈过渡圆角处的应力变化规律,并以CA6102型汽油机曲轴为例,进行了计算结果与试验结果的对比分析。
短句来源
     The crack growth model of exponent b =1 is recommended for smaller crack at fillets.
     推荐对于圆角的较小裂纹扩展采用b=1的裂纹扩展模型。
短句来源
更多       
  “fillets”译为未确定词的双语例句
     The addition of heavy metals, such as Bi, Sn, Pb, Cd, Tl, Cu, Ni and Ga causes serious intercrystalline corrosion in the fillets.
     少量重金属Bi,Sn,Pb,Cd,Tl,Cu,Ni及Ga等引起合金强烈的晶间腐蚀。
短句来源
     When the fillets of thawing fish and fresh fish were immersed in 18~19% of brine and 24~25.5% of brine respectively for 2~3min, salt content of production was about 3%, and when immersed in rice vinegar about 10s, pH value of production was less than 5, and the texture of fillets became soft and palatable.
     解冻鱼鱼片用 18~ 19%盐水浸渍 ,新鲜鱼鱼片用 2 4~ 2 5 .5 %盐水浸渍 ,2~ 3min ,制品盐份含量为 3%左右 ; 米醋大约浸渍 10s ,产品pH <5 ,鱼片质地柔软适口 ;
短句来源
     Material of explosion cladding plates tubesheet for the first~fifth effect re-boiler were 16Mn(Ⅲ forging)+90Cu10Ni,material of tubes were 90Cu10Ni(high flux tube,UOP offer),SMAW was applied to tube-tubesheet fillets,the joints were required to 100% radiograph.
     一效~五效换热器管板为爆炸复合板16MnⅢ+90Cu10Ni,管子为90Cu10Ni高通量管,管子管板焊接采用SMAW,结构为传统的端面焊接,管头伸出3 mm,管子管板接头要求100%RT探伤。
短句来源
     Using the R1 and R2,the radius of the transition fillets as two design parameters,the stress distribution were analyzed in the thread connection part in different R1 and R2 under certain conditions.
     在设计中以螺纹连接处两个过渡圆角半径R1、R2为设计变量,分析了在一定条件下不同尺寸的R1、R2所对应的螺纹连接处应力分布情况。
短句来源
     The results showed that weight rate of fillets in the whole fish was 27~33%.
     结果表明 ,鱼片占整条鱼的重量比为 2 7~ 33% ;
短句来源
更多       
  相似匹配句对
     Optimum Design of Crankshaft Fillets
     曲轴圆角的优化设计
短句来源
     Induction Hardening of Journal Fillets of Crankshaft
     曲轴圆角感应加热淬火技术
短句来源
查询“fillets”译词为用户自定义的双语例句

    我想查看译文中含有:的双语例句
例句
为了更好的帮助您理解掌握查询词或其译词在地道英语中的实际用法,我们为您准备了出自英文原文的大量英语例句,供您参考。
  fillets
In storage on ice, fillets of fish fed the diets high in α-tocopheryl acetate exhibited significantly lower (P>amp;lt;0.05) levels of oxidation.
例句来源      
These results suggested that increased dietary α-tocopheryl acetate could increase its flesh deposition, increase the activity of SOD and prevent lipid peroxidation of Sparus macrocephalus fillets in retail storage on ice.
例句来源      
The peak stresses appeared at the slot corners inside the adhesive fillets and at the horizontal and vertical plate outer fibres corresponding to the two slot free ends.
例句来源      
High stress concentrations were observed around the adhesive free ends and the peak adhesive stresses occurred inside the adhesive fillets.
例句来源      
The steady state heat transfer analysis showed that the temperature distribution through the joint members was non-uniform and high heat fluxes occurred inside the adhesive fillets at the adhesive free ends.
例句来源      
更多          



         The influence of 28 element additions on the melting point, flowability, corrosion resistance and fillet bending ability of A1-Si type filler metal has been investigated. Among these systems, filler 6M, i. e.A1-Si(13.0)-Be(0.4—0.8)-Sr (0.03—0.06)-La (0.03—0.06) is regarded as the optimum. The erosion mechanism of molten filler metal on base metal has been also studied. In addition to the influences of brazing temperature and the composition of filler metal, the rate of solution of base metal into molten fil...
            考察了28种有代表性的微量元素对Al-Si共晶钎料的熔点,流动性,抗腐蚀性以及钎缝折弯能力的影响。其中以Al-Si(13.0)-Be(0.4—0.8)-Sr(0.03—0.06)-La(0.03—0.06)钎料体系最为理想。本文还探讨了钎料对母材熔蚀的机理,分析了钎焊温度和钎料组成的影响,此外,还认为与母材熔入钎料的速度以及液态钎料沿钎缝的流布速度有关,此二速度的比值愈大,熔蚀愈烈。最后,在钎焊温度下对钎缝进行了不同时间的保温处理,发现钎缝的强度和抗弯能力仅有不大程度的改善。
文摘来源
         This paper deals with histological changes in the muscle of some commercial fishes during freezing and frozen storage.The experiments were carried out under various conditions, namely, freezing at different temperatures and rates, frozen storage at different temperatures, freezing and frozen storage by using fishes iced for various periods prior to freezing and fishes with different oil contents subjecting to tests. The results obtained are as follows: 1. When fish is frozen at low temperature, the water in...
            几种经济鱼类在冷冻冷藏中组织学变化的研究,得到了以下结果: 1.鱼肉在低温下冷冻时,肌肉纤维的水发生内冻结,冰晶体小,可以较好地保持其组织结构的完整。考虑到冻鱼在冷藏中仍继续变化,采用-25°——35℃温度冷冻鱼品是适宜的。 2.快速冷冻可使鱼肉组织不受冰晶体的破坏。梭鱼片在104分钟以内的不同速度 (鱼肉中心温度由0°至-5℃所需的时间)冷冻的结果均较好,其中以27、40、72分钟者更能令人满意。试验表明,鱼肉的冷冻速度不是愈快愈好。鲵鱼片用60—1,500分钟八种速度单向冷冻时,除720、1,380和1,500分钟的较差外,其他速度冷冻的肌肉组织相似。 3.冰藏1、7和13天的小黄鱼在相同温度下冷冻后,肌肉组织结构有差异,冰藏了天以上者差异特别明显。三种冰藏期的冻鱼以相同温度冷藏时,冰藏13天后的冻鱼,其保藏期较前二种冰藏期的短2—3个月。 4.冻鱼的冷藏温度十分重要。用相同的和低于冷冻时的温度保藏鱼类,可以较好地保持肌肉组织不受破坏。在-18℃冷冻并冷藏和-10℃冷冻后、-18℃冷藏的大黄鱼的保藏期,较之在-29℃(鼓风)冷冻后分别在-18°和-10℃冷藏的延长1—2个月。 5.不同含脂量的鱼(小黄鱼、...
文摘来源
         A study has been made of the effects of twenty metal additions in small amount on the corrosion resistance in 3% NaCl solution of Al-Zn euteetic fillets on pure aluminum as well as on LY12 (2024) base metals as determined by weight loss and by metallographic technique. It is shown that corrosion resistance effectively increses with the addition of small amounts of alkaline earth and rare earth elements, such as Be, Mg, Sr and La. The addition of heavy metals, such as Bi, Sn, Pb, Cd, Tl, Cu, Ni and Ga ...
            用经典失重法和显微结构法研究了20个少量添加元素对纯铝及LY-12母材上Al-Zn钎料焊点抗腐蚀性能的影响。发现添加少量碱土金属或稀土金属能有效地提高焊点的抗腐蚀性。少量重金属Bi,Sn,Pb,Cd,Tl,Cu,Ni及Ga等引起合金强烈的晶间腐蚀。过渡金属及碱金属影响不大。
文摘来源
 
<< 更多相关文摘    
图标索引    相关查询:

 对查询结果不满意

 


 

 
CNKI小工具
在Springer中查有关的英文论文
在知识搜索中查有关fillets的内容
在数字搜索中查有关fillets的内容
在概念知识元中查有关fillets的内容
在学术趋势中查有关fillets 的内容
 
 


CNKI主页 设CNKI翻译助手为主页 | 收藏CNKI翻译助手 | 广告服务
版权  2008 CNKI-中国知网
京ICP证040431号 互联网出版许可证 新出网证(京)字008号
北京市公安局海淀分局 备案号:110 1081725
版权图标 2008中国知网(cnki) 中国学术期刊(光盘版)电子杂志社