fillets 圆角(37)   圆角     Comparison between Steel Shots and Glass Shots in Shot Peening of Crankshaft Fillets     用铸钢丸和玻璃丸对曲轴圆角喷丸强化的对比分析 短句来源     Induction Hardening of Journal Fillets of Crankshaft     曲轴圆角感应加热淬火技术 短句来源     Because the process supplyment affect the quality of piece forming greatly, here the influence of process supplyment fillets on piece forming is also analyzed, the suitable process plan are finally gained.     由于工艺补充对零件的成形质量影响很大，本文分析了工艺补充圆角对零件成形的影响，最终确定了合理的工艺方案。 短句来源     In this paper, an optimum design of transient fillets in the housing has been carried out by a program package-OPTSDP for optimal design of the shape using FEM, with rapid redesigning function.     本文利用具有局部区域快速重设计功能的有限元形状优化设计程序OPTSDP对轧钢机机架过度圆角进行了形状最优设计。 短句来源     Based on different theories and techniques for the reduction of stress concentration, and on the basis of forms of breech ring fillets in general use, over a dozen of fillet forms are proposed.     根据降低应力集中的理论和技术措施,在现有常用的炮尾闩室圆角的基础上,提出了十几种圆角形式。 短句来源 更多          “fillets”译为未确定词的双语例句     The addition of heavy metals, such as Bi, Sn, Pb, Cd, Tl, Cu, Ni and Ga causes serious intercrystalline corrosion in the fillets.     少量重金属Bi,Sn,Pb,Cd,Tl,Cu,Ni及Ga等引起合金强烈的晶间腐蚀。 短句来源     A-GTAW was applied to tube to tube-plate fillets.     管子管板角焊缝的焊接采用A—GTAW焊接方法。 短句来源     OPTIMAL DESIGN OF TANSIENT FILLETS IN THE MILL HOUSING     轧钢机机架圆角的形状优化设计 短句来源     Influence of Tempering Temperature on the Microstructure and Properties of the Hardening Journals Fillets Crankshafts     回火温度对曲轴圆角淬火后组织性能的影响 短句来源     The rational configurations of overlap regions and fillets are S-form and arc respectively.     接头搭接区域的合理形状为“S”形,而胶瘤的合理形状为圆弧形; 短句来源 更多        查询“fillets”译词为用户自定义的双语例句     我想查看译文中含有：的双语例句 为了更好的帮助您理解掌握查询词或其译词在地道英语中的实际用法，我们为您准备了出自英文原文的大量英语例句，供您参考。   fillets In storage on ice, fillets of fish fed the diets high in α-tocopheryl acetate exhibited significantly lower (P>amp;lt;0.05) levels of oxidation. 例句来源       These results suggested that increased dietary α-tocopheryl acetate could increase its flesh deposition, increase the activity of SOD and prevent lipid peroxidation of Sparus macrocephalus fillets in retail storage on ice. 例句来源       The peak stresses appeared at the slot corners inside the adhesive fillets and at the horizontal and vertical plate outer fibres corresponding to the two slot free ends. 例句来源       High stress concentrations were observed around the adhesive free ends and the peak adhesive stresses occurred inside the adhesive fillets. 例句来源       The steady state heat transfer analysis showed that the temperature distribution through the joint members was non-uniform and high heat fluxes occurred inside the adhesive fillets at the adhesive free ends. 例句来源       更多                    The influence of 28 element additions on the melting point, flowability, corrosion resistance and fillet bending ability of A1-Si type filler metal has been investigated. Among these systems, filler 6M, i. e.A1-Si(13.0)-Be(0.4—0.8)-Sr (0.03—0.06)-La (0.03—0.06) is regarded as the optimum. The erosion mechanism of molten filler metal on base metal has been also studied. In addition to the influences of brazing temperature and the composition of filler metal, the rate of solution of base metal into molten fil...             考察了28种有代表性的微量元素对Al-Si共晶钎料的熔点,流动性,抗腐蚀性以及钎缝折弯能力的影响。其中以Al-Si(13.0)-Be(0.4—0.8)-Sr(0.03—0.06)-La(0.03—0.06)钎料体系最为理想。本文还探讨了钎料对母材熔蚀的机理,分析了钎焊温度和钎料组成的影响,此外,还认为与母材熔入钎料的速度以及液态钎料沿钎缝的流布速度有关,此二速度的比值愈大,熔蚀愈烈。最后,在钎焊温度下对钎缝进行了不同时间的保温处理,发现钎缝的强度和抗弯能力仅有不大程度的改善。 文摘来源          A study has been made of the effects of twenty metal additions in small amount on the corrosion resistance in 3% NaCl solution of Al-Zn euteetic fillets on pure aluminum as well as on LY12 (2024) base metals as determined by weight loss and by metallographic technique. It is shown that corrosion resistance effectively increses with the addition of small amounts of alkaline earth and rare earth elements, such as Be, Mg, Sr and La. The addition of heavy metals, such as Bi, Sn, Pb, Cd, Tl, Cu, Ni and Ga ...             用经典失重法和显微结构法研究了20个少量添加元素对纯铝及LY-12母材上Al-Zn钎料焊点抗腐蚀性能的影响。发现添加少量碱土金属或稀土金属能有效地提高焊点的抗腐蚀性。少量重金属Bi,Sn,Pb,Cd,Tl,Cu,Ni及Ga等引起合金强烈的晶间腐蚀。过渡金属及碱金属影响不大。 文摘来源          It was shown from experimental results that excellent brazability of aluminiumalloy could be obtained with magnesium activator in vacuum brazing.It was thepurpose of the present study with the help of Auger electron spectroscopy and Scanningelectron microscopy surface analysis to research for variation of magnesium constituentand surface configuration of brazing filler metal layer on composite sheet specimens.At different temperature the concentrated evaporation of magnesium constituent atmelting temperatur...             试验证明,铝真空钎焊时,大都借助于镁才能获得优质接头。本文研究了复合板试样经不同温度的钎焊加热后,用俄歇能谱仪及扫描电镜分析钎料层中镁的变化及钎料层表面形态的变化,明确了镁在钎科熔化温度下能产生聚集性蒸发。这一现象对形成优质接头具有重要作用。此外,用附加镁块的方式,研究了不同镁蒸气浓度对钎料填充间隙能力的影响。结果表明,钎缝附近镁的浓度适量是获得优质钎缝的关键。浓度过大,钎料流失;浓度过小,钎料不漫流,均形不成焊角。通过环状的T 型接头试验,由于结构开敞程度的不同(如内外焊角),镁蒸气的作用效果亦不同,调整附加镁量或加罩可获得优质接头。在上述试验的基础上,应用试验所得结果及工艺措施,成功地钎焊了具有空间曲面T 型接头的叶轮。 文摘来源   << 更多相关文摘         相关查询: pollock fillets herring fillets adhesive fillets frozen fillets mackerel fillets globefish fillets tilapia fillets journal fillets dovetailed fillets fish fillets flavor fish fillets crankshaft fillets stress  对查询结果不满意

CNKI小工具 在Springer中查有关的英文论文 在知识搜索中查有关fillets的内容 在数字搜索中查有关fillets的内容 在概念知识元中查有关fillets的内容 在学术趋势中查有关fillets 的内容

CNKI主页 |  设CNKI翻译助手为主页 | 收藏CNKI翻译助手 | 广告服务

2008 CNKI－中国知网

京ICP证040431号 互联网出版许可证 新出网证(京)字008号 北京市公安局海淀分局 备案号：110 1081725  2008中国知网(cnki) 中国学术期刊(光盘版)电子杂志社