|
|
|
|
|  | | 为了更好的帮助您理解掌握查询词或其译词在地道英语中的实际用法,我们为您准备了出自英文原文的大量英语例句,供您参考。 | |
In storage on ice, fillets of fish fed the diets high in α-tocopheryl acetate exhibited significantly lower (P>amp;lt;0.05) levels of oxidation.
|
| 例句来源 | |
These results suggested that increased dietary α-tocopheryl acetate could increase its flesh deposition, increase the activity of SOD and prevent lipid peroxidation of Sparus macrocephalus fillets in retail storage on ice.
|
| 例句来源 | |
The peak stresses appeared at the slot corners inside the adhesive fillets and at the horizontal and vertical plate outer fibres corresponding to the two slot free ends.
|
| 例句来源 | |
High stress concentrations were observed around the adhesive free ends and the peak adhesive stresses occurred inside the adhesive fillets.
|
| 例句来源 | |
The steady state heat transfer analysis showed that the temperature distribution through the joint members was non-uniform and high heat fluxes occurred inside the adhesive fillets at the adhesive free ends.
|
| 例句来源 | | 更多 |
|
|
|

| | Testing and analysis research on fillets of bathtub joint show that the durability design approach based on probabilistic fracture mechanics is applicable to fillets.The crack growth model of exponent b =1 is recommended for smaller crack at fillets. | | 通过对浴缸式接头圆角耐久性试验及分析研究,证明基于概率断裂力学的耐久性设计方法对圆角也是适用的。推荐对于圆角的较小裂纹扩展采用b=1的裂纹扩展模型。 | | 文摘来源 | | According to the tapered section assumption,this paper presents a method for calculating the local stress of a hollow cylindrical shaft with fillets under tension.The influence of fillets radius,shaft radius and fillets depth on the local stress is discussed.The relations of the local stress with the shaft radius ratio and the elasto\|plastic interface are given finally. | | 根据锥形截面假设 ,探讨了一种计算具有圆角的空心圆轴拉伸时局部应力的方法 .文中详细讨论了圆角的半径、圆轴的半径和圆角的深度系数对应力集中的影响 ,并推导出圆轴内、外半径和弹塑性交界面与弹塑性局部应力的关系 | | 文摘来源 | | Appling the SAP91 software developed by Algor, the paper computed the stress concentration factors for shoulder fillets in the stepped shafts in tension. In the main, the computing results are identical with the results of the photoelastic tests made by above scholars. Our results show that the shaft's fillet radius can remarkably affect the stress concentration effect, and that the different loading modes or shaft's lengths can also result in the different factors when other parameters are fixed. | | 应用 Algor公司的 SAP91软件计算了受拉阶梯轴倒角处的应力集中系数 ,理论计算结果与前人的光弹实验结论比较吻合 .研究表明 :轴的倒角半径对应力集中效应有显著影响 ;当其他参数不变时 ,改变轴端力的作用方式或轴段的长度 ,均会产生不尽相同的应力集中系数 | | 文摘来源 | |   | | << 更多相关文摘 |
|
相关查询: | |
对查询结果不满意
|
|
|
|