dissipation factor      损耗因子(20) 耗散因子(4) 损耗因数(41) 介质损耗因数(25) 耗散系数(0) 损耗因素(0) 耗散因数(0)   损耗因子      With the addition of 5wt% Bi2O3, the dissipation factor of the sample showed the lowest value (<10-3).      当Bi2O3添加量(质量分数)达5%时样品的介质损耗因子最低(<10-3); 短句来源      With the addition of 4%(mass factor) CeO_2,the dissipation factor of the sample shows the lowest value(about 0.2%).      当CeO2添加量达4%(质量分数)时样品的介质损耗因子最低(≈0.2%)。 短句来源      The relationship between stiffness, damping coefficient dissipation factor and frequency, and acting force is acquired.      获得测试对象的刚度系数、阻尼系数以及损耗因子等动力学特征参数值与使用频率、作用力幅值以及合金厚度之间的对应关系。 短句来源      The dissipation factor of the films was about 0.5 at zero bias.      零偏压下的损耗因子为0.5。 短句来源      The typical measured dielectric constant, dissipation factor, tunability and resistivity of Ba0.6Sr0.4TiO3 thin films doped with 5% Mg were 380, 0.013, 17.5% and 1.0 ×1012Ω2·cm, respectively.      当Mg掺杂量分数为5％时,其介电常数为380,损耗因子为0.013,电容变化率为17.5％,电阻率为1.0×10~12Ω. cm. 短句来源 更多          耗散因子      By the relationships between the dissipation factor and equivalent circuit parameters, the energy losses of the PZT ceramics are computed.      在压电机敏模块的载荷响应特性实验中,测量了压电陶瓷的各等效电路参数的载荷响应特性,并根据各等效电路参数与耗散因子之间的关系,计算了压电陶瓷耗散因子的载荷响应特性。 短句来源      In this paper, the nonlinear partial equation with dissipation term-Burger'sequation is adopted as model equation. Linear and nonlinear computational stabilities of some three (time) level schemes which are used in numerical weather prediction are analysed, particularly, the effect of computational initial value, length of time step and the dissipation factor are discussed.      本文以带耗散项的非线性方程——Burger方程为模型,用截谱形式的差分解代入相应的差分方程,分析了数值天气预报中常用的一类三时间层差分格式的计算稳定性问题,特别讨论了计算初值、时间步长和耗散因子对计算稳定性的影响. 短句来源      In this paper, the nonlinear partial equation with dissipation term-Burgers equation is adopted as model equation The computational stability of two kinds of general three time level schemes and two time level schemes which are used in numerical weather prediction is analyzed, particularly, the effect of computational initial value, the length of time step and the dissipation factor are discussed. A new method for judging the computational stability is given.      以最简申的非线性扩散波动方程Burgers方程为模型．着重分析了数值天气预报中常用的二类较普遍的三时间层和二时间层差分格式的计算稳定性问题，特别指出了计算初值、时间步长和耗散因子对计算稳定性的影响。 短句来源      With this kind of electrolyte, by using F. B.P, the dissipation factor and the measuring current as three criteria for the measurement, and by choosing appropriate measuring voltage and etching current, the experimental results can be achieved quickly, reproducibly and reliably.      综合利用平带电位值(F.B.P)、耗散因子和测量电流等3个测量判据,合理选取测量电压、腐蚀电流等测量参数,获得了速度快、重复性好和数据准确可靠的测试效果. 短句来源   损耗因数      The results show that there is excellent compatibility between PTFE and FEP,and that,after the modification by blending,the peeling strength of CCLs increases from 1.8kN/m to 2.26kN/m,and the flexural strength increases from 100MPa to 134MPa,while the dielectric dissipation factor decreases from 8×10~(-4) to 7×10~(-4).      结果表明,聚四氟乙烯与聚全氟乙丙烯相容性能好,共混改性后覆铜板剥离强度从1.8 kN/m提高到2.26 kN/m,抗弯强度从100MPa提高到134MPa,而介质损耗因数从8×10-4降到7×10-4. 短句来源      The suitable mass fraction of SFR100 was 4% in the flame retardant ABS with 14% TBAB. The OI and impact strength increased to 31.8% and 15.1 kJ/m2 from 29.2% and 11.2 kJ/m2 respectively. Furthermore, the electrical strength increased and the dielectric constant and the dielectric dissipation factor decreased.      在TBAB用量为 14 % (质量分数 ,下同 )的阻燃ABS中 ,SFR10 0的适宜用量为4% ,此时氧指数和冲击强度分别从 2 9 2 %和 11 2kJ/m2 提高到 3 1 8%和 15 1kJ/m2 ,且电气强度提高 ,介电常数和介电损耗因数下降。 短句来源      This paper introduces two types of fixed non-contacting electrode systema which can be used to measure relative permittivity and dissipation factor of polymeric thin films conveniently and accurately at frequencies of 50 Hz, 1kHz and 1MHz.      本文介绍两种固定式不接触电极,它可以方便而准确地测量很薄的有机薄膜在50Hz、1kHz和1MHz下的相对电容率和损耗因数,并提出了相应的测试技术。 短句来源      By studying the filling which can adjust dielectric constant, the equality of dielectric thickness andcopper board preparation technics , have developped high frequency circuit using copper-clad copper base boardwhose dielectric constant is 6.15 and dissipation factor is 0.0015.      通过对可调节介电常数的填充材料、介质厚度均匀性、铜板处理工艺的研究与选择,研制开发出了介电常数为6.15、介质损耗因数为0.0015的铜基高频电路用覆铜板。 短句来源      MEASUREMENT AND ANALYSIS OF DIELECTRIC DISSIPATION FACTOR IN 500kV CURRENT TRANSFORMER      500kV 电流互感器介质损耗因数的测量与分析 短句来源 更多          介质损耗因数      The results show that there is excellent compatibility between PTFE and FEP,and that,after the modification by blending,the peeling strength of CCLs increases from 1.8kN/m to 2.26kN/m,and the flexural strength increases from 100MPa to 134MPa,while the dielectric dissipation factor decreases from 8×10~(-4) to 7×10~(-4).      结果表明,聚四氟乙烯与聚全氟乙丙烯相容性能好,共混改性后覆铜板剥离强度从1.8 kN/m提高到2.26 kN/m,抗弯强度从100MPa提高到134MPa,而介质损耗因数从8×10-4降到7×10-4. 短句来源      By studying the filling which can adjust dielectric constant, the equality of dielectric thickness andcopper board preparation technics , have developped high frequency circuit using copper-clad copper base boardwhose dielectric constant is 6.15 and dissipation factor is 0.0015.      通过对可调节介电常数的填充材料、介质厚度均匀性、铜板处理工艺的研究与选择,研制开发出了介电常数为6.15、介质损耗因数为0.0015的铜基高频电路用覆铜板。 短句来源      MEASUREMENT AND ANALYSIS OF DIELECTRIC DISSIPATION FACTOR IN 500kV CURRENT TRANSFORMER      500kV 电流互感器介质损耗因数的测量与分析 短句来源      The results show that the corona-resistant lifetime of PI with nano-TiO 2 loading of15%is about40timeslonger than pure PI film at the electrical stress of12kV/mm. But the mass resistivity and the breakdown strength of nano-TiO 2 filled polyimide film are deteriorated with nano-TiO 2 loading,and the relative dielectric constant and the dissipation factor are increased with nano-TiO 2 loading.      结果表明,随着纳米TiO2含量的增加,聚酰亚胺/纳米TiO2复合材料的体积电阻率和电气强度出现不同程度的劣化,并造成了介电常数和介质损耗因数的增加,但是材料的耐电晕性能显著增强,在12MV/m的电场强度下,纳米TiO2含量15%的PI薄膜的耐电晕寿命为纯PI薄膜的40多倍。 短句来源      The aplications of low dielectric constant and low dissipation factor substrate material in PCB production are widering,Manufacturing technology researsh of microwave PCB are importance more and more.      随着低介电常数性与低介质损耗因数的基材在PCB加工中应用趋于广泛,研究高频基板工艺技术越来越重要。 短句来源 更多            查询“dissipation factor”译词为其他词的双语例句 耗散系数 损耗因素 耗散因数   查询“dissipation factor”译词为用户自定义的双语例句     我想查看译文中含有：的双语例句 为了更好的帮助您理解掌握查询词或其译词在地道英语中的实际用法，我们为您准备了出自英文原文的大量英语例句，供您参考。   dissipation factor Extending upon previous studies of statistical fractal automata, a redistribution law is introduced which incorporates two model parameters: a dissipation factor and a stress transfer ratio. 例句来源       The relative dielectric constant and the dissipation factor of the film measured at 1 kHz were about 750 and 4.3%, respectively. 例句来源       A novel double layer structure has been developed to reduce the pinholes and improve the electrical properties, such as higher dielectric constant, lower dissipation factor, higher breakdown fields and low leakage currents. 例句来源       We determine the optimal displacement of the small mirror from the quasi-focal area of the large mirror, ensuring the minimum main-lobe width in terms of a given level and a given dissipation factor. 例句来源       The typical measured small signal dielectric constant and dissipation factor at a frequency of 100 kHz were 299 and 0.065, respectively, for a thin film with 230 nm thickness annealed at 600°C for 2 h. 例句来源       更多           点击这里查询相关文摘     相关查询: dielectric dissipation factor energy dissipation factor dissipation factor measurement dissipation factor testing insulation dissipation factor dissipation heat compensator dissipation factor factor insulation dielectric dissipation factor measurement test for permittivity and dissipation factor 1－factor factor v  对查询结果不满意

CNKI小工具 在Springer中查有关的英文论文 在知识搜索中查有关dissipation factor的内容 在数字搜索中查有关dissipation factor的内容 在概念知识元中查有关dissipation factor的内容 在学术趋势中查有关dissipation factor 的内容

CNKI主页 |  设CNKI翻译助手为主页 | 收藏CNKI翻译助手 | 广告服务

2008 CNKI－中国知网

京ICP证040431号 互联网出版许可证 新出网证(京)字008号 北京市公安局海淀分局 备案号：110 1081725  2008中国知网(cnki) 中国学术期刊(光盘版)电子杂志社