|
|
|
|
|  | | 为了更好的帮助您理解掌握查询词或其译词在地道英语中的实际用法,我们为您准备了出自英文原文的大量英语例句,供您参考。 | |
In this work we demonstrate that alkaline blend polymer electrolyte can be tailored with a blend technique to achieve specific characteristic properties for battery applications.
|
| 例句来源 | |
The ionic transport properties for the blend polymer electrolytes were measured using Hittorf's method.
|
| 例句来源 | |
The characteristic properties of alkaline PVA/TEAC blend polymer electrolytes were examined using DSC, TGA, XRD, SEM, EA, stress-strain tests and AC impedance spectroscopy.
|
| 例句来源 | |
The ionic conductivity of the alkaline PVA/TEAC blend polymer electrolyte was found to be of the order of 10-2?S?cm-1 at ambient temperature when the blend ratio of PVA:TEAC varied from 1:0.2 to 1:2.
|
| 例句来源 | |
Tetraethyl ammonium chloride (TEAC) was added to PVA polymer matrix to form an alkaline blend polymer electrolyte exhibiting excellent ionic transport and mechanical properties.
|
| 例句来源 | | 更多 |
|
|
|

| | The differential miscibility of three blend polymer systems(PAN/PVC,PAN/CA,PAN/ PS)was studied in this paper. Blend UF membranes were prepared from corresponding polymers. The effect of miscibility of blend membrane on the membrane performances was analyzed. The results show that the flux of PAN/PS UF membrane which prepared from part miscibile polymer increased largely in comparison with the other two blend UF membranes. | | 研究了三种共混聚合物体系(PAN/PVC,PAN/CA,PAN/PS)的不同溶混特性。分别制成相应的共混超滤膜。分析了共混膜的溶混程度变化对膜性能的影响。结果表明,由部分溶混的共混物制成的PAN/PS超滤膜的水通量有较大幅度地提高。 | | 文摘来源 | | The micro-porous membrane was prepared from PVDF/PS blend polymer by L-S phase inversion method.The effects of polymer concentration,PVDF/PS ratio,solvents,additive,temperature and composition of coagulation bath,solvent volatilization time and heat treatment temperature on the membrane performance were studied.The results under the experimental conditions show that:(1) DMF/DMAc blend solvent was beneficial to improve the pore size and porosity of the membranes;(2) the pore size and ... | | 将聚偏氟乙烯和聚砜共混,通过溶胶-凝胶相转化法研制高孔隙率微孔膜.考察了聚合物浓度、PVDF/PS配比、溶剂种类和组成、添加剂浓度、凝胶浴温度和组成、溶剂挥发时间和热处理温度对膜孔径和孔隙率的影响.实验发现:使用DMF/DMAc混合溶剂可提高膜孔径和孔隙率;随LiCl含量的增加,膜孔径和孔隙率逐步增加;凝胶浴温度对膜的水通量没有太大的影响,但凝胶浴组成对膜性能有很大的影响;延长溶剂挥发时间,导致平均孔径减小.选择适当的膜液组成,可制得孔径为0.2~1.0μm,孔隙率达到90%以上的PVDF/PS共混微孔膜,而且共混膜的孔隙率比单组分PVDF膜有大幅度的提高.说明共混化是一种改善PVDF膜性能的有效方法,具有极好的实用开发价值. | | 文摘来源 | |   |
|
相关查询: | |
对查询结果不满意
|
|
|
|