助手标题  
全文文献 工具书 数字 学术定义 翻译助手 学术趋势 更多
查询帮助
意见反馈
   optimum process 的翻译结果: 查询用时:0.017秒
图标索引 在分类学科中查询
所有学科
有机化工
轻工业手工业
一般化学工业
无机化工
人口学与计划生育
林业
更多类别查询

图标索引 历史查询
 

optimum process     
相关语句
  最佳工艺
     The optimum process conditions were obtained as follows: 30 g/L of NiSO4 · 6H2O,110 g/L of acetic acid,10 g/L of sodium hypophosphite,4 g/L of accelerator,pH 10,temperature of 45 °C.
     得到了泡沫基体上化学镀镍最佳工艺条件:30g/LNiSO4·6H2O,110g/L醋酸,10g/L次磷酸钠,4g/L加速剂,pH10,温度45°C。
短句来源
     The optimum process conditions were determined by series of experiments, i.e., I/KI mass ratio of 1.5~1.8, Iodine concentration of 210 g/L, 70~80℃ and 80 min for Iodine sorption;
     碘吸附过程的最佳工艺条件为 :I/KI质量比 1.5~ 1.8,碘浓度 2 10 g/L,温度 70~ 80℃ ,时间 80 min;
短句来源
     The removal rate of COD in the catalytic oxidation effluent is 82% when the optimum process conditions are as follows:catalyst mass concentration 0.5g/L,H_2O_2 mass concentration 2 400mg/L,no FeSO_4,reaction time 60min and system pH 3?
     负载活性炭催化剂催化氧化的最佳工艺条件:催化剂质量浓度为0.5g/L,H2O2质量浓度为2400mg/L,不投加FeSO4,反应时间为60min,体系pH为3~4,COD去除率达82%。
短句来源
     The optimum process conditions are obtained:n(formaldehyde)/n(naphthalene)=088-090,reaction temperature (110±5) ℃,reaction time 3 h and the amount of catalyst 1%(w) of naphthalene.
     确立了n(甲醛)/n(萘)=0 88~0 90,反应温度(110±5)℃,反应时间3h,催化剂MA用量为萘质量的1%的最佳工艺条件。
短句来源
     The removal rate of CODCr can reach 66.96% when the optimum process conditions are determined as follows: pH value=7,the amount of FeSO4 at 4g/L and H2O2 at 1.13%(V/V) and dispensing time at 45 minutes.
     实验确定了最佳工艺条件:pH=7,FeSO4投加量4 g/L,H2O2投加量为1.13%(V/V),搅拌时间15 min,此时CODCr去除率达到66.96%。
短句来源
更多       
  优化工艺
     The results of 40 t BOF-LF-CC production showed that with using optimum process the total oxygen content in steel decreased by 2×10~(6),to 15.2×10~(-6),and the amount of inclusion in steel decreased obviously.
     40 t BOF-LF-CC生产结果表明,采用优化工艺后,钢中全氧量降低2×10-6,达到15.2×10-6,钢中夹杂物也显著减少。
短句来源
     Study of PSSWS-LDD MOSFET Optimum Process Conditions for VLSI
     应用于VLSI的PSSWS-LDD MOSFET优化工艺研究
短句来源
     STUDY ON THE OPTIMUM PROCESS FOR PREPARING MAGNETIC POWDER OF Fe_4N
     制备Fe_4N磁粉的优化工艺研究
短句来源
     Optimum process with orthogonal design,control PET carboxyl end group value
     正交设计优化工艺控制PET端羧基值
短句来源
     The influential factors of synthesizing 2-ethyl -4-ethoxy-6-hydroxypyrimidine were investigated by uniform test design, the one optimum process conditions were obtained by regression analysis, followed as :molar ratio of 2-ethyl-4,6-dihydroxypyrimidine to diethylsulphate 1:1.5;
     采用均匀实验设计考察了影响2-乙基-4-乙氧基-6-羟基嘧啶收率的因素,然后通过回归分析得出了它的一种优化工艺条件:物料配比n_(2-乙基-1.6-二胫基嘧啶):n_(硫酸二乙酯)=1:1.5;
短句来源
更多       
  优化过程
     The optimum process parameters are as following: forming at a pressure of 30 t,sintering at 920(°C) for 8 h,40 t re-pressing and 150(°C)×0.5 h anneal. The Ag/SnO_2-La_2O_3-Bi_2O_3 contact material with better electrical behavior than that of Ag/CdO can be obtained.
     选择优化过程参数如下:30 t成形,920°C×8 h烧结,40 t复压,150°C×0.5 h去应力退火,所得的Ag/SnO2-La2O3-B i2O3触头材料电性能优于Ag/CdO。
短句来源
     PROTEIN OPTIMUM PROCESS IN NUTRITION MEAL
     营养膳食中蛋白质优化过程
短句来源
     The optimum design on 2# coal bunker of first stoping area in Xingdong Mine Shaft and reinforcement calculating optimum process are introduced. 
     介绍了邢东矿井首采区2#煤仓优化设计及配筋的计算优化过程
短句来源
     In order to improve the efficiency of the multi-point optimization problem, the parallel calculation basing on MPI is applied. Different CPU of the web is allocated to compute the flow field corresponded with the every design point, the parameters are transferred to the major CPU in which the optimum process is run.
     对于多目标优化设计,采用基于MPI平台的并行计算策略,针对各个不同的设计点,分别分配不同的计算机CPU进行流场计算,然后将计算所得的参数传递给主机,由主机进行优化过程的计算,提高了优化设计效率。
短句来源
     In this paper, a mathemedical model for the optimum design of this construction is built up by means of dynamic programming, and the objective function of optimization and the constraints that must be observed in the optimum process are also given.
     本文用动态规划方法建立了这种结构优化设计的数学模型,并给出了优化的目标函数及在优化过程中需要遵守的约束条件。
短句来源
更多       
  最优工艺
     but with the increase of material ratio, the yield was gradually decreasing and up to its maximum on the condition that material ratio was 1:1.1. Based on single factor experiment, it was confirmed that by orthogonal experiment the optimum process condition was 90min, 660W, 1:1.0 and the optimum process experiment was characteristic of reproducibility.
     而随着原料比的增大,其收率逐步下降,在原料比1:1.1时,其收率达到最大值。 基于单因素试验,再通过正交试验确定其最优工艺条件为反应时间90min、微波功率660W、原料比1:1.0,且最优工艺试验具有可再现性。
短句来源
     The optimum process conditions were found. Thus,reacting at 45 ℃ for 3~4 h with n (TAB)∶ n (EAPH)=(1.52~1.55)∶1,total yield of AP was 89%(by weight) and w (C_3H_9NO)=98.6% (pherchloric acid titration method).
     考察了物质的量比对反应的影响,获得了最优工艺条件:n(硼氢化四甲基铵)∶n(L 2 氨基丙酸乙酯盐酸盐)=(1 52~1 55)∶1,45℃反应3~4h,AP收率89%。 w(C3H9NO)=98 6%(高氯酸滴定法测定)。
短句来源
     The results showed that the optimum process conditions were as follows:catechol∶isobulyric aldehyde∶catalyst∶dehydrating agent was 1 mol∶1.5 mol∶10 g∶250 mL; reaction temperature was reflux temperature; reaction time was about 4 h.
     其最优工艺条件是 :n(邻苯二酚 )∶n(异丁醛 )∶m(催化剂 )∶v(带水剂 )为 1mol∶1.5mol∶10g∶2 5 0ml,反应在回流温度下进行 ,反应时间约 4h ,收率可达 92 .6 %。
短句来源
     Under the optimum process conditions the conversion of CH4 is 82.7% and the yield of CH3OH is 70.5%.
     在最优工艺条件下甲烷转化率为82.7%,甲醇收率为70.5%。
短句来源
     The optimum process conditions were: temperature,350 ℃ ; space velocity,0.29 h-1;
     最优工艺条件:反应温度350℃、液态空速0.29 h-1、n(3,5-二甲基苯酚)/n(甲醇)/n(水)=1/2/1;
短句来源
更多       

 

查询“optimum process”译词为其他词的双语例句

 

查询“optimum process”译词为用户自定义的双语例句

    我想查看译文中含有:的双语例句
例句
为了更好的帮助您理解掌握查询词或其译词在地道英语中的实际用法,我们为您准备了出自英文原文的大量英语例句,供您参考。
  optimum process
In tubes made by the optimum process, minute fissures that form adjacent to some of the pressure points during twist testing occupy just 3 % of the bond-line length.
      
In the optimum process, temperatures were controlled to prevent meltback of the SS310 outer layer by the higher melting T-11 stream.
      
From the analysis of characteristic changes in the RAS spectra even small deviations from the optimum process (doping levels, composition, etc.) which would effect the performance of the final device can be detected.
      
From the analysis of characteristic changes in the RAS spectra even small deviations from the optimum process (doping levels, composition, etc.) which would effect the performance of the final device can be detected.
      
From the sensitivity values and the deviation of sheet resistance, the optimum process conditions minimizing the effects of straggle in process parameters are obtained.
      
更多          


点击这里查询相关文摘
图标索引 相关查询

 


 
CNKI小工具
在英文学术搜索中查有关optimum process的内容
在知识搜索中查有关optimum process的内容
在数字搜索中查有关optimum process的内容
在概念知识元中查有关optimum process的内容
在学术趋势中查有关optimum process的内容
 
 

CNKI主页设CNKI翻译助手为主页 | 收藏CNKI翻译助手 | 广告服务 | 英文学术搜索
版权图标  2008 CNKI-中国知网
京ICP证040431号 互联网出版许可证 新出网证(京)字008号
北京市公安局海淀分局 备案号:110 1081725
版权图标 2008中国知网(cnki) 中国学术期刊(光盘版)电子杂志社