助手标题  
全文文献 工具书 数字 学术定义 翻译助手 学术趋势 更多
查询帮助
意见反馈
   view of engineering application 的翻译结果: 查询用时:0.185秒
图标索引 在分类学科中查询
所有学科
更多类别查询

图标索引 历史查询
 

view of engineering application
相关语句
  从工程应用出发
     With the view of engineering application, using water, propylene carbonate (A)and polyethylene glycol—dimethylether(B)as absorbents,the rates of absorption of CO_2 in the absorbents are measured with modified wetted-wall tower at the industrial operating temperatures.
     本研究从工程应用出发,以水、碳酸丙烯酯和聚乙二醇二甲醚为液相,在工业生产使用的温度条件下,用改良型湿壁塔测定各溶剂吸收CO_2的速度。
短句来源
     From the point of view of engineering application,the influences of resistance errors on beamforming were also discussed.
     作者从工程应用出发 ,分析了电阻值误差对波束形成的影响 .
短句来源
     Based on the CT testing results, the complete rock stress-strain process curve is divided into several. From the point of view of engineering application, the pre-peak 3-segment damage evolution equation and constitutive model of rock are given.
     基于CT试验结果,对岩石应力-应变全过程曲线进行了分段,从工程应用出发,给出 了峰前分段岩石损伤演化方程及本构关系。
短句来源
  “view of engineering application”译为未确定词的双语例句
     From the point of view of engineering application, this paper proposes an approach of designing self-tuning α-β filter based on [1].
     本文从工程应用角度出发,在文[1]基础上提出了自校正α-β滤波器设计方法。
短句来源
     The results show that both standard k ε model and Realizable k ε model in Fluent 6.0 could give results from the view of engineering application.
     结果表明基于Fluent 6的标准k ε模型和Realizablek ε模型均能给出工程应用精度的结果 ;
短句来源
     A computer vision solution scheme for the automatic landing of unmanned helicopter on ship was examined from the view of engineering application.
     通过理论分析和计算机半实物仿真研究了一种应用于无人直升机自主着舰的计算机视觉系统及相关计算机视觉技术 .
短句来源
     From the point of view of engineering application, the PID control rule is discussed and the experience of automatic control system is introduced.
     从工程应用的角度 ,对PID控制规律应用注意事项进行了讨论 ,并介绍了一些控制系统投入自动的经验
短句来源
     This paper,in view of engineering application and working experiences analyses and discusses some problems in land use dynamic monitoring by remote sensing technology.
     本文从工程应用的角度和根据实际工作经验,对土地利用动态遥感监测中的几个问题进行了分析和探讨。
短句来源
更多       
  相似匹配句对
     View
     观点
短句来源
     Point of view
     观点
短句来源
     PROJECTION AND VIEW
     投影与视图
短句来源
     In view of the limitation of B. K.
     鉴于常用的B.K.
短句来源
     On Engineering
     论工程
短句来源
查询“view of engineering application”译词为用户自定义的双语例句

    我想查看译文中含有:的双语例句
例句
没有找到相关例句


Overload retardation behavior under different overload ratios and different crack lengths in a Ti-6Al-4V titanium alloy has been investigated.The effect of some major factors on retardation behavior is discussed.The retardation behavior can be considered as the results of interaction effects between overload and cyclic loads.It is suggested tha retardation process may be divided into five stages. From an analysis of the modes of fatigue fractures, the overloading process of fatigue crack growth in these tests...

Overload retardation behavior under different overload ratios and different crack lengths in a Ti-6Al-4V titanium alloy has been investigated.The effect of some major factors on retardation behavior is discussed.The retardation behavior can be considered as the results of interaction effects between overload and cyclic loads.It is suggested tha retardation process may be divided into five stages. From an analysis of the modes of fatigue fractures, the overloading process of fatigue crack growth in these tests can be regarded as mainly in a plane strain condition or a mixed mode in which the plane strain occurs predominantly. Thus, at a given overload ratio Qo1 the number of delay cycles No caused by an overload increases with a decrease of Ko1 under plane strain condition.In this paper, the Wheeler, Willenborg, Maarse, and Matsuoka models were selected in view of engineering application. An evaluation of the describing capacity and life prediction of these models on retardation behavior have been made. The Matsuoka model based on the crack closure concept was found comparatively to be in good agreement with the experimental results. It is also recognized that the experimental values of overload delay effect zone size are considerably greater than the calculated values suggested by the above mentioned models.

本文针对Ti-6Al-4V钛板的超载试验,着重研究了不同超载比及不同裂纹长度下的超载迟滞特性,讨论了影响迟滞效应的一些主要因素。认为迟滞效应是循环载荷之间交互作用的结果,并提出了迟滞过程可以分为五个阶段的看法。通过对裂纹扩展形式等因素的分析,认为本试验的疲劳裂纹扩展的超载过程,属于平面应变或以平面应变为主的混合型;在平面应变条件下,对于给定的Q_(o1)超载引起的迟滞循环数N_o,随着超载水平K_(o1)的减小而增加。 从应用观点出发,选择了Wheeler模型、Willenborg模型、Matsuoka模型和Maarse模型,从各模型对迟滞现象的解释能力、应用情况等方面作了较全面的比较和讨论。认为以闭合效应为基础的Matsuoka模型与实际情况符合较好;并发现各模型计算中所假定的迟滞影响区,均比实测的超载迟滞影响区要小得多。

This paper gives a comprehensive introduction and review of the models for predicting fatigue crack growth under spectrum loadings.The schematic, characteristic parameters, governing equations and strong and weak. points of the load interaction models, which are presented typically hy the specialists of various countries in over ten years, are summarized and compared in tabular form. In addition, the selective principle, predictive accuracy and computation. cost of the models are discussed..In the view of engineering...

This paper gives a comprehensive introduction and review of the models for predicting fatigue crack growth under spectrum loadings.The schematic, characteristic parameters, governing equations and strong and weak. points of the load interaction models, which are presented typically hy the specialists of various countries in over ten years, are summarized and compared in tabular form. In addition, the selective principle, predictive accuracy and computation. cost of the models are discussed..In the view of engineering applications, Willenborg/Chang model provides an effective method for predicting fatigue crack growth under complex spectrum loadings. and some models developed by Chinese specialists are rather simple and efficacious.It is worth noting that further research in this field should be performed experimentally and analytically.

本文对谱载荷下预测疲劳裂纹扩展的各种模型作了综合介绍及评述。 对十余年来国内外学者提出的有代表性的载荷相互作用模型的基本原理、特征参数、主要的计算公式及优缺点等列表作了此较,并对模型的选择原则、计算精度与经济性进行了讨论。

From the point of view of engineering application, this paper proposes an approach of designing self-tuning α-β filter based on [1]. Thus, from both aspects of filter structure and parameter matching, it solves successfully the problem of maneuvering targets tracking accuracy. The simulation results achieved with IBM/AT computer used 8087 assembly language indicate that not only this method is simple and with acceptable performance, but also it is nearly twice as accurate as that of constant gains α-β...

From the point of view of engineering application, this paper proposes an approach of designing self-tuning α-β filter based on [1]. Thus, from both aspects of filter structure and parameter matching, it solves successfully the problem of maneuvering targets tracking accuracy. The simulation results achieved with IBM/AT computer used 8087 assembly language indicate that not only this method is simple and with acceptable performance, but also it is nearly twice as accurate as that of constant gains α-β filter.

本文从工程应用角度出发,在文[1]基础上提出了自校正α-β滤波器设计方法。从而从滤波器结构和参数匹配两方面较好地解决了α-β滤波器跟踪机动目标精度问题。在IBM/AT微机上用8087汇编语言进行的仿真结果表明,这种方法不仅简单易行且其精度比常增益α-β滤波器高近一倍。

 
<< 更多相关文摘    
图标索引 相关查询

 


 
CNKI小工具
在英文学术搜索中查有关view of engineering application的内容
在知识搜索中查有关view of engineering application的内容
在数字搜索中查有关view of engineering application的内容
在概念知识元中查有关view of engineering application的内容
在学术趋势中查有关view of engineering application的内容
 
 

CNKI主页设CNKI翻译助手为主页 | 收藏CNKI翻译助手 | 广告服务 | 英文学术搜索
版权图标  2008 CNKI-中国知网
京ICP证040431号 互联网出版许可证 新出网证(京)字008号
北京市公安局海淀分局 备案号:110 1081725
版权图标 2008中国知网(cnki) 中国学术期刊(光盘版)电子杂志社