助手标题  
全文文献 工具书 数字 学术定义 翻译助手 学术趋势 更多
查询帮助
意见反馈
   strong adhesive 的翻译结果: 查询用时:0.133秒
图标索引 在分类学科中查询
所有学科
更多类别查询

图标索引 历史查询
 

strong adhesive
相关语句
  附着力强
     And designs the flexible relief block printing ink characteristic of good flexibility,strong adhesive power, well-antifreezing and low cost.
     设计出具有柔性好、附着力强、抗冻性好,且成本低的柔性凸版油墨。
短句来源
     The coating has high strength,strong adhesive power and good wear resistance.
     涂层硬度高 ,附着力强 ,耐磨性好。
短句来源
     The protection coating used for graphite anode in calcium molten salt electrolysis is developed. It is indicated by XRD, SEM analysis and the weight loss experiment with oxidation that the coating is compact without crack and with strong adhesive, and with excellent capacity for oxidation protection of the graphite anode.
     研制出适合于钙熔盐电解的石墨阳极抗氧化涂层,XRD和SEM分析及氧化失重试验结果表明,涂层致密无裂纹且附着力强,具有较好的抗石墨阳极氧化能力
短句来源
  “strong adhesive”译为未确定词的双语例句
     Development of 901 Rapid Strong Adhesive
     901快速强力胶的研制
短句来源
     The Preparation and Application of a Strong Adhesive
     强力胶粘剂的制备及应用研究
短句来源
     10CrCuSiV was a new kind of low alloy steel for resistance Sea-corrosion,its corrosion rate was 0.23 mm/a in the sea after immersed 7 years. Used the metallograph,lithofacies-MIC, X-ray diffraction, SEM and electron energy spectrum etc, the results areshown:1)The rust on the 10CrCuSiV steel has strong adhesive power, compact textureand small adhesiveness coefficient.
     新型耐海水腐蚀低合金钢10CrCusiV,在大连海域全浸区挂片试验7a后的腐蚀率为0.23mm/a.通过金相、岩相、X射线衍射及扫描电镜、电子能谱等分析,都证明了10CrCuSiV钢的锈层致密,附着牢固,粘附性系数小;
短句来源
     Study on high—speed and strong adhesive laetescent viscose
     高速强力粘接乳胶的研究
短句来源
     The results show that the binder has a strong adhesive to Fe-2Ni powder and a high solid loading, and the binder and powder could be mixed easily to obtain a homogeneous feedstock.
     结果表明 :新型PEG基粘结剂与Fe - 2Ni粉具有较强的相互作用 ,混合均匀性好 ,且粉末装载量高 ,注射料注射成形性好。
短句来源
更多       
  相似匹配句对
     The Preparation and Application of a Strong Adhesive
     强力胶粘剂的制备及应用研究
短句来源
     Development of 901 Rapid Strong Adhesive
     901快速强力胶的研制
短句来源
     Strong shoulders
     “肩”强无比
短句来源
     the strong power
     科技:地产演进的强大动力
短句来源
     Anaerobic adhesive
     厌氧胶
短句来源
查询“strong adhesive”译词为用户自定义的双语例句

    我想查看译文中含有:的双语例句
例句
为了更好的帮助您理解掌握查询词或其译词在地道英语中的实际用法,我们为您准备了出自英文原文的大量英语例句,供您参考。
  strong adhesive
The strong adhesive causes tearing of the back plate, whereas the compliant adhesive results in extensive delamination without any back plate damage.
      
The key problem in designing polymeric composites is ensuring a sufficiently strong adhesive bond between the polymer and the filler (or the reinforcement).
      
It was therefore possible to achieve both nickel-zirconium oxide as well as a copper-zirconium oxide coatings with strong adhesive bonds on stainless steel.
      
Accordingly, galectins can display de-adhesive effects when presented as soluble proteins to cells in a strong adhesive state.
      
The surface obtained at 16K showed an extreme smooth feature, and the friction performance was revealed to be controlled only by abrasive process, as opposed to that at room temperature of strong adhesive effect.
      
更多          


By the direct radiation grafting techonique, kinetics of the Gamma-induced graft copolymerization of st-AA to polytetrafluoroethyene has been studied at 20°-40℃. Dependence of the grafting temperature on the critical radiation intensity has been found. Above a given critical radiation intensity, the grafting is limited to the surface. Below that intensity, the grafting proceeds in the mass. Optical microscope and scanning electron microscope were used to study the structure of the cross section and surface of...

By the direct radiation grafting techonique, kinetics of the Gamma-induced graft copolymerization of st-AA to polytetrafluoroethyene has been studied at 20°-40℃. Dependence of the grafting temperature on the critical radiation intensity has been found. Above a given critical radiation intensity, the grafting is limited to the surface. Below that intensity, the grafting proceeds in the mass. Optical microscope and scanning electron microscope were used to study the structure of the cross section and surface of the grafted film. The grafted amount of the surface grafted film is about 1 mg/cm2, thus, the average adhesive strength is found to be above 100 kg/cm2. The electrical properties of the surface grafted film are the same as those in nongraft film. This indicates that the Gamma radiation-induced surface graft copolymer of at-AA to polytetrafluoroethyene could be used as constructional material with strong adhesive strength or as adhesive sealing material of the electronic parts.

本文采用共辐照工艺,在20°—40℃范围内研究了聚四氟乙烯辐射引发接枝苯乙烯-丙烯酸的动力学。找到了接枝温度与临界辐照强度的关系。高于临界辐照强度,接枝发生在表面,反之,接枝发生在整体。借光学显微镜和扫描电子显微镜研究了接枝膜的断面和表面结构。表面接枝膜的接枝量约1毫克/厘米~2,平均粘结强度高达100公斤/厘米~2以上。表面接枝膜的电性能与未接枝的聚四氟乙烯相仿。可知聚四氟乙烯表面辐射接枝苯乙烯-丙烯酸可用作强粘结强度的结构材料或电子元件的粘结密封材料。

By mixing flocculating agent into the underwater concrete, it will make the concrete to produce strong adhesive attraction and bear a particular anti-dispersion behavior on the concrete, so as to keep a good integrity of the mixture and alleviate. the erosion 9r "washing" action of water, and at last, the structural composition of concrete component will be kept in a good state, and normal hardening of concrete will be going on. This, paper presents abrief sum-up of tests on the mixing agent for underwater...

By mixing flocculating agent into the underwater concrete, it will make the concrete to produce strong adhesive attraction and bear a particular anti-dispersion behavior on the concrete, so as to keep a good integrity of the mixture and alleviate. the erosion 9r "washing" action of water, and at last, the structural composition of concrete component will be kept in a good state, and normal hardening of concrete will be going on. This, paper presents abrief sum-up of tests on the mixing agent for underwater concrete.

掺有絮凝剂的混凝土,具有较强的粘聚性,在水下施工中以其特有的抗分散性能,使混凝土保持优良的整体性,减弱水的侵蚀和“洗涤”作用,最大程度地保证混凝土组成份的排列结构和正常硬化成型。本文是关于絮凝剂应用于水下混凝土的试验小结。

This paper describes the method that the polyester-amide hot melting adhesive is manufactured by polyester and polyamide adhesive as the raw materials melting together by heat with catalyst, and through the exchange reaction of macromolecule chain to obtain it. The exchange reaction is proved by the experiment of solution of the product in polyester adhesive agent and the analysis of infrared ray analyzer. There is a stronger adhesive strength of the product by this method, and it also...

This paper describes the method that the polyester-amide hot melting adhesive is manufactured by polyester and polyamide adhesive as the raw materials melting together by heat with catalyst, and through the exchange reaction of macromolecule chain to obtain it. The exchange reaction is proved by the experiment of solution of the product in polyester adhesive agent and the analysis of infrared ray analyzer. There is a stronger adhesive strength of the product by this method, and it also bears either water washing or dry washing. It is suitable for the production of adhesive lining cloth.

研究了以聚酯胶和聚酰胺胶为原料在催化剂的作用下加热共熔,通过大分子链交换反应制备织物用聚酯酰胺热熔胶的方法。用聚酯胶的溶剂对所得产品进行溶取试验并且通过红外光谱分析都证明了链交换反应的存在。用该法所得产品粘接强度大,既耐水洗又耐干洗,适用于粘合衬生产。

 
<< 更多相关文摘    
图标索引 相关查询

 


 
CNKI小工具
在英文学术搜索中查有关strong adhesive的内容
在知识搜索中查有关strong adhesive的内容
在数字搜索中查有关strong adhesive的内容
在概念知识元中查有关strong adhesive的内容
在学术趋势中查有关strong adhesive的内容
 
 

CNKI主页设CNKI翻译助手为主页 | 收藏CNKI翻译助手 | 广告服务 | 英文学术搜索
版权图标  2008 CNKI-中国知网
京ICP证040431号 互联网出版许可证 新出网证(京)字008号
北京市公安局海淀分局 备案号:110 1081725
版权图标 2008中国知网(cnki) 中国学术期刊(光盘版)电子杂志社