助手标题  
全文文献 工具书 数字 学术定义 翻译助手 学术趋势 更多
查询帮助
意见反馈
   input gas 的翻译结果: 查询用时:0.043秒
图标索引 在分类学科中查询
所有学科
更多类别查询

图标索引 历史查询
 

input gas
相关语句
  进口烟气
     Further improvement can be made to enhance the input gas temperature,use more sugarcane dregs as fuel of boilers and raise the wet dust-removal efficiency.
     应通过提高进口烟气温度 ,尽量多用甘蔗渣为锅炉燃料和提高湿式除尘效率进一步提高该技术的处理能力
短句来源
  “input gas”译为未确定词的双语例句
     Simultaneous NO absorption could promote the oxidation of FeII(EDTA), the apparent oxidation reaction rate constant increased from 0.00451min-1 to 0.00604min-1, when NO concentration of input gas increased from 0 to 500cm3/m3. The oxidation reaction of FeII(EDTA) by O2 was first order reaction, apparent oxidation rate constant had liner relation with O2 content.
     结果表明,同时吸收NO可促进FeII(EDTA)的氧化,当进气NO浓度由0增至500cm3/m3时,表观氧化反应速率常数由0.00451min-1增至0.00604min-1; FeII(EDTA)的氧化反应对于O2含量为1级反应,表观氧化速率常数与O2含量成线性关系;
短句来源
     Through the control of the concentration of input gas, the reaction finish in a definete time, and thus the -input quantity of the gas is minimum.
     通过控制外界气体浓度,使反应在某固定时刻完成,并且输入气体量最小。
短句来源
     A Related Control System of Waste Energy Recovery Turbine Requiring Stationary Input Gas Pressure
     具有定常气压要求的余能透平联系控制系统
短句来源
     Experiments show that the water content of theproduct fuel - methanol can be kept within1 % (mass)by fixing an appropriate content ofcarbon dioxide in the input gas under certainoperation conditions.
     结果表明,在一定的操作条件下,入塔气中选择合适的CO2含量,产品燃料甲醇中的水含量可维持在1%(mass)以内。
短句来源
     Thermodynamic analysis and a technical design and experimental results for the chemical vapor deposition(CVD) of AIN film from AIBr2-NH3-N2 system are presented. At various deposition temperatures,input gas flow rates and total pressure,the equilibrium partial pressures of the major gaseous species are calculated. The effects of precursor temperature and gas flow rate on the theoretical deposition rate of AIN film are estimated.
     对AIBr3-NH3N2体系化学气相淀积法合成AIN膜进行了热力学分析和工艺设计,研究了在不同淀积温度和体系总压时,体系中主要气态物种的平衡分压和AIN膜的理论淀积速率与源温和载气流量的关系,并与微波等离子体化学气相淀积AIN膜的实验结果进行了比较.
短句来源
更多       
  相似匹配句对
     Determination of Heat Input of the Gas Appliance in Detecting
     燃具检验热负荷的确定
短句来源
     Fault analysis through changing of input gas pressure
     通过进气压力变化诊断12V190型柴油机故障
短句来源
     Gas Bearings
     气轴承
短句来源
     The Emissivity of Gas
     气体黑度
短句来源
     The input of C in default
     C语言的缺省输入
短句来源
查询“input gas”译词为用户自定义的双语例句

    我想查看译文中含有:的双语例句
例句
为了更好的帮助您理解掌握查询词或其译词在地道英语中的实际用法,我们为您准备了出自英文原文的大量英语例句,供您参考。
  input gas
The heat transfer coefficient was estimated as a function of the input gas flow rate, solution flow rate, temperature, concentration, absorber diameter and height, and input flow direction.
      
These conditions are met at low coupled microwave powers (>amp;lt;300 W) and low total process pressures (>amp;lt;1.0 mTorr) for input gas mixtures of 25% Cl2 in Ar.
      
Subsequent growth experiments were then performed for each Q-composition in which the input gas flow rates were kept the same and only the temperature changed in 25°C decrements down to 600°C.
      
To get an optimal film, a precise control of input gas composition and also a deposition in a low temperature range from 350 to 400°C are necessary.
      
Values for the amount of TMA adsorbed on graphite surfaces under a variety of conditions were determined by analyzing the transient response attending abrupt changes in input gas composition.
      
更多          


A thermodynamic analysis of the deposition of Ga_xAl_(1-r)N from the Al-Ga-HCl-NH_3-H_2 system is described. A computation procedure is developed to predict the equilibrium partial pressure of the major gaseous species and the deposition rate and composition of the solid phase under various input gas stream composition and temperature conditions. The relevance of these results to the preparation of Ga_xAl_(1-x)N solid solutions is discussed.

本文叙述了以Ga—Al—HCl—NH_3—H_2体系淀积Ga_xAl_(l-x)N材料的热力学分析。所提出的计算程序可以予言在各种输入气流组成和淀积温度条件下体系中主要气态物种的平衡分压和固相组成及其淀积速率。并讨论了这些理论计算结果对于Ga_xAl_(l-x)N固溶体材料研制的指导意义。

This paper briefly introduces practicability of superplastic forming/diffusion bonding (SPE/DB) of TC4 (TI-6A1-4V) titanium alloy sheet and effect of main proc2ssing factors, such as forming temperature, compressing rate, pressure and holding time, on SPF and SPF/DB. The processing condition for some air frames and loading doors are described and reasonable processing parameters and procedures are provided. The problems of blowing bulging input gas, high-temperature protection and mould unloading of parts...

This paper briefly introduces practicability of superplastic forming/diffusion bonding (SPE/DB) of TC4 (TI-6A1-4V) titanium alloy sheet and effect of main proc2ssing factors, such as forming temperature, compressing rate, pressure and holding time, on SPF and SPF/DB. The processing condition for some air frames and loading doors are described and reasonable processing parameters and procedures are provided. The problems of blowing bulging input gas, high-temperature protection and mould unloading of parts and their solutions are provided.Test results show that obvious technical and economic benefit can be obtained.

TC4(Ti-6Al-4V)钛合金板材超塑成形/扩散连接(SPF/DB)组合工艺的可行性和对影响钛板SPF、SPF/DB的主要工艺因素。着重阐述某机框段和舱门的研制情况,提供了合理的工艺参数和流程。

This paper is concerned with an optimal boundary control problem of gas-solid re-action . The equations of mass conservations of the reactions arc described by a nonlinear parabolic system of equations. The objective function is the input quantity of gas in a fixed period of time. Through the control of the concentration of input gas, the reaction finish in a definete time, and thus the -input quantity of the gas is minimum. We have discussed solvability of the equations and proved the existence...

This paper is concerned with an optimal boundary control problem of gas-solid re-action . The equations of mass conservations of the reactions arc described by a nonlinear parabolic system of equations. The objective function is the input quantity of gas in a fixed period of time. Through the control of the concentration of input gas, the reaction finish in a definete time, and thus the -input quantity of the gas is minimum. We have discussed solvability of the equations and proved the existence of optimal control and also obtained an approximat result of the optimal control.

本文研究了气-固反应中的一个边界最优控制问题。反应的质量守恒方程为非线性抛物方程组,目标函数为一定时间内输入的气体量。通过控制外界气体浓度,使反应在某固定时刻完成,并且输入气体量最小。我们讨论了方程的可解性,得到了最优控制的存在性,并建立了最优控制的一个逼近结果。

 
<< 更多相关文摘    
图标索引 相关查询

 


 
CNKI小工具
在英文学术搜索中查有关input gas的内容
在知识搜索中查有关input gas的内容
在数字搜索中查有关input gas的内容
在概念知识元中查有关input gas的内容
在学术趋势中查有关input gas的内容
 
 

CNKI主页设CNKI翻译助手为主页 | 收藏CNKI翻译助手 | 广告服务 | 英文学术搜索
版权图标  2008 CNKI-中国知网
京ICP证040431号 互联网出版许可证 新出网证(京)字008号
北京市公安局海淀分局 备案号:110 1081725
版权图标 2008中国知网(cnki) 中国学术期刊(光盘版)电子杂志社