助手标题  
全文文献 工具书 数字 学术定义 翻译助手 学术趋势 更多
查询帮助
意见反馈
   whole stroke 的翻译结果: 查询用时:0.132秒
图标索引 在分类学科中查询
所有学科
更多类别查询

图标索引 历史查询
 

whole stroke
相关语句
  全行程
     According to these features, this article puts forward that in this kind of cylinder’s testing, the frictions and dynamic responds of the whole stroke must be tested.
     本文针对这些特点 ,提出了轧制伺服油缸的试验必须进行全行程摩擦力和动态响应特性的测试 ;
短句来源
     In order to satisfy the smoothness of thrust of flat three-phase permanent magnet linear synchronous motor(PMLSM),factors and regularity of its end force and slot force are analyzed through finite element method. A method to measure the detent force in the right and left direction according to reciprocating movement on the whole stroke is introduced,which can eliminate the effect of the friction force,and the experiment is carried out on an optimized prototype.
     为满足平板式三相交流永磁同步直线电动机(PMLSM)推力平稳性要求,利用有限元方法分析端部力和齿槽力的形成原因和波动规律,介绍了一种全行程往复运动双向测量的直线电机定位力的方法,可以克服摩擦力的影响,并在样机上实验完成。
短句来源
  “whole stroke”译为未确定词的双语例句
     The characters of motor are analyzed through experiments. Research demonstrates that driving force is proportional with the current,and driving force is stable in the whole stroke,and driving force reaches 0.72 N when the current strength is 0.004A,and the temperature of coil rises to 55.6 °C.
     对样机进行了试验分析,结果表明电机驱动力和电流呈线性关系,在整个行程中,输出力均匀,驱动力在电流0.004A时可达0.72N,线圈温度在55.6°C。
短句来源
     Whole Stroke Automatic Control of a Bypass Used for a Steam Turbine's M.P. Cylinder Starting Procedure
     旁路全程自动在中压缸启动汽轮机组中的实现
短句来源
     So as to know the working status of the subsurface sucker rod pump having hanging weight at the end of rod string for polymer containing liquid, by contrast to the common pump at the similar pumping parameters, the peculiarity and regularity of the two kind pumps" load changing during the whole stroke were calculated by the qualitative and quantitative method. The dynamometer card in theory of the subsurface rod pump for polymer containing liquid at ideal condition was obtained as well.
     为了进一步探索悬重式抽聚泵的工作状况,从柱塞悬重式抽聚泵的工作原理入手,通过与相近工作制度的普通管式泵对比,采用定性与定量相结合的方法,详细计算和分析了在一个冲程之内,两种泵型的载荷变化规律和特点,给出了在比较理想的状态下抽聚泵的理论示功图。
短句来源
     Whole stroke automatic control of the bypass for middle pressure cylinder starting of steam turbine sets is being explained,simultaneously pointing out the key points during the whole control procedure. The practical way of manipulation is described on hand of a certain power plant's 600 MW set.
     描述了中压缸启动机组的旁路全程控制的方法,指明了控制过程中的关键点,并结合某电厂600 MW机组中压缸启动的控制过程,介绍了实现旁路全程自动的具体操作方法。
短句来源
     Based on it the effects of the stiffness of the two springs on the characteristic relationship, the seat vertical equivalent stiffness and the suspension vibration natural frequency within the suspension whole stroke were analyzed and the possibility of changing vertical equivalent stiffness by adjusting spring stiffness was discussed.
     基于此模型,分析了在悬架运动行程内,两弹簧刚度对悬架垂向力-位移特性、垂向等效刚度以及振动固有频率的影响,探讨了通过对螺旋弹簧刚度的调节来实现悬架垂向等效刚度调节的可行性。
更多       
  相似匹配句对
     Silent Stroke
     静止性卒中(附58例报告)
短句来源
     Thrombin and Stroke
     凝血酶与卒中
短句来源
     The whole cells of R.
     直接将霉菌R.
短句来源
     The effective stress distribution and the load-stroke curve of the whole process are got.
     得到了新工艺成形过程的应力分布图以及载荷———形成曲线。
短句来源
     Push it on as a whole,but do not try to cut it even at one stroke.
     既要整体推进,但又不能搞“一刀切”;
短句来源
查询“whole stroke”译词为用户自定义的双语例句

    我想查看译文中含有:的双语例句
例句
为了更好的帮助您理解掌握查询词或其译词在地道英语中的实际用法,我们为您准备了出自英文原文的大量英语例句,供您参考。
  whole stroke
Energy cost of arm stroke, leg kick, and the whole stroke in competitive swimming styles
      
The brush texture is nearby constant over the whole stroke.
      
Differences can be seen in the distribution of the texture over the whole stroke.
      


A control system for dynamically regulating the amount of injection and injection timing in diesel engines is presented in this paper. In the system an injection pump is designed based on controllable pre-stroke principle, a stepmotor is adopted as an executive unit and a model 8098 monolithic circuit as the kernal of controlling unit. The collecting accuracy of the system and static characteristics of the executive unit have been tested and analysed, the controlling performance of an A type pump have also been...

A control system for dynamically regulating the amount of injection and injection timing in diesel engines is presented in this paper. In the system an injection pump is designed based on controllable pre-stroke principle, a stepmotor is adopted as an executive unit and a model 8098 monolithic circuit as the kernal of controlling unit. The collecting accuracy of the system and static characteristics of the executive unit have been tested and analysed, the controlling performance of an A type pump have also been studied for simulating two-terminal and whole stroke regulators, then the controlling curves are obtained.

介绍一种用于动态调整柴油机喷油量和喷油正时的控制系统。该系统的喷油泵是基于可控预行程原理设计的,以步进电机为执行器,以8098单片机为控制单元的核心,对系统的采集精度及执行器的静态特性进行了试验分析。模拟两极式和全程式调整器对A型泵进行了控制试验,并取得了控制曲线。

Through the analysis of the speed of arm pulls,leg kicks and whole stroke of swimmers by using the method of GreyRelatedness,the author pointed out that swimming technical standards and comprehensive technical models could be formu-lated by using the method of quantitative analysis for swimming techniques.The experiment showed that this method ofquantitative analysis was effective.Also,The process of using the method was introduced in the paper.

通过对运动员游泳分解动作和配合动作速度的关联度分析,提出了制定游泳技术标准与建立综合技术模型的一种游泳技术定量分析方法,实验证明了这种分析方法的有效性,同时介绍了这种方法的运用过程。

From the angle of examination of kinetic characteristic of the press,effect of the matched main motor torque-speed characteristic on the press kinetic energyaccumulating and blow times per minute is investigated. Variation of fly wheel start time,slider velocity,blow energy and blows per minute at whole stroke with change of the motormaximum torque or critical slip ratio are brought to light.Relative parametersdetermination priciple of the press and the motor is proposed,and theorectic analysis andcaculating...

From the angle of examination of kinetic characteristic of the press,effect of the matched main motor torque-speed characteristic on the press kinetic energyaccumulating and blow times per minute is investigated. Variation of fly wheel start time,slider velocity,blow energy and blows per minute at whole stroke with change of the motormaximum torque or critical slip ratio are brought to light.Relative parametersdetermination priciple of the press and the motor is proposed,and theorectic analysis andcaculating formulas are provided.

从分析J58系列电动螺旋压力机主机运动特性角度,研究其主电动机机械特性对压力机打击能量积蓄过程、滑块每分钟行程次数的影响.通过实例计算,得出从轮启动时间、滑块运动速度、打击能级、每分钟全能量打击次数随电动机最大转矩、临界转差率变化的规律.提出合理选取J58系列电动螺旋压力机基础参数和其主电动机参数的原则,为该系列压力机的设计和计算提供了理论分析方法和计算公式.

 
<< 更多相关文摘    
图标索引 相关查询

 


 
CNKI小工具
在英文学术搜索中查有关whole stroke的内容
在知识搜索中查有关whole stroke的内容
在数字搜索中查有关whole stroke的内容
在概念知识元中查有关whole stroke的内容
在学术趋势中查有关whole stroke的内容
 
 

CNKI主页设CNKI翻译助手为主页 | 收藏CNKI翻译助手 | 广告服务 | 英文学术搜索
版权图标  2008 CNKI-中国知网
京ICP证040431号 互联网出版许可证 新出网证(京)字008号
北京市公安局海淀分局 备案号:110 1081725
版权图标 2008中国知网(cnki) 中国学术期刊(光盘版)电子杂志社