助手标题  
全文文献 工具书 数字 学术定义 翻译助手 学术趋势 更多
查询帮助
意见反馈
   double glow plasma chromizing 的翻译结果: 查询用时:0.008秒
图标索引 在分类学科中查询
所有学科
金属学及金属工艺
更多类别查询

图标索引 历史查询
 

double glow plasma chromizing
相关语句
  双辉等离子渗铬
     Study on Low Temperature Double Glow Plasma Chromizing Process of T8 Steel
     T8钢的低温双辉等离子渗铬研究
短句来源
     Double glow plasma chromizing process of T8 steel at temperature range of 880~900℃ was studied.
     用双辉等离子渗铬技术 ,进行了 880~ 90 0℃温度下的T8钢表面渗铬合金化研究 ;
短句来源
     The results show that the carbon migration from substrate to chromized layer was inevitable due to the decrease of chemical potential of carbon in austenite during double glow plasma chromizing process of T8 steel. The decarbonization caused by cathode sputter can be avoided by controlling parameters during the chromizing process.
     结果表明 ,对T8钢进行双辉等离子渗铬处理时 ,奥氏体中碳化学位下降引起的从基体向渗层的碳迁移是必然的 ,但通过控制工艺参数 ,由阴极溅射引起的表面脱碳是可以减轻的。
短句来源
     The results showed that for T10 steel in double glow plasma chromizing process, some forms of chromizing layers such as chromium depositing layer, chromium diffusing layer and chromium diffusion-depositing layer can be formed by adjusting the process parameters.
     结果表明,在880~900 ℃温度下,对T10钢进行双辉等离子渗铬,可得到铬沉积层、铬渗镀层等形式的渗铬改性层。 通过调节工艺参数,可对渗铬改性层形式进行控制。
短句来源
  “double glow plasma chromizing”译为未确定词的双语例句
     In 10% H_2SO_4,3.5% NaCl and H_2S pregnant solutions(H_2S 5~8g/L,NH_3·H_2O 20g/L),the electrochemical corrosion experiments were carried out on the double glow plasma chromizing samples and Q235 steel samples.
     将双层辉光离子渗铬+渗碳淬火试样,在10%硫酸、3.5%NaCl水溶液和H2S富液(含H2S 5~8g/L,NH3.H2O 20g/L)中,进行电化学腐蚀试验。
短句来源
     The results indicated that the corrosion resistance of the double glow plasma chromizing samples was 2.35,3.10 and 2.14 times higher than that of Q235 steel samples.
     结果表明,渗铬试样在10%硫酸、3.5%氯化钠水溶液和硫化氢富液中的耐腐蚀程度比Q235基体试样分别提高了2.35、3.10、2.14倍。
短句来源
     Double glow plasma chromizing process for T10 steel under 880~900℃ was studied. The distributions of carbon and chromium concentration were measured.
     用双辉等离子渗金属技术,在880~900 ℃温度下,对T10钢进行了表面渗铬试验;
短句来源
     In this article,it was introduced that a high chromium alloy layer was produced on Q235 steel with the double glow plasma chromizing. The fundamental principle is that alloying element Cr was penetrated into the Q235 steel in a vacuum chamber by glow discharge sputtering so that the Cr content of alloyed layer was about 40% on the surface of Q235 steel and the depth of coating is about to 50μm,respectively.
     在Q235钢表面进行双层辉光离子渗Cr,表面Cr含量约为40%,渗层厚度近50μm;
短句来源
  相似匹配句对
     Study on Low Temperature Double Glow Plasma Chromizing Process of T8 Steel
     T8钢的低温双辉等离子渗铬研究
短句来源
     Change of source cathode by double glow plasma
     双层辉光离子多元共渗中的源极变化
短句来源
     Surface chromizing at 900 ℃ of T8 steel was studied using double glow plasma alloying process.
     采用双辉等离子渗铬技术,对T8钢进行了900 ℃温度表面渗铬合金化;
短句来源
     Surface chromizing of Ti-6Al-4V by double glow plasma surface alloying technology
     Ti-6Al-4V表面双层辉光离子渗Cr研究
短句来源
     Low Temperature Double Glow Plasma Surface Chromizing Hardening Process of Carbon Tool Steel
     碳素工具钢表面低温双辉等离子渗铬硬化的研究
短句来源
查询“double glow plasma chromizing”译词为用户自定义的双语例句

    我想查看译文中含有:的双语例句
例句
没有找到相关例句


Double glow plasma chromizing process of T8 steel at temperature range of 880~900℃ was studied. The concentration distributions of Fe,Cr and C of the chromized T8 steel were measured. The carbon migration behavior in substrate and chromized layer is analyzed. The results show that the carbon migration from substrate to chromized layer was inevitable due to the decrease of chemical potential of carbon in austenite during double glow plasma chromizing process of T8 steel. The decarbonization caused by cathode...

Double glow plasma chromizing process of T8 steel at temperature range of 880~900℃ was studied. The concentration distributions of Fe,Cr and C of the chromized T8 steel were measured. The carbon migration behavior in substrate and chromized layer is analyzed. The results show that the carbon migration from substrate to chromized layer was inevitable due to the decrease of chemical potential of carbon in austenite during double glow plasma chromizing process of T8 steel. The decarbonization caused by cathode sputter can be avoided by controlling parameters during the chromizing process.

用双辉等离子渗铬技术 ,进行了 880~ 90 0℃温度下的T8钢表面渗铬合金化研究 ;测量了渗铬层中Fe、Cr和C等元素的浓度分布 ,分析了渗铬合金化层形成过程中碳迁移行为。结果表明 ,对T8钢进行双辉等离子渗铬处理时 ,奥氏体中碳化学位下降引起的从基体向渗层的碳迁移是必然的 ,但通过控制工艺参数 ,由阴极溅射引起的表面脱碳是可以减轻的。

Double glow plasma chromizing process for T10 steel under 880~900℃ was studied. The distributions of carbon and chromium concentration were measured. The surface micrographs and phase structure in chromizing layer were analyzed. The results showed that for T10 steel in double glow plasma chromizing process, some forms of chromizing layers such as chromium depositing layer, chromium diffusing layer and chromium diffusion-depositing layer can be formed by adjusting the process parameters.

用双辉等离子渗金属技术,在880~900 ℃温度下,对T10钢进行了表面渗铬试验;分析了渗铬改性层的表观形貌和相结构,测量了渗铬改性层的成分。结果表明,在880~900 ℃温度下,对T10钢进行双辉等离子渗铬,可得到铬沉积层、铬渗镀层等形式的渗铬改性层。通过调节工艺参数,可对渗铬改性层形式进行控制。

Low temperature double glow plasma chromizing process of T8 steel was studied. The microstructure and the phase structure of chromized layer was analyzed. The depth of chromized layer and the distribution of microhardness and chromium concentration were measured. Bonding force between the layer and base was tested by scratching. The results showed that a good chromized layer could be also gained in T8 steel by low temperature double glow plasma chromizing process. The layer consisted of sediment...

Low temperature double glow plasma chromizing process of T8 steel was studied. The microstructure and the phase structure of chromized layer was analyzed. The depth of chromized layer and the distribution of microhardness and chromium concentration were measured. Bonding force between the layer and base was tested by scratching. The results showed that a good chromized layer could be also gained in T8 steel by low temperature double glow plasma chromizing process. The layer consisted of sediment layer, carbide layer and solid solution layer.

研究了 T8钢低温双辉等离子渗铬工艺 ,分析了改性层的显微组织和相结构 ,测量了改性层的厚度、硬度及铬浓度分布 ,并对改性层进行了划痕检验。结果表明 ,T8钢在 90 0℃以下温度进行双辉等离子渗铬也可得到良好的改性层。改性层由沉积层、碳化物层和固溶体层构成

 
<< 更多相关文摘    
图标索引 相关查询

 


 
CNKI小工具
在英文学术搜索中查有关double glow plasma chromizing的内容
在知识搜索中查有关double glow plasma chromizing的内容
在数字搜索中查有关double glow plasma chromizing的内容
在概念知识元中查有关double glow plasma chromizing的内容
在学术趋势中查有关double glow plasma chromizing的内容
 
 

CNKI主页设CNKI翻译助手为主页 | 收藏CNKI翻译助手 | 广告服务 | 英文学术搜索
版权图标  2008 CNKI-中国知网
京ICP证040431号 互联网出版许可证 新出网证(京)字008号
北京市公安局海淀分局 备案号:110 1081725
版权图标 2008中国知网(cnki) 中国学术期刊(光盘版)电子杂志社