助手标题  
全文文献 工具书 数字 学术定义 翻译助手 学术趋势 更多
查询帮助
意见反馈
   representative value 的翻译结果: 查询用时:0.01秒
图标索引 在分类学科中查询
所有学科
建筑科学与工程
地质学
自动化技术
数学
宏观经济管理与可持续发展
贸易经济
工业通用技术及设备
更多类别查询

图标索引 历史查询
 

representative value
相关语句
  代表值
     The results show that 0.005 is the adequate representative value of ∫_1 for thepublic adults,which is 25 times greater than the value recommended by ICRP 30(0.0002).
     结果表明,对于公众中成年人0.005是 f_1值的合适代表值,是 ICRP 30号报告推荐值 f_1=0.0002的25倍。
短句来源
     Determination of representative value of target displacement in displacement reliability-based seismic design method
     直接基于位移可靠度的抗震设计方法中目标位移代表值的确定
短句来源
     Based on the analysis of the principle of preventing slab progressive collapse,it is reckoned if the formula(6.6.9) suggested by Code of Seismic Design of Buildings(GB50011—2001)applies to interior connection,exterior connection and corner connection without spandrel beam,N_G in the formula should be modified as the design value of axial compressive force in the interior column under the representative value of gravity load of the floor.
     通过对防止楼板连续倒塌原理的分析,提出如果将我国《建筑抗震设计规范》(GB50011—2001)建议的公式(6.6.9)同时应用于中柱节点、无边梁的边柱节点和角柱节点,公式中的NG应改为该层楼板重力荷载代表值作用下的中柱轴压力设计值。
短句来源
     Compared with the experimental results,the representative value is useful in the region of low lying frequency.
     通过与水弹实验数据的对比 ,认为该代表值在结构的低阶频率区域是可用的。
短句来源
     Theconcrete representative value coefficient of same condition specimens is 1.13, which is alittle bigger than the criterion’s 1.10.In winter, antifreeze mixed in and adopted heat preservation conserve, the pumpingconcrete’s strength increasing also match the logarithm curve.
     得到泵送混凝土同条件养护试件的强度代表值系数为1.13,略大于规范规定值1.10。
短句来源
更多       
  典型值
     With the measurement of batch respirometric method, the value of the yield coefficient for heterotrophic biomass is 0.65, which is different from the representative value of YH for municipal wastewater 0.67 that was presented in ASM1.
     采用间歇式呼吸计量法,测得该废水的异养菌产率系数为0.65,此值不同于ASM1号模型中推荐的城市污水异养菌产率系数的典型值0.67。
短句来源
     The conventional Dammann grating is a binary-phase uniform-intensity splitter designed by using the scalar diffractive theory,and the representative value of diffraction efficiency is about 80%.
     传统的Dammann光栅是基于标量衍射理论设计的二值相位等光强分束器件,其衍射效率的典型值为80%左右.
短句来源
  “representative value”译为未确定词的双语例句
     A NEW METHOD ON ESTIMATING CONCRETE STRENGTH REPRESENTATIVE VALUE
     估计混凝土检验批强度标志值的一种新方法
短句来源
     In the developed countries, because of the high developed economy and capital market, Everything has been in a good state, so legated system arrangement and operation system are formed, which can assure the resources of enterprises be analyzed, reconstructed and reused for decreasing the representative value.
     在西方发达的国家,由于资本和经济市场发展到一定程度后,都已经进入到一种有序的状态,因此已经形成了规范的制度安排及运作机制,可以保证企业的资源不断地分解、重组与整合,来减少企业的代理成本。
短句来源
     The LE 1 is proposed to be the stability criterion of rock and soil slopes, and the |LE 1| is regarded as the representative value of the system stability degree.
     提出将LE1作为岩土边坡的稳定判据,将|LE1|作为系统稳定度的表征量。
短句来源
     A new method of estimating concrete strength representative value by means of a confidence lower limit is presented in this paper ,and one-side tolerance factor expression is given.
     提出了用置信下限作为混凝土检验批强度标志值的估计量的新方法,给出了单侧容限系数的表达式。
短句来源
     When the air mass frequency from one side arrives at its maximum, the sulfate concentration is the representative value of this side approximately.
     当来自某方面的气团频度达到最大值时 ,岛上的SO2 - 4浓度接近该方向气团的参考浓度 .
短句来源
更多       
查询“representative value”译词为用户自定义的双语例句

    我想查看译文中含有:的双语例句
例句
为了更好的帮助您理解掌握查询词或其译词在地道英语中的实际用法,我们为您准备了出自英文原文的大量英语例句,供您参考。
  representative value
The determined representative value of the parameterh is equal to 1.34, with 1.08 and 1.60, 95% confidence intervals, and the value of τ0 has been found equal to 20 days.
      
A representative value of the decay parameter of the statistical law, which describes the time distribution of the aftershocks in a region, can be reliably determined by considering all the complete sets of aftershocks of the region as one sequence.
      
Only two of the possible combinations of length scales and permeability relations provide a maximum value within the mush that can be chosen as a representative value for the given conditions.
      
A representative value of 0.30 ± 0.05 g was obtained for the pga.
      
A representative value for the spacing of stalks in a small section of model wheat field was calculated by referring to published data on momentum absorption in a variety of real and model canopies.
      
更多          


Pinus koraiensis, Larix gmelini and Larix olgensis are the species of the most important timber in northeast of China. The sample trees of the three softwoods for density and maximum crushing strength test are collected from the various sample plots through out the range of their natural distribution. Some of them had been collected and tested in the fifties, and some sample trees were complemented and tested late. The experimental results of wood are shown in this paper to study the variations in density and...

Pinus koraiensis, Larix gmelini and Larix olgensis are the species of the most important timber in northeast of China. The sample trees of the three softwoods for density and maximum crushing strength test are collected from the various sample plots through out the range of their natural distribution. Some of them had been collected and tested in the fifties, and some sample trees were complemented and tested late. The experimental results of wood are shown in this paper to study the variations in density and strength that may occur not only among the different localities but also among trees within a locality and within a tree.The variations in density and strength of each kind of wood are clearly shown in this research, and thus a reliable representative value (species mean and total variance of wood density and strength.) could be determinated respectively. In addition, the lumber stress grading and grade stresses or characteristic value are derived by different methods in this paper for the structural timber.

本文研究了东北红松、落叶松和黄花落叶松的木材密度和顺纹抗压强度的变异。供试验用的试材,是按照这些树种的分布,选择了各种有代表性的地区采集而来。试验数据采用方差分析方法,分别树种比较不同地区间的材性,以及在同一地区内的树株间和一株树内部木材性质的变异。研究结果清楚地表明了每种木材性质变异的特点。据此可以确定该种木材的密度和顺纹抗压强度的代表值,即树种平均值及标准差。本文并讨论了这三种木材用于木结构承重构件的应力分级方法,和木材设计应力不同表达方式及推导。

Based on the measured values of the daily intake of ~(232)Th from diets and inhalation,the con-tent of ~(232)Th in bones of the public adults in Beijing area,and the models recommended in ICRP 30,thefraction of ingested ~(232)Th into body fluid through gastrointestinal tract,∫_1,of the public adults in Bei-jing area is estimated.The results show that 0.005 is the adequate representative value of ∫_1 for thepublic adults,which is 25 times greater than the value recommended by ICRP 30(0.0002).The I-CRP...

Based on the measured values of the daily intake of ~(232)Th from diets and inhalation,the con-tent of ~(232)Th in bones of the public adults in Beijing area,and the models recommended in ICRP 30,thefraction of ingested ~(232)Th into body fluid through gastrointestinal tract,∫_1,of the public adults in Bei-jing area is estimated.The results show that 0.005 is the adequate representative value of ∫_1 for thepublic adults,which is 25 times greater than the value recommended by ICRP 30(0.0002).The I-CRP value is not applicable to the general public.However,it may be helpful to understand the situa-ton of a population.The ∫_1 value given by this paper,derived from measured data,may be moresuitable for the public.

从北京地区公众成年人~(232)Th 的膳食日食入量,空气日吸入量,以及骨中~(232)Th 的沉积量出发,利用 ICRP 30号报告中参考人的代谢参数和内照射的库室模型,估算了北京地区公众成年人膳食摄入~(232)Th 后经胃肠道向体液转移份额 f_1值。结果表明,对于公众中成年人0.005是 f_1值的合适代表值,是 ICRP 30号报告推荐值 f_1=0.0002的25倍。虽然 ICRP 推荐值并不用于公众,但可以对群体有所了解;而北京地区从实测数据资料出发导出的 f_1值可能是更适于公众的。

he N value (number of blows) of penetration tests is used in determining the bearing capacity of foundations. But the dispersion of N value is often too great even in the same stratum. Therefore it is very important to find out a definite and representative value for N.

我国89年颁布的“地基基础设计规范”GBJ7—89(后面简称89规范)规定按标贯击数N(即N63.5)或按轻便触探击数N10可确定地基承载力。用标贯和用动力触探选定土层力学特性确有优点,比较简便,信息量多,对于不均匀性较明显的土质材料,现场触探方法值得大力推广应用。用触探方法遇到的最大的问题就是同一层土的触探击数分散性大。因此,从众多数据中如何选取一个有代表性的确定值,其选取方法十分重要。当按规范从N或N10。确定承载力时,特别当确定的承载力略低于设计要求承载力时,这个问题的重要性显得尤为突出。

 
<< 更多相关文摘    
图标索引 相关查询

 


 
CNKI小工具
在英文学术搜索中查有关representative value的内容
在知识搜索中查有关representative value的内容
在数字搜索中查有关representative value的内容
在概念知识元中查有关representative value的内容
在学术趋势中查有关representative value的内容
 
 

CNKI主页设CNKI翻译助手为主页 | 收藏CNKI翻译助手 | 广告服务 | 英文学术搜索
版权图标  2008 CNKI-中国知网
京ICP证040431号 互联网出版许可证 新出网证(京)字008号
北京市公安局海淀分局 备案号:110 1081725
版权图标 2008中国知网(cnki) 中国学术期刊(光盘版)电子杂志社