The results of the experiment show that CO poisoning effect, nitrogen diluting effect, CO 2 diluting effect and the reaction balance between CO 2 and CO are the main factors for decreasing cell performance.
As a result, high concentrations of the catalyst and monomer were applied: [Ti]= 5X10-3 mol/L, MAO/Ti=10 mol ratio, the temperature of polymerization= 20癈, time=64hours.
4)There is a threshold value in the flow rate of nitrogen. When the flow rate ratio of N2/Ar is no less than 1:1, the (Ti,Al)N films can not be produced because of the decreasing pressure of argon and target poison.
Ce and Bi can not be poisoned by Cr and Mn atoms,because a dystectic compound CeBi is formed in peritectic reaction and this compound can be heterogeneous nucleator for Al matrix. When the atom ratio of Ce and Bi is 3∶2,the refining effect is best.
The high activity of catalysts based of nanodisperse Pt-P system and their tolerance to the poisoning effect of methanol are demonstrated for the working potentials of cathodes in methanol-air fuel cells.
Liquid phases in the hydration of C_3S in pure water and solutions of various chemical admixtures were studied. It is shown that the early hydration of C_3S in pure water can be divided into four periods, the second of which corresponds to the so-called induction period and during that period C_3S has a constant dissolution rate.The chemical admixtures do not change the nature of C_3S hydration, but rather, shorten the duration of its induction period. The effect of a chemical admixture on C_3S hydration ra...
Hydrogenation was carried out in a "dead-end" type of batch reactor for Chinese rapeseed oil high in erucic acid and sulfur. The effcts of the sulfur compounds (RS: 5.3ppm-29.7ppm) to the rate of reaction and selectivity for hydrogenation under selective conditions (190℃ and 1.5kgf/cm2)and nonse-lective conditions (160℃ and 6.0kgf/cm2) were studied in this paper. When the level of sulfur compounds in oil increased, there was a decrease in reaction rate under above conditions and increase in selectivity "S2,...
The mechanizms of dispersant FDN, naphthaline sulfonate-formaldehyde condcnsates, for oil well cement are not clear enough until recently. In this work the effects of FDN on the hydration of oil well cement G are investigated by measuring electrical conductance and pH of liquid phase of the slurry. It is shown that the major factor in dispersing the cement particles can be attributed to the rise in Zeta-potential of the slurry with FDN. A dose of 0.8%(BWOC)leads to the maximum value of Zeta-potential, when ...