助手标题  
全文文献 工具书 数字 学术定义 翻译助手 学术趋势 更多
查询帮助
意见反馈
   temperature and adiabatic 的翻译结果: 查询用时:0.192秒
图标索引 在分类学科中查询
所有学科
更多类别查询

图标索引 历史查询
 

temperature and adiabatic
相关语句
  低温绝热
     Crust Bursting Accident Analysis for a Stationary Lower Temperature and Adiabatic Liquid Vessel during the Manufacture
     固定式低温绝热液体贮槽制造过程中外壳爆裂事故分析
短句来源
     Bursting accident analysis for a stationary lower temperature and adiabatic liquid Vessel during the manufacture
     一台固定式低温绝热液体贮槽制造过程爆裂事故分析
     When conducted the laminated pneumatic test for a stationary lower temperature and adiabatic liquid vessel,buckling deformation occured in inside shell and bursting in outside shell. Through the analysis, it proves that the formed size and weld residual stress of inside shell must be strictly controlled during the manufacture for this kind of vessel, and the monitoring of process program to laminated pneumatic test and vacuumizing leak check should be strengthened.
     通过一台固定式低温绝热液体贮槽夹层气压试验时内壳发生失稳变形 ,导致外壳爆裂的事故原因分析 ,证明此类容器在制造过程中应严格控制内壳的成形尺寸和焊缝残余应力 ,并加强对夹层气压试验、抽真空检漏的工艺程序监控
短句来源
     When conduct the laminated pneumatic test for a stationary lower temperature and adiabatic liquid vessel, there occur buckling deformation in inside shell and bursting in outside shell. Through the analysis, it proves that we'11 strictly control formed size and weld residual stress of inside shell during the manufacture for this kind of vessel, and strengthen the monitoring of process program to laminated pneumatic test and vacuumizing leak check.
     通过一台固定式低温绝热液体贮槽夹层气压试验时内壳发生失稳变形,导致外壳爆裂的事故原因分析,证明此类容器在制造过程应严格控制内壳的成形尺寸和焊缝残余应力,并加强对夹层气压试验、抽真空检漏的工艺程序监控。
  “temperature and adiabatic”译为未确定词的双语例句
     Most scholars had done the numerical calculation of heat and mass transfer in dehumidifier under constant temperature and adiabatic boundary conditions, which are two ideal boundary conditions.
     大多数学者在对除湿过程进行传热传质的计算中采用的除湿器壁面边界条件都是理想的恒壁温或是绝热壁面的情况,这与除湿过程实际工况不符。
短句来源
     The effects of Al_2O_3 and Cr_2O_3 dilutor on initial reaction temperature and adiabatic temperature were investigated by thermodynamic calculation.
     通过热力学计算与分析,探讨了Al2O3和Cr2O3稀释剂与反应起始温度、绝热温度的关系。
短句来源
     Amendments on the Traditional Exposition of Wet-Bulb Temperature and Adiabatic Saturation Temperature of Drying Gas
     干燥介质湿球温度与绝热饱和温度——经典论述的修正与补充
短句来源
     The relationships among the preheat temperature and adiabatic temperature are definite through the calculation of adiabatic temperature under ideal state.
     通过对理想状态下反应绝热温度的计算,明确了体系的预热温度与绝热温度的关系。
短句来源
     Some amendments on the traditional exposition of wet-bulb temperature and adiabatic saturation temperature of drying gas have been made in this paper,which makes them both more scientific and rigorous.
     本文修正与补充了干燥介质湿球温度与绝热饱和温度的经典定义及论述,使其更加科学与严谨。
短句来源
更多       
  相似匹配句对
     The adiabatic temperature was calculated.
     通过计算CaO B2O3 Mg反应体系的绝热温度,确定了该体系自蔓延反应进行的可行性。
短句来源
     T is temperature, ℃.
     T为温度,℃。
短句来源
     The temperature for R.
     越冬卵孵化起点温度低于4℃。
短句来源
     Experiment and Analysis of Concrete Adiabatic Temperature Rise
     混凝土绝热温升的实验测试与分析
短句来源
     ADIABATIC FLAME TEMPERATURE OF HYDROCARBON,COAL AND HYDROGEN
     烃、煤、氢绝热火焰温度
短句来源
查询“temperature and adiabatic”译词为用户自定义的双语例句

    我想查看译文中含有:的双语例句
例句
为了更好的帮助您理解掌握查询词或其译词在地道英语中的实际用法,我们为您准备了出自英文原文的大量英语例句,供您参考。
  temperature and adiabatic
It is shown that the temperature and adiabatic index depend on the values of both entropy and lepton fraction.
      


Some amendments on the traditional exposition of wet-bulb temperature and adiabatic saturation temperature of drying gas have been made in this paper,which makes them both more scientific and rigorous.

本文修正与补充了干燥介质湿球温度与绝热饱和温度的经典定义及论述,使其更加科学与严谨。

Because of the great temperature gradient near the cooling pipe in mass concrete,a very fine mesh has to be adopted in finite element computation to consider the effect of pipe cooling.In the equivalent equation of heat conduction established in Ref.[3]of the paper,the influence of initial temperature and adiabatic temperature rise were considered but the influence of external temperature had not been considered.The author proposed a method of computation considering the influence of external...

Because of the great temperature gradient near the cooling pipe in mass concrete,a very fine mesh has to be adopted in finite element computation to consider the effect of pipe cooling.In the equivalent equation of heat conduction established in Ref.[3]of the paper,the influence of initial temperature and adiabatic temperature rise were considered but the influence of external temperature had not been considered.The author proposed a method of computation considering the influence of external temperature,so that the equivalent equation of heat conduction for pipe cooling in mass concrete would be more perfect.

水管冷却是大体积混凝土温度控制的重要措施,由于水管附近温度梯度很大,直接用有限元法计算水管冷却效果,必须采用密集网格,有较大困难,目前广泛采用笔者在文献[3]中提出的等效热传导方程,该方程已考虑了混凝土的初始温度和绝热温升,但没有考虑外界温度的影响,本文给出在水管冷却等效热传导方程中考虑外界温度影响的计算方法,使等效热传导方程趋于完善。

When conducted the laminated pneumatic test for a stationary lower temperature and adiabatic liquid vessel,buckling deformation occured in inside shell and bursting in outside shell. Through the analysis, it proves that the formed size and weld residual stress of inside shell must be strictly controlled during the manufacture for this kind of vessel, and the monitoring of process program to laminated pneumatic test and vacuumizing leak check should be strengthened.

通过一台固定式低温绝热液体贮槽夹层气压试验时内壳发生失稳变形 ,导致外壳爆裂的事故原因分析 ,证明此类容器在制造过程中应严格控制内壳的成形尺寸和焊缝残余应力 ,并加强对夹层气压试验、抽真空检漏的工艺程序监控

 
<< 更多相关文摘    
图标索引 相关查询

 


 
CNKI小工具
在英文学术搜索中查有关temperature and adiabatic的内容
在知识搜索中查有关temperature and adiabatic的内容
在数字搜索中查有关temperature and adiabatic的内容
在概念知识元中查有关temperature and adiabatic的内容
在学术趋势中查有关temperature and adiabatic的内容
 
 

CNKI主页设CNKI翻译助手为主页 | 收藏CNKI翻译助手 | 广告服务 | 英文学术搜索
版权图标  2008 CNKI-中国知网
京ICP证040431号 互联网出版许可证 新出网证(京)字008号
北京市公安局海淀分局 备案号:110 1081725
版权图标 2008中国知网(cnki) 中国学术期刊(光盘版)电子杂志社