助手标题  
全文文献 工具书 数字 学术定义 翻译助手 学术趋势 更多
查询帮助
意见反馈
   hot torsion 的翻译结果: 查询用时:0.008秒
图标索引 在分类学科中查询
所有学科
金属学及金属工艺
机械工业
更多类别查询

图标索引 历史查询
 

hot torsion
相关语句
  热扭转
     AbstractBy means of hot torsion test and quantitative metallographic analysis,the mechanical behavior and dynamical structural changes under hot deformation conditions were investigated for l8Mn-18cr-0. 5N austenite steel.
     用热扭转试验及定量金相法研究了18Mn-18Cr-0.5N钢热变形条件下的力学行为和动态组织变化。
短句来源
     Effects of deformation temperature and speed on hot ductility of Ni36CrTiAl alloy was investigated by means of hot torsion test.
     用热扭转实验方法,研究了变形温度和速度对Ni36CrTiAl合金热塑性的影响。
短句来源
     The static recrystallization behavior of 18Mn-18Cr-0.5N austenitic steal was investigated by means of hot torsion tests and quantitative metallographic analysis.
     用热扭转试验及定量金相研究了18Mn-18Cr-0.5N奥氏体钢静态再结晶行为。
短句来源
     The applications of artificial neural networks in prediction of ambient temperature mechanical properties of strip and spheroidal graphite cast iron, hardenability of alloy steel, hot strength of high speed steel and heat resistant - stainless steel and hot torsion properties of microalloying steel are summarily presented in this article.
     概要叙述了人工神经网络在预测板材、球墨铸铁的常温力学性能 ,合金结构钢的淬透性 ,高速钢、不锈耐热钢的热强度以及微合金钢热扭转性能方面的应用
短句来源
     In this papar the ductility of 16Cr5NiMo stainless steel under hot conditions Was investigated by use of hot torsion and transmission electrical microscopy.
     本文利用热扭转、透射电镜试验方法测定了16Cr5NiMo钢的高温延性,发现随着铁素体相的增加该钢的高温延性下降。
短句来源
更多       
  “hot torsion”译为未确定词的双语例句
     RESEARCH ON CONTINUOUS DYNAMIC RECRYSTALLIZATION IN HOT TORSION OF Al-Cu-Mg-Zn-Cr ALLOY
     Al-Cu-Mg-Zn-Cr合金热扭转变形中连续动态再结晶机理
短句来源
     Dynamic recrystallization during hot torsion of Al 2Mg alloy
     Al-2Mg合金的动态再结晶
短句来源
     Specimens of single phase Al 2Mg alloy have been deformed by hot torsion at 300~530 ℃ and strain rates of 0.069~1.587 s -1 to true strain of 5.5 followed by water quenched immediately.
     单相Al2 Mg 合金在300 ~530 ℃ 以0 .069 ~1 .587s- 1 形变速率扭转到真应变5 .5 , 随后立即水冷。
短句来源
     An Exploration of the Feasibility on Evaluating Performances of Tool Steels in Terms of Deformation Work by the Method of Hot Torsion
     用热扭实验法评价工具钢使用性能的研究
短句来源
  相似匹配句对
     HOT
     热报!
短句来源
     the means of hot plate and torsion were used painkilling test.
     采用热板法和扭体法进行镇痛试验。
短句来源
     HOT NEWS
     热点新闻
短句来源
     Torsion of the epididymis
     附睾扭转
短句来源
     The torsion balance
     谈扭秤
短句来源
查询“hot torsion”译词为用户自定义的双语例句

    我想查看译文中含有:的双语例句
例句
为了更好的帮助您理解掌握查询词或其译词在地道英语中的实际用法,我们为您准备了出自英文原文的大量英语例句,供您参考。
  hot torsion
The hot fracture of Inconel 600 has been studied over the temperature range from 800° to 2000°F using a hot torsion tester that is capable of superimposing either axial tensile or compressive stresses on the torsional shearing stresses.
      
Finally, the entire hot strip rolling and controlled cooling process have been simulated by hot torsion tests, and the optimum coiling temperatures for the formation of TRIP microstructures have been determined.
      
The current study on a Ni-30Fe austenitic model alloy revealed that laminar microband structures were the key intragranular defects in the austenite for nucleation of ferrite during the hot torsion test.
      
A C-Mn-Nb-Ti steel was deformed by hot torsion to study ultrafine ferrite formation through dynamic strain-induced transformation (DSIT) in conjunction with air cooling.
      
Hot torsion testing comprising multiple twist reversals was used to establish the effect of strain-path changes on concurrent dynamic globularization and cavitation of Ti-6Al-4V with a colony-alpha starting microstructure.
      
更多          


The effect of trace S on the hot plasticity of high speed steels has been examined. It was shown that the S content in W14Cr4VMn steel decreased from 0.01% down to a possible lowest limit of 0.002% the number of cycles of the hot torsion test increases about 20% under 950-1150℃. This indicates that the hot plasticity of the high speed steels may be deteriorated even if a trace S contained. AES was observed that the S segregation occurs along the austenite grain boundaries. The reason of the S segregation...

The effect of trace S on the hot plasticity of high speed steels has been examined. It was shown that the S content in W14Cr4VMn steel decreased from 0.01% down to a possible lowest limit of 0.002% the number of cycles of the hot torsion test increases about 20% under 950-1150℃. This indicates that the hot plasticity of the high speed steels may be deteriorated even if a trace S contained. AES was observed that the S segregation occurs along the austenite grain boundaries. The reason of the S segregation and its deterioration on the hot plasticity of the steels has also been discussed.

本文研究了微量硫对W14Cr4VMn高速钢热塑性的影响:热扭转实验证实微最硫仍能危害钢的热塑性;Auger能谱仪实验发现,即使钢中的硫含量降低到0.002wt-%时,硫仍偏聚在晶界上。本文讨论了硫偏聚和微量硫危害热塑性的原因。

The microstructural changes during hot working of a retaining ring steel have been studied by hot torsion tests.The stress-strain curves,dynamic recrystallization during hot working and static recrystallization hereafter were observed,and the relationships between these parameters have been established.A new technological method for refining the grain size of the steel was suggested.

本文利用热扭转试验方法,研究了50Mn18Cr4WN 护环钢热变形金属学问题。主要内容有护环钢在热变形条件下的应力一应变曲线,热变形过程中产生的动态再结晶及在变形温度下保持时产生的静态再结晶行为。建立了变形参量和力学行为与组织变化的对应关系。提出了细化护环钢晶粒的新途径及可采用的工艺。

The hot torsion tests on low-carbon Mn-Nb steel were carried out of the es-tablishment of the constitutive equation of the power function and of the deter-mination of the relationship between flow stress of a steady state and hot ductility.An approach to the process of dynamic recrystallization was also made after con-sideration in the effect of strain accumulation.The influences of temperature,strain rate,Nb(CN)precipitation on the dynamic fractional softening have beenanalyzed.During dynamic recrystallization,the...

The hot torsion tests on low-carbon Mn-Nb steel were carried out of the es-tablishment of the constitutive equation of the power function and of the deter-mination of the relationship between flow stress of a steady state and hot ductility.An approach to the process of dynamic recrystallization was also made after con-sideration in the effect of strain accumulation.The influences of temperature,strain rate,Nb(CN)precipitation on the dynamic fractional softening have beenanalyzed.During dynamic recrystallization,the variation of activation energy orstress exponent reflects the precipitation of Nb(CN)to a certain extent.The effectof temperature and strain rate on the Nb(CN)precipitation may be quantitativelyillustrated by(?) which is defined as so-called precipitation exponent.Furthermore,the correlation among the strain rate sensitivity,temperature and shear strain hasalso been studied.

用扭转实验方法,对低碳锰铌钢进行了研究.建立了幂函数形式的本构方程.确定了稳态流变应力与热塑性之间的关系.考虑到累积应变效应,对动态再结晶过程进行了初步研究.分析了温度、应变率、Nb(CN)沉淀对动态软化百分数的影响.动态再结晶过程中,激活能和应力指数的变化,在一定程度上反映了Nb(CN)的沉淀.定义(?)/(?)为沉淀指数,用以定量地说明温度,应变率对Nb(CN)沉淀过程的影响.此外,还对应变率敏感系数与温度,剪切应变之间的关系进行了研究.

 
<< 更多相关文摘    
图标索引 相关查询

 


 
CNKI小工具
在英文学术搜索中查有关hot torsion的内容
在知识搜索中查有关hot torsion的内容
在数字搜索中查有关hot torsion的内容
在概念知识元中查有关hot torsion的内容
在学术趋势中查有关hot torsion的内容
 
 

CNKI主页设CNKI翻译助手为主页 | 收藏CNKI翻译助手 | 广告服务 | 英文学术搜索
版权图标  2008 CNKI-中国知网
京ICP证040431号 互联网出版许可证 新出网证(京)字008号
北京市公安局海淀分局 备案号:110 1081725
版权图标 2008中国知网(cnki) 中国学术期刊(光盘版)电子杂志社