The statistical analysis results show that the prognostic results comparing with the observed data, about 93% of the difference of wind direction within the 1.5 of azimuth angle (<33.75 degree), 80% of the wind speed radios are within a factor of 1.5 in the first two hours.
On this basis, the system can predicate the mechanical properties and microstructure in HAZ (Heat Affected Zone),the geometric shape of weld seam,and the lateral deformation and angular deformation of welded joint.
For the purposes of improving the detect precision of weight density and size distribution parameters of coal mine dust, based on the mathematical model of angular distribution coal mine dust diffraction and its feature, the algorithm suitable for single-chip computer is put forward.
Through experimentation,the contact angles with pure water of 9 coal seam in Jinggezhuang Mining and 9 coal seam in Tangshan Mining were measured respectively. Then according to the relation of the concentrations of four surfactants and the surface tensions,get the lowest concentrations which make the contact angles with surfactants were zero.
An improved visualization device made of polymethyl methacrylate (PMMA) was used to study the 3D flow profile inside conical columns of a 10° opening angle packed with C18 phase.
The Brill transition of even-even polyamide 618 was investigated using differential scanning calorimetry (DSC), temperature-dependent wide angle X-ray diffraction (WAXD) and Fourier transform infrared (FTIR).
The transmittance passing through the cell between crossed polarizers changed periodically with a regular 90° separation of the rotational angle.
The pretilt angle of the cell was found to be 2.8°.
With the increase of DHPDMS content, the water contact angle increased while the surface tension decreased.
The bipartite Brill-Gordan locus and angular momentum
The results showed that errors of the radium of the hinges and angular differences of the centerline of the hinges were dominant factors resulting in output errors.
Under this control, the steady value of the lateral acceleration is obviously diminished and the yaw angular velocity changes little under any vehicle velocity.
By employing resampling sub-datasets from the original dataset in different directions, we could overcome the difficulty in the direct use of current non-angular methods of pattern analysis.
Three-dimensional numerical analysis and experimental investigation of grain refinement in multi-pass equal channel angular pres
By producing a L2 convergent Neumann series, we prove the invertibility of the elastostatics and hydrostatics boundary layer potentials on arbitrary Lipschitz domains with small Lipschitz character and 3D polyhedra with large dihedral angles.
The structure of the pigment was characterized by X-ray diffraction (XRD), and its optically variable effect was investigated by X-Rite MA86 II five angles spectrophotometer.
In NQGA, a novel approach for updating the rotation angles of quantum logic gates and a strategy for enhancing search capability and avoiding premature convergence are adopted.
The 2D/3D scattering center models can be reconstructed based on the wideband measurements at different viewing angles.
Research results show that initiation and propagation laws are the same with interior symmetric wedge angles of 30°-120°, while the laws are different with interior symmetric wedge angles equal to or more than ≥150°.
This wavelet basis is obtained from three wavelet generators by scaling, translation and rotation, and the wavelets are supported either by one corner triangle or a pair of adjacent triangles in the triangulation of level k - 1.
Localization of a Corner-Point Gibbs Phenomenon for Fourier Series in Two Dimensions
In this note we prove that the corner cutting procedure preserves continuity properties, i.e., a sequence of polygons obtained in this way belongs to the Lipschitz class of the same constant and exponent.
Using two micro-motors, a novel omni-direction miniature wheeled robot is designed on the basis of the bi-corner driving principle.
Coal is relatively thick in the northern part and the southeastern corner.