助手标题  
全文文献 工具书 数字 学术定义 翻译助手 学术趋势 更多
查询帮助
意见反馈
   一个0 的翻译结果: 查询用时:0.094秒
图标索引 在分类学科中查询
所有学科
无线电电子学
更多类别查询

图标索引 历史查询
 

一个
相关语句
  a 0
     Fabricated with 2 μm CBIP technology,the device has the advantages of high accuracy(±0.8%),low-dropout voltage(0.12 V,100 mA),and low temperature coefficient(-55-125 ℃,10 mV),and it requires only a 0.47 μF ceramic capacitor for stable operation,thus simplifying the peripheral design of the system.
     该电路采用2μm CBIP工艺技术制作,具有输出精度高(±0.8%)、输入输出压差低(0.20 V,100 mA)、温度系数低(-55~125℃,变化10 mV)、输出仅接一个0.47μF瓷介电容,即可实现稳定工作等特点,简化了外围设计。
短句来源
     However, because of various noise source and inter symbol interference (ISI), one 2 bit reversing error event (2 BREE) between the two digits of a 1 and a 0 is easy to occur in a detected codeword compared with an original modulation codeword, which causes about a 3 bit error on the average in a 6 bit dataword for the 6∶8 natural binary order mapping constant weight modulation code (NCWMC).
     然而,各种各样的噪声源和符号间串扰极易使检测到的一个等重码字与原等重码字相比发生一个0与1之间的2 码元交换错误事件(2 BREE). 对于 6∶8 二进制顺序映射等重调制码(NCWMC)而言,由此导致在一个6比特数据字中平均产生约3比特误码.
短句来源
     A 0.931 ha constructed wetland for mine drainage treatment was installed in the Swatara Creek Watershed in Schuylkill County, Pennsylvania.
     在宾西法尼亚州的Schuylkil县,一个0.931ha的人工湿地建造在 Swatara Creek流域。
     While LiBr mass factor difference in the solution storage tank between energy charging start and end is 0.1, the energy transformation and storage system in which there are a 0.6 m3 solution storage tank and a 0.17 m3 water storage tank can store about 109 kWh refrigerating potential and shift about 23.3 kWh electric load in off-peak time.
     当充能始、终时刻溶液储罐内溴化锂质量分数差为0.11时,蓄能系统中仅用了一个0.6m~3的溶液储罐和一个0.17m~3的水储罐可储存109KWh的制冷潜能,转移电网负荷23.3KWh,蓄能系统运行的COP值可达到4.67。
短句来源
     A branch and bound algorithm is developed to get the solution of the model which is a 0/1 integer linear programming problem.
     该模式是一个0/1整数线性规划问题,并给出了分枝定界求解算法;
短句来源
更多       
  “一个0”译为未确定词的双语例句
     A 0-1 Finite Space
     一个0—1有限空间
短句来源
     Noise optimization is taken on by software and a 5.8 GHz all-on-chip Low Noise Amplifier in 0.18 μm CMOS technology is presented.
     利用软件对电路进行噪声优化,设计出了一个0.18μm CMOS工艺的5.8GHz全集成低噪声放大器.
短句来源
     Finally,the verification is done with a commercial FET device of 0.3μm×280μm.
     以一个0.3μm×280μm商用器件的一组寄生参数为基础,对该方法进行了验证.
短句来源
     At the concentration of 10 μg/l ,five time-effect groups(12,24,48,72 and 96 h) and a zero time control group were set up.
     在 10 μg/L暴露条件下 ,设 12、2 4、48、72和 96h五个时间效应组 ,另设一个 0时间对照组。
短句来源
     Results A simple scoring system was produced,assigning linear scores(0/1/2) to the covariates (TNM,α-fetoprotein,and Child-Pugh).
     结果最后模型由TNM、Ch ild-Pugh和AFP 3个协变量构成,分配线性记分(0/1/2)给每个协变量产生一个0~5分的联合分期记分。
短句来源
更多       
  相似匹配句对
     0,?
     0,?
短句来源
     0?
     0?
短句来源
     A Characterization of l_p and C_0 Turdebek N Bekjan ;Nurbahet Xamaly
     l_p和C_0一个特性
短句来源
     A 0-1 Finite Space
     一个0—1有限空间
短句来源
     One Evening
     一个夜晚
短句来源
查询“一个0”译词为用户自定义的双语例句

    我想查看译文中含有:的双语例句
例句
为了更好的帮助您理解掌握查询词或其译词在地道英语中的实际用法,我们为您准备了出自英文原文的大量英语例句,供您参考。
  a 0
The cell constants are calculated at a = 0.2652 nm and c = 0.4334 nm.
      
We prove the uniqueness of weak solutions of the time-dependent 3-D Ginzburg-Landau model for superconductivity with (Ψ0, A0) ∈ L2(Ω) initial data under the hypothesis that (Ψ, A) ∈ C([0, T]; L3(Ω)) using the Lorentz gauge.
      
peregrina, Hex-1-a (0.800-1.000) and Ldh-b (0.487-0.750) in A.
      
All these constituents were classified into dissolved and suspended groups by using a 0.45-μm membrane filter, and the concentration of each constituent in each group was analyzed.
      
The kinetics of coupled peroxidation of 3,3",5,5"-tetramethylbenzidine (TMB) and 1-amino-2-naphtol-4-sulfonic acid (ANSA) or its polydisulfide (poly(ADSNSA)) was studied in a 0.01 M phosphate buffer (pH 6.4) at 20°C.
      
更多          


In ordinary sampled-data control systems the system response to a step input can reach its equilibrium state only within n or more sampling intervals (n is the order of the controlled plant). In this paper multiple-impulses are used, instead of ordinary simple impulses, to speed up the system response. In such sampled data systems the system response to step input can reach its equilibrium state within less than n, even one, sam-pling intervals. Methods of design of such kind of sampled-data systems and their...

In ordinary sampled-data control systems the system response to a step input can reach its equilibrium state only within n or more sampling intervals (n is the order of the controlled plant). In this paper multiple-impulses are used, instead of ordinary simple impulses, to speed up the system response. In such sampled data systems the system response to step input can reach its equilibrium state within less than n, even one, sam-pling intervals. Methods of design of such kind of sampled-data systems and their com-ponents are discussed. In the last part of the paper methods of compensating sampled data systems with dead time elements is also considered.

在通常的脉冲控制系统中,当输入信号是阶跃函数时,系统的过渡过程至少在n个采样周期内才能完全结束(n是控制对象的阶数).文中考虑了采用宽度不等的多拍脉冲代替通常的单拍脉冲以加快系统的过渡过程.在采用多拍脉冲以后,系统的过渡过程可以在少于n个采样周期内,甚至在一个采样周期内完全结束.文中叙述了这种脉冲系统的综合方法,也讨论了系统中有关组成部分——脉冲组成器和校正装置——的构成方案及其参数的计算方法.最后并考虑了由于时滞引起的对系统动态特性有害影响的补偿问题.文中举有例题,对文中各节内容作必要的说明.

In this paper the logical structure of contactless telemechanical system for distributed objects is discussed. A simple method of variable system structure for transmitting and receiving telemechanical information is adopted. The idea is that the information oc-curred in every controlled point (station) and the information of some of those objects,which frequently change their states, are transmitted continually and cyclically, while for other objects their information is transmitted only after any change in...

In this paper the logical structure of contactless telemechanical system for distributed objects is discussed. A simple method of variable system structure for transmitting and receiving telemechanical information is adopted. The idea is that the information oc-curred in every controlled point (station) and the information of some of those objects,which frequently change their states, are transmitted continually and cyclically, while for other objects their information is transmitted only after any change in their states. Thus,the speed of operation will be increased, and also the error probability of system syn-chronization will be decreased. For the realization of the variable logical system struc-ture, several blocks are used repetitively. For example, two commutators and one sim-ple logical unit are used to construct a simple automatic sequential encoder, and at the same time, the two commutators are used also to operate as a matrix commutator for receiving telesignalling information etc. Therefore the system is comparatively simplified and attains a higher degree of "minimization".

本文研究了无触点集中-分散目标远动系统的逻辑结构.文中提出了采用简单的系统变结构来发送和接收信息的逻辑结构方式.对被控制点及一部分比较重要或变化比较频繁的被控制目标的信息,保留了循环传送,而对大部分变化比较慢的被控制目标则采用目标有变化时才传送信号的方式,这样就提高了系统的平均动作速度,同时也减小系统的失步概率.文中采用环节的复合利用及简化的逻辑单元线路来实现这种系统的逻辑结构.例如用两个分配器和一个简单的逻辑单元“和”线路组成了很简化的选点自动程序编码器,同时这两个分配器又复合利用兼组成目标信号接收矩阵式分配器等,因而可以使得这种系统同时又具有较高的极简化度.

Analysis of the low frequency response of automatic balancing D-C amplifier with mechanical chopper is illustrated by a typical circuit in this paper. The analysis of dynamic response of the modulation and the demodulation circuits and the auxiliary carrier wave amplifier have been considered more in details. The analysis is based on solving difference equations since the intrinsic working process behaved by the M-D M circuits using mechanical chopper is more accurately described by difference equation other...

Analysis of the low frequency response of automatic balancing D-C amplifier with mechanical chopper is illustrated by a typical circuit in this paper. The analysis of dynamic response of the modulation and the demodulation circuits and the auxiliary carrier wave amplifier have been considered more in details. The analysis is based on solving difference equations since the intrinsic working process behaved by the M-D M circuits using mechanical chopper is more accurately described by difference equation other than by differential equations.

本文結合一个典型线路对带有机械振子的自动稳零直流放大器的低頻特性,进行了分析,并且着重分析了調制解調輔助放大器对緩变信号的频率响应。所用方法是差分方程求解法,因为用差分方程来描述具有机械振子的調制解調线路的固有工作过程,要比用相同的初始条件的微分方程来描述更为准确。文中推导出調制及解調綫路的調制系数k_M、解調系数k_(ДM)以及它們的传递函数。此外,对放大調制波的阻容耦合放大器也进行了分析。分析結果說明,如果放大器耦合迴路的参数选择得合理吋,則此放大器对緩变信号的調制波可作为理想放大器来处理。文中所得結果可作为設計該类型放大器时选择参数的参考。此外,本文对于采用自动稳零直流放大器作运算放大器时可能产生的持續低頻自激振蕩問題,也进行了討論。

 
<< 更多相关文摘    
图标索引 相关查询

 


 
CNKI小工具
在英文学术搜索中查有关一个0的内容
在知识搜索中查有关一个0的内容
在数字搜索中查有关一个0的内容
在概念知识元中查有关一个0的内容
在学术趋势中查有关一个0的内容
 
 

CNKI主页设CNKI翻译助手为主页 | 收藏CNKI翻译助手 | 广告服务 | 英文学术搜索
版权图标  2008 CNKI-中国知网
京ICP证040431号 互联网出版许可证 新出网证(京)字008号
北京市公安局海淀分局 备案号:110 1081725
版权图标 2008中国知网(cnki) 中国学术期刊(光盘版)电子杂志社