Effects of injection retard on 13-mode weighted NO_x and particulates emissions and particulate composition were studied and results showed that when injection timing was retarded from 21° to 18° CA BTDC, 13-mode weighted brake specific emission of NO_x was decreased by 27.5% while particulate mass emission was increased by 9.1% with higher content of carbonaceous matter.
PM2.5 samples were collected at five sites of Beijing during summers and winters of 2001 and 2002 and spring of 2003. It has been found that carbonaceous aerosol is one of the major compositions of PM2.5. OC and EC concentrations and their mass percentages in PM2.5 were higher in winter than in summer, which could be attributed to the coal consumption of heating period.
The carbonaceous lead zinc ore in Inner Mongolia is very large in reserve,but it contains a high level carbon,which interferes with the selective flotation of these ores,making the selective process target very low and economic benefit poor. In recent years,the decarbonizing technology has been greatly improved that provides enough reliable information to exploit these ores
And some problems such as the oxidizing rate and the fully burning of carbon,the composition and shaping of carbonic reheating agent have been analyzed.
Its photosynthetic dependence on external dissolved inorganic carbon was higher than that of the wild type cells, but its carbonic anhydrase activity was comparatively low.
A sensitive complex absorptive wave of Ca-ARS was obtained by using differential pulse voltammetry when a mercury film glass carbon electrode was immersed in 0.1 mol L-1 KOH and 4.5×10-4 mol L-1 ARS solution.
Ionic liquid like 1-butyl-3-methyl-imidazolium tetrafluorobrate ([BMIM]BF4) has been used as solvent and electrolyte for the electropolymerization of aniline at glassy carbon electrode by cyclic voltammetry.
Moreover, the procedure of their manufacture, analogous to the manufacture of "shungizite" (an artificial carbonaceous-clayey material) from Lower Proterozoic clayey rocks of Karelia, is more economical than that for keramzit.
This work presents the quantitative estimation of Corg content in lithological rock types and morphostructural features of carbonaceous inclusions and sulfide mineralization.
In the presence of 0.1-0.2% carbolic acid, known to prevent flagellation, no plaques were formed.2.L-forms of both strains, as well as spheroplasts which had completed their development, were phage resistant.
Crushed nodule suspensions or soil suspensions were incubated briefly in 0.7% phenol (carbolic acid) just before application to a sucrose density gradient.
The respiratory activity of Rhodococcus rhodochrousM8 cells containing nitrile hydratase and amidase was studied in the presence of nitriles and amides of carbonic acids.
SBAM is a most potent inhibitor on ciliary epithelium carbonic anhydrase and is approximately 13 times more active against carbonic anhydrase isoform II than against isoform I.
The dielectrie constants of toluene, carbon bisulphide, normal pentane, normal hexane, ethyl ether and iso-amyl alcohol were measured by a capacity bridge using a specially constructed liquid condenser at both 30° and 75℃ (22.4℃ only for the last liquid), for frequencies of 600,1000 and 2000 cycles per sec. and under pressures from 1 up to 12,000 kg/cm2. For the first four liquids, the dielectric constant is practically independent of the frequencies
A spectrographic procedure for determining copper in concentrated iron ores has been worked out for routine analysis. The powder method is found to be satisfactory with a medium quartz spectrograph and an activated a. c. arc between carbon electrodes as light source. In order to minimize erratic burning of the sample, the electrodes are pre-burned for one minute and then loaded with a mixture of equal weight of the ore sample and carbon powder. The analysis pair of lines chosen are: Cu 2824.369- Fe 2824.67 ...
Creep under very small torsional stress has been investigated for 99.95% polycrystalline iron in the temperature range of 350°-525℃. The general features of the creep curves obtained are essentially the same as those previously reported for 99.991% aluminum. The creep is shown to be consisted of two parts, one occurring at lower temperatures or shorter times and the other at higher temperatures or longer times. The first part of the creep is limited in extent and is associated with the viscous behavior of g...